Garden

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

It could be your bearings and your spindle pockets, or spindles, have seized up,” says Oshel. If the blades are stuck, pump some grease into the fitting and carefully work the blades back and forth by hand until they move freely.
There is a safety switch at the end of the cutter engage lever which has gone faulty and needs replacing, overiding the switch by keeping it pressed in will allow the mower to be operational till replacement switch is fitted.
The possible causes of a lawn mower blade spinning but not cutting grass include a damaged or wrongly installed blade, a dull blade, or damaged lawnmower tires. Other possible reasons can be improper tire pressure, a clogged deck, or a broken mower belt.
There is a safety switch at the end of the cutter engage lever which has gone faulty and needs replacing, overiding the switch by keeping it pressed in will allow the mower to be operational till replacement switch is fitted.
The engine powers both the wheels and the blade, just like a walk-behind self-propelled mower. But instead of being directly connected to it by an axle, the blade on most riding mowers is powered by a belt connected to the engine.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

John deere stx 30 pto wont engage
ANSWER : Check your fuse or for a broken wire( or shorted)

Read Full Q/A … : Garden

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : Garden

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : Garden

Cannot remove mower blade pulley nut – John Deere 22HP VTwin 48" Riding Mower
ANSWER : I think its a left hand thread, you undo it clockwise (the “wrong” way)

Read Full Q/A … : Garden

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : Garden

Our john deere 400 is eating the belts for the front pto drive
ANSWER : Flat idler to left of belts is most likely seizing up during use.

Read Full Q/A … : Garden

What size – Length belt fits L110 – John Deere L100 Series
ANSWER : Model # GX20072 is for a 42 inch deck . It fits a variety of John deere mowers

Read Full Q/A … : Garden

Free belt diagram john deere freedom 42 – John Deere 42 in. EZ Trak Bagger
ANSWER :

Read Full Q/A … : Garden