Garden

Experienced gardeners share their insights in answering this question :
Lawn mower trouble shooting, no start
First check the air filter. Is it getting air and gas? If not lets find out why.
1. Air Filters; There are 2 types. One is made of paper and the other is made of foam. NOTE: (Whenever you lift your lawnmower for any reason disconnect your spark plug and ground it.) NOTE: Do not run your engine or any engine without the air filter, it will RUIN the motor. When lifting your lawnmower on its side, always lift it with the carburetor up. A little oil Will come out, but not enough to hurt anything. If you lift your lawnmower with the carburetor down oil & gas will go everywhere. If your air filter is made of paper the oil & gas will ruin it. If not you will have to clean your foam one.

a. Paper filters cannot be cleaned with gas or any solvent, you can only use compressed air to blow the dirt out. If it’s very dirty, it’s best to replace.
b. Foam filters can be cleaned with dish washing liquid and water and dried with a rag. Then very liberally, work new engine oil throughout the air filter and squeeze out excess. The oil in the filter is what traps the dirt. If your foam filter is deteriorating or coming apart replace it, it can ruin your engine. Clean every 25 hours under normal conditions. Note: Use the same type of engine oil you use in your small engine to lightly oil your filter.2. Check your gas cap. The gas cap is a source of ventilation for the fuel tank. If your gas cap is clogged it will make your fuel tank vapor lock, and you will have no gas flow. To check and see if the gas cap is bad, loosen the gas cap and see if it will run longer than before you loosened the gas cap. If it continues running, you need to replace the cap, if it does not continue running check further in this troubleshooting guide for more information.
3. Is the fuel line clogged or partially clogged? Example: when you disconnect the fuel line from the carburetor and the gas is steadily flowing there is not a problem. But if it only drips with a full tank of gas replace it after checking the gas cap.
4. Do you have a fuel cut off? If so, is it cut on?
5. Do you have a gas filter? If so is it clear? If not, replace it.
6. Is the gas flowing in to the carburetor? If not you could have a piece of trash in the needle & seat. The needle & seat controls the gas flow that starts & stops the gas. You will have to clean or replace. It’s best to replace.
7. The float controls the gas level in the carburetor. If any of these signs occur, the carburetor is overflowing out of your air filter or out of your primer. If you have gas in your oil, you have carburetor problems. NOTE: Drain the oil if there is gas in it, if you don’t it can be dangerous. You need to check the needle & seat to see if it has trash or is bad. Is your float bad? To check the float pull the pin that holds your float in place, shake the float and if there is fluid inside of the float, replace it. Don’t forget to set the float level.
8. Carburetors with primers represent a large majority of lawnmower and small engines today. They have primers to push or force air in the carburetor and in turn force gas through the center jet to make starting easier. Then look to see if the primer is pumping gas in to the engine.
9. Things to check for if the primer is not working. This applies to several different types of engines. Check for holes or tears if you have a carburetor that has a diaphragm. (A diaphragm is a gas pump located in carburetors that have the gas tank and carburetors assembled together.) Replace the diaphragm if the diaphragm has a hole or has hardened or slightly slid over to one side, or if the engine will not run correctly and is skipping, not priming, or will not run at all. If you have a float type carburetor, the bowl gasket Will not be sealed properly and air will leak past the bowl gasket and will not prime. If you have a air assembly primer box where the air filter box is connected to carburetor, your gasket Will not be sealing correctly. If there is a tear or a hole in the gasket, air will leak past it and will not force air in the carburetor which will not force gas through the center jet. Also your air assembly box Will have a crack and will be warped because it was over tightened. If so, replace it.
10. Some models have chokes. Chokes are used to draw gas through the center jet to run. If the choke is not working properly and it is not closing all the way the engine cannot draw gas through the center jet and will not crank.

11. The throttle cable is what operates the choke on some models and the primer on some others, but it works the speed of the engine. To adjust the throttle that works the choke you need to loosen the throttle and open the throttle all the way, then push it until the choke is closed all the way. To adjust a “speed only” open the throttle all the way and make sure that the engine speed will be all the way open and then tighten the cable back up on the engine. Make sure if you have a kill switch on the throttle cable, that it works when you lower the speed all the way. If not, adjust again. Carburetors: Carburetors are the cause of 99% of all small engine problems. Carburetors are the easiest thing to repair on small engines.
We have videos to that will help you in the repair of your Lawn Mower and Small Engine

Section 2 Troubleshooting safety switch system
1. Spark. There are several things that would keep a lawnmower or small engine from sparking like the safety switches. Lawnmowers and small engines have several different locations where the safety switches Will be. If your lawnmower or small engine doesn’t spark you need to get your owner’s manual and find out where your safety switches are and then try to trace the problem.
2. Oil sensor. If you have one … The oil sensor will make your lawnmower or small engine quit running until you fill it with oil to the “full level.” This will cause the engine not to spark because of the oil being low. NOTE: This is a safety feature to protect your engine from running out of oil.
3. Stop cable or blade brake. This cable is connected to the handle bar and you have to hold the handle bar down for your engine to run. This cable becomes stretched after some time and needs to be replaced. There is a safety switch on the other end of that cable, on the motor, that Will not be opening all the way and in turn, not letting the engine spark.
4. Coils. Lawnmowers and small engines have changed a lot in the last 15 years. 99% of all lawnmowers and small engines today have electronic ignition coils which means no points. When you start your lawnmower or small engine and it runs until it gets hot and won’t start back again until it cools off you Will have a bad coil.

Lawn Mower Repair Troubleshooting Lawn Mower

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If your vegetables aren`t growing to full size or producing as much as you think they should, lack of sun might be the reason. If you can relocate your garden into a full sun area of your yard that`s the best option. If not, focus on growing vegetables that need less sunlight.
To revive the plant, you can soak it in water and then adopt a predictable watering schedule that uses the same amount of water each time. Remove dead leaves: Improper care may cause most leaves on the plant to die, and it`s usually best to remove leaves that have become entirely brown.
Thankfully, the answer is often yes. Whether they were damaged in a drought or a hard overnight freeze, most regional trees, shrubs and flowers can be nursed back to vitality – if you know how. When considering how to bring your shrubs back to life, it is important to determine the cause of the blight.
Plants require light to fuel photosynthesis, which nourishes it. A lack of light means that the plant is nutrient-deficient and has entered `survival mode. ` It will stop growing. No amount of water or fertilizer can fix this problem.
You can increase nitrogen in soil by adding nitrogen-rich fertilizer, composted manure, processed plant-based soil amendments, homemade compost, and even by planting certain crops that can pull nitrogen down into the soil from the atmosphere. These are all great sources of nitrogen for plants.
Some water is lost to evaporation, but overall hydroponics is very water-efficient. In properly maintained systems, plants can grow up to 30% faster than in soil.
Can I burn clothes in my garden? It is illegal to burn any waste in your garden, including wood. Many wood products are treated with toxic chemicals to prevent rot. Burning them can release harmful chemicals into the atmosphere and damage the environment.
Coffee contains a lot of nitrogen, which not only kills off weeds and bacteria but can also help certain types of plants (a.k.a those that prefer more acidic soil) flourish. Plus, your daily cuppa also contains significant amounts of magnesium and potassium, both of which are key factors in plant growth and health.
`Sugar water can be a wonderful boost to dying plants but I would not recommend it for every day watering,` says Rachel Crow, garden editor for Homes & Gardens. `Sugar water can conversely cause damage to plants that are otherwise growing healthily by changing the way their roots absorb moisture and nutrients.
What you can do is cut back any dying leaves or stems. Leave at least a few leaves to absorb and process sunlight. Be sure the plant has good drainage out of the bottom of its container. When it springs back to life and you see new growth, then consider a general water-soluble fertilizer to help it along.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Spark plug firing order – Farmall Tractor C ,super Av, Complete Gasket Set
ANSWER : Firing order for 96 lincoln mark 8, 4.6 liter

Read Full Q/A … : Garden

The engine fires, runs for 5-10 seconds and then dies. If I reprime it, it will repeat the same way over and over.
ANSWER : There is a number of different problems that could account for this.you may need to replace a clogged fuel filter, also check to see if the air filter is clean… there is also the possibility that you may need to put in a new carb kit.You may also want to check and make sure that the choke is not sticking.good luck

Read Full Q/A … : Garden

Troy Built 6.0 HP stored for winter. Fired up and
ANSWER : Most definitely. You aren’t getting enough gas, probably because the float valve is gummed up. Drain the gas, put in a little carb cleaner and a little fresh gas. Fire it up. Do that a couple of time if needed, then fill tank with fresh gas. Use a gas stabilizer like Sea Foam to prevent this.

Read Full Q/A … : Garden

Riding mower keeps back firing and will not start
ANSWER : You have a sheared timing key it is under thefly wheel replace says the red neck

Read Full Q/A … : Garden

How to get owner's manual – Troy-Bilt Pony Garden Tiller
ANSWER : Most of the time u can go to the place of sale and get one or just call
the company and get or go one line with tyap code and modal number a
and see if that helps.

Read Full Q/A … : Garden

Won't seal and hold pressure – Ace Hardware Acer Spray and Go Sprayer
ANSWER : Try smearing some Vaseline on the gasket that goes around the pump shaft at the top.

Read Full Q/A … : Garden

Sprayer hose split after 2 uses – Garden Brand Outdoor Garden Utility Sink – Gb4000
ANSWER : Manufacture defect–operator abuse–

Read Full Q/A … : Garden

Back fires – Honda 8 HP Engine
ANSWER :

Read Full Q/A … : Garden