Toro

My toro z turn timecutter 4325 mower will not go forward or reverse. What should I do to correct this? It starts fine and blades engage.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The reasons why mower is not moving forward or reverse is that the battery is dead, or due to clogged fuel line. Additionally, malfunctioning transmission, or a broken drive belt, also a faulty spark plug, even when friction wheel isn`t in contact with the friction plate, or damaged Tires.
Mower Not Moving. It`s a big problem if your mower starts but won`t move because this issue cannot be resolved by simply filling the tank or recharging the battery! A loose, worn, or broken drive belt commonly causes this problem , so you should check whether it`s properly adjusted and replace it if it`s damaged.
The drive wheels of a zero turn mower are controlled by two independent wheel motors. The ability for one wheel of the mower to turn forward while the other wheel moves in reverse is what allows the mower to turn in a zero-degree radius. Operators can make the wheels move in the same or different directions.
Replace the riding mower drive belt

If your riding lawn mower won`t drive forward or slows down when you go uphill, check the drive belt. Reinstall the lawn tractor or riding mower drive belt if it`s slipped out of place. Replace it if it`s damaged or broken.

Worn or broken blade drive belt – If the riding mower blades are not spinning, the blade drive belt may be worn or broken and unable to engage the blades. If the belt is intact, inspect it to see if it`s loose or slipping on the pulleys then replace it with a new one if necessary.
Zero-turn mowers can flip over when riding over uneven surfaces or slopes exceeding 10 degrees. If you have a rough lawn with bumps, consider exploring the lineup of traditional John Deere riding lawn tractors. Because the rear wheels control steering, zero-turn mowers can be difficult to stop.
Your zero turn mower is weak on one side because of one or more of many reasons: traction adjustment being wrong, dragging drum brake, bad dampers, incorrect balance, tire compression does not match, or there is air trapped in the hydrostatic motor.
Failure of any mechanical component, a broken hose, or clogged filter will cause tractor hydrostatic transmission problems. But the most common issue will be the oil itself. In the transmission section of your operator`s manual, you`ll find a section that covers oil viscosity.
Please make sure your tires are properly inflated. Then look along the steering shaft for a grease fitting, and grease the shaft. Check for any worn guides or bushings along the steering shaft.
Clear the mower deck of debris.

Grass clippings can clog the mower deck, especially while mowing a wet lawn, preventing the blade from turning. If the starter rope seems stuck or is difficult to pull, then it`s probably due to a clogged deck.

Failure of any mechanical component, a broken hose, or clogged filter will cause tractor hydrostatic transmission problems. But the most common issue will be the oil itself. In the transmission section of your operator`s manual, you`ll find a section that covers oil viscosity.
Grinding gears, starting and stopping during operation, and the wheels not rotating with the pulley are common signs that your mower`s transmission is breaking down.
Pulling a lawn mower backwards is generally not recommended, especially if it`s a self-propelled model, as it can damage the drive mechanism. However, if you`re dealing with a manual push mower and need to maneuver it in a tight space, pulling it backwards briefly should not cause harm.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Toro cutting off
ANSWER : Maybe low oil level, all mowers have a low oil cutoff. 30w oil.

Read Full Q/A … : Toro

Blowing oil out of the engine – Toro 52" 27hp Z Master Zero Turn Lawn Mower
ANSWER : Check oil level fuel could have flooded through into the engine oil which will cause it to blow out if so clean out carby and check that needle in the carby is sealing

Read Full Q/A … : Toro

<!– from fixya rte –>How do I engage bagger on zero clearance – kawasaki 48'' Toro Com Zero Turn Lawn Mower 21hp Kawasaki ()
ANSWER : That should be covered in your manual. I’m not sure what a zero clearance mower is actually, are you assuming and making up a name for it?

Read Full Q/A … : Toro

Diagnosing possible pto issue – Toro Zero Turn Rider 74366 Lawn Mower Tractor Rider Ztr
ANSWER : Check plug on the pto itself.located under the mower near the rear end. contacts probably have dried dirt and mud. if that don’t work, tap it with a hammer,it may be just stuck.Thats what I did and it been working ever since. Hope this helps someone.Let me know.

Read Full Q/A … : Toro

I have a toro time cutter that i need to get to the shop, the problem is i need it to go in to neural.
ANSWER : Under the seat towards the rear are two levers with finger loops. move them both to the neutral position shown in diagram provided on mower. This will release the wheels .

Read Full Q/A … : Toro

Battery goes dead over night – Toro 42'' Zero Turn Lawn Mower Trailer Package Deal ()
ANSWER : First thing to do is find out if it’s the battery or the mower. Disconnect the battery and leave it overnight. If it’s dead in the morning, you need a new battery. If not, you either have a charging problem (not likely if the battery isn’t dead after using the mower) or you have a current drain.

Read Full Q/A … : Toro

Not getting fuel to carburator have fuel and good filter have a solinoid on carburator bowl that is very hot could this be the problem
ANSWER : Yes it is called a rollover valve so if machine rolles over it shuts fuel off preventing fire, remove bowl and clean it out and spray p.b. blast on the solenoid needle and keep working it till it moves free with the electricity from the batt should cure problem

Read Full Q/A … : Toro

19 h.p. kawa mowing and motor stopped. Will not turn over at all. PTO was engage when shut down
ANSWER : See if it vapor locked pull plugs out and turn it over without them in if works put plugs back go on down the road and mow

Read Full Q/A … : Toro