Mighty Lite Lawn Trimmer
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The most common problem with a strimmer not starting is that there`s a problem with the fuel mix. Double check that you`ve used 40 parts fresh unleaded petrol to 1 part 2-stroke oil (40:1). Check the petrol you`ve used isn`t stale.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
over time the arrestor can become clogged with soot which may cause the trimmer engine to stall. you can try cleaning the arrestor with a wire brush. but you may need to replace it with a new.
If your trimmer engine idles, but stalls on throttle, check the following parts: the gasket, primer bulb, fuel filter, air filter, fuel vent, fuel line, and carburetor. The repair and symptom guide will help you better identify the part needed to be replaced and how.
If your 2-stroke brushcutter fails to start, the simplest explanation is that there is not enough fuel: in this case you simply need to top it up. A 2-stroke brushcutter engine runs on fuel/oil mixture, which you can buy ready prepared, such as EFCO-Mix Alkilate alkylated mixture in a 5 L can.
The average lifespan of a captive-reared grasscutter ranges from 7-9 years. They can live up to 12 years depending on health care given to the animals during their service lives.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die
By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.
Over time, the spark arrestor can become clogged with soot. If the spark arrestor is clogged, the engine may not start. To unclog the spark arrestor, remove it and clean it with a wire brush. You may also replace the spark arrestor.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
It won’t stay running. have cleaned the gas tank and it just had a tune up. runs fine then gets rough and quits. If I push the bulb it smooths out and runs fine for a couple of minutes and then begins hesitating again. Now today it ran for about 15 min. and now it won’t start. It wants to. runs for a couple of seconds 5-10 and then quits.
Remove the float bowl and empty the contents out clean and replace
My Husqvarna 128cd weedeater would run with choke on but not in the run position. Sometimes it would run in the run position but would not stay running. I had it running and then it cut off. I now cannot get it to crank at all. Any ideas
More than likely a fueling issue, wrong fuel air mix or air leak somewhere
Starts right up on choke. then run inrun position for a minute and have to go back to choke to keep it running ,then it runs fine for a couple of minutes and have to go back to choke and start all over again.
This happens with the cover off, so not the filter.
Seems to start easily run for a few minutes and then slow and stop–bulb remains full –gas is good–have tried half choke in case too lean–did not solve–also seems possibly related to the angle I hold it at–seems to cut out quicker if blower tube angled more downward.
Your filter may be hanging up in the tank. you also my be losing compression
I have a Toro 20332 that stopped running after 20 minutes and would not restart. Tried several days later and it would start for a few seconds and stop again. Took it to the Tor dealer twice last year when this happened and was told it was bad gas. Replaced gas can and used new gas still having the issue. The odds of 3 bad tanks of gas are pretty slim. Any thoughts?
Just take off your carb and give it a good cleaning. Be careful and watch how everything comes apart so you can put it back together with little or no trouble.
Will only start and run in choked position, when throttle applied chokes out. If started with out choke and throttle position in low speed will start and run for 10 sec then like it runs out of gas.
I have your solution guaranteed, I fixed mine yesturday remove H L screw plastic caps and on high 11 threads exposed and on the low side 8 threads exposed. removing the plastic caps allows u further adjusting these wear out or move soo just take them things off and you will be rolling
I have a husqvarna 323L string trimmer. I stored it after running the tank & carb dry for about two years. I fueled it, then started it, & it ran for a minute then died like I turned the switch off. Since it would not restart, I found the fuel filter had broken off the hardened fuel line & it sucked gummy crap out of the tank & into the carb. Failing at cleaning the carb, I finally put a new carb on it & replaced the pump, hoses & filter. It has ran good till this year. I winterized it with stabilizer & left it with a full tank over the winter. The gas in the tank was gone when I got ready to use it this year. I filled the tank with premix, checked for leaks, then started it. It would run fine for about half a tank, start idling poorly (lean) then cutoff & refuse to restart till I refilled the tank. I finally found the tank had cracks & was letting pressure out of the tank & apparently this was causing the carb to lose it’s ability to siphon gas out of the tank. So I replaced the tank which came with new hoses & a filter, which I properly installed to the carb. It cranked right up, but when it runs a half tank, the carb quits sucking gas out of the tank. When I pump to prime the carb, it moves the fuel into the carb, but the pump never gets hard like it does when I prime the carb when the motor is cold. I have to keep refilling the tank, prime, & then it starts & runs until the tank gets about half empty. The new fuel filter is down in the gas tank properly, but It will not run after it shuts off until I refill the tank & prime. I’m baffled. New tank, new hoses, new filter, new carb, & I can find no leaks in the fuel system. It runs strong. The 323L is a two-stroke & it always cranks on the second pull from cold on a full tank. Any ideas?
Have to run on half choke,just stops if i turn it off.fuel is 25 to 1. thanks alan.
More than likely a small passage way in the carb is clogged. You can try some carb cleaner, but you may need to disassemble the carb and clean it out. Be advised that these passageways are sometimes as fine as a human hair, and almost impossible to clear sometimes. A new carb may be required if it is worth it to you. Sorry.