Garden

I cleaned the air filter, changed the oil and do not know where to look for the spark plug for replacement. This is a push mower.

CubCadet OHV Model Number 959-468 11A-18MC056

Experienced gardeners share their insights in answering this question :
Pastorcheri,

I found this site if you can not find plug behind engine/blk wire with black cover boot/ pull off.

http://www.webcrawler.com/webcrawler301/ws/results/Web/Cub%20Cadet%20Online%20Part%20Lists/1/302349/RightNav/Relevance/iq=true/zoom=off/_iceUrlFlag=7?_IceUrl=true

Please rate. Thanks. jj505

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

One of the most common problems, especially because rototillers often sit unused for months, is stale fuel or a clogged carburetor. If you know you have fresh fuel, you can check for carburetor blockage by spraying a small amount of carb cleaner into the intake and attempting to start the engine.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
A dirty carburetor is the most common cause of a lawn mower that starts and then dies. Other possible causes include: Stale/Dirty Gas. Faulty Choke.
If the rotary tiller still doesn`t start:

Check that the fuel tank isn`t empty: if necessary, add fuel. The fuel must be fresh, of good quality and clean: make sure that no dirt, water or incompatible fuel (such as petrol-oil mixture, if the engine is a 4-stroke) gets into the tank.

You should change your tiller oil at least every spring, but ideally after every 50 hours of operation. Between oil changes, check your oil level before each use to ensure there`s enough oil present. Small amounts of oil may burn off during use, so you may need to occasionally top it off.
Replace the Spark Plug. If your lawn mower starts then dies right away, another possible culprit for the issue is the spark plug. A spark plug problem will result in the mower being more difficult to get going, and in some cases, the faulty spark plug may prevent it from starting at all.
Use Carburetor Cleaner

Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.

Watering too Little (or too Much!)

Underwatering and overwatering are both probable causes for brown or dying grass. Underwatering creates drought-like conditions when there isn`t enough rain to keep roots alive, and causes grass to die off.

Other things that could cause this issue are bad fuel, weak/colapsed/kinked fuel line, faulty spark plug, faulty ignition/coil, oil over full, clogged air filter, plugged/dirty carburetor, worn engine parts internal rings/valves/etc.
A rototiller, or tiller, is the heavier and more powerful of the two. Tillers are made for digging deeply and aggressively to break open the soil—for instance, when you`re creating a brand-new garden bed or to getting started at the beginning of the season.
Can a tiller cut through roots? Tillers can cut through smaller roots without much problem. The maximum size of roots that the machine can cut through depends on the tiller`s size and power, as well as the blades` size. However, running into overly large roots can stop, or even damage your tiller.
All Troy-Bilt tillers are shipped without oil in the engine, so the first thing you must do before starting and using your new tiller is add oil and fill the fuel tank. The engines in these tillers run on unleaded gasoline. Oil is added separately and is not mixed with the fuel.
Should You Wet the Ground Before Tilling? If the garden soil that you are planning on tilling is too dry, you should consider adding water to it before you till. Less is usually more, but water to a depth of about 4 inches. Let the water penetrate the soil before you begin the tilling process.
A powered tiller or cultivator will make removing grass or sod easier. While purchasing power equipment will add to your total cost, choosing the right tool may save you time and labor.
The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the engine for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
If the wheels on your tiller move but the tines don`t spin, you may need to replace tine shaft clevis pins or replace the transmission. The tiller`s transmission drives the wheels and the tine shaft, so you`ll likely need to replace the transmission when the wheels spin but the tine shaft doesn`t move.
The term “3 Point” refers to the Three-Point Hitch on the back of the tractor used to attach a variety of implements which are powered by the HP output of the PTO. The power is transferred to the implement via a PTO shaft (power take-off shaft) that serves as a connector between the two machines.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Wont stay running – Mtd 22" Yard Machine Push Mower
ANSWER : Under neath the carby is a single brass bolt, undo it

that one bolt is a multi jet, find four holes use a fine pin and carby cleaner ,hint one is at the top were the thread starts , one is in the inside center and two in the sides
put it back in and prim and start, hope it helps

Read Full Q/A … : Garden

Poulan pro chain wont stay running – Poulan Pro Chain Saw 46cc 20"
ANSWER : Keep “poulan” ha ha

Read Full Q/A … : Garden

Wont stay running
ANSWER : Bad fuel or check for water in your fuel! Clean your carb and float bowl. Empty gas
into a clear container, if there is two levels of liquid one of them is
water. Of course make sure you have good spark plug.

Read Full Q/A … : Garden

Where is the primer ball
ANSWER : It may not have a primer ball. If it does, it would be attached to the carberator. If it starts, but won’t stay running, that could mean your carberator needs to be cleaned/serviced.

Read Full Q/A … : Garden

Strimmer wont start plug very dry when i remove it?
ANSWER : Sounds like the gas is not getting to the cylinder—remove carb and disassemble–make sure all jets are clear and the float valve moves freely.

Read Full Q/A … : Garden

Wont start and primer button stay`s in when pushed
ANSWER : Try loosening the gas cap, if the primer bulb still stays in when pressed replace the fuel filter.

Read Full Q/A … : Garden

Why my blade wont engage on my toro 74370 zeroturn mower
ANSWER : It has an electromagnetic clutch switch on it,that is more than likely bad. Try this,pull the pto switch out and start the engine,then disconnect the 2 wires coming from the switch and just tap them together and see if they will come on. If they do then you need to replace that switch.

Read Full Q/A … : Garden

My mower wont stay on for more than 2 seconds after starting. Help!!
ANSWER : Remove the float bowl from the carburetor and clean it as well as the main jet up in the center of where the bowl nut screws in using an areosol carburetor cleaner

Read Full Q/A … : Garden