20 hp 42 in. Deck Lawn Tractor – CA Model

Experienced gardeners share their insights in answering this question :
How your fuel cap vent?

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
An object or obstruction (such as an ant hill, clump of matted grass clippings or large tree branch) is jammed underneath the cutting deck or in the cutting deck drive system preventing the moving parts from engaging properly. Inspect for obstructions and carefully remove if necessary.
Being Overworked

One of the most common reasons that a lawn mower might stall while it is cutting grass is that it is being overworked. This is a mechanism that is intentionally incorporated into the mower to prevent the motor from being blown.

Condensation inside the gas tank is one culprit, but moisture can also enter the system through a loose or ill fitting gas cap. The best solution is to drain the mower`s gas tank and refill it with fresh gasoline. A clogged fuel filter can also cause a mower engine to die.
The most common cause of a mower that runs for thirty minutes and then dies is a faulty armature. A faulty gas cap is the second most likely cause.
As the fuel level drops, a vacuum begins to form in the fuel tank because air can get in to fill the space the consumed fuel occupied. After about 10 or 15 minutes, the vacuum will become strong enough that fuel will stop flowing to the carburetor and the lawnmower will die.
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that`s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
A dirty carburetor is the most common cause of a lawn mower that starts and then dies. Other possible causes include: Stale/Dirty Gas. Faulty Choke.
It may be a bad spindle bearing that is seizing up when you engage it which puts too much load on the engine and makes it die. You may hear some squealing sounds from the spindle and the belt may smoke. Most all these spindles can be taken apart and you can easily replace the bearings.
Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
If your lawnmower will start and run with the choke on but dies when the choke is turned off, it may have a problem with the carburetor. The carburetor brings air and fuel together and mixes them in the perfect ratio for combustion before they enter the engine.
A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
Reasons Mowers Stall

If you have a steeply graded property, hill stalling is often a sign your mower is not strong enough to perform the task at hand. Another reason this occurs is due to problems with the engine, such as bad spark plugs and ignition coils, a clogged carburetor or a worn out transmission.

Other things that could cause this issue are bad fuel, weak/colapsed/kinked fuel line, faulty spark plug, faulty ignition/coil, oil over full, clogged air filter, plugged/dirty carburetor, worn engine parts internal rings/valves/etc.
A dirty air filter is one of the most common causes of a poorly running lawn mower, since it starves the engine of the oxygen needed for combustion. Fuel Filter: Check the fuel filter on the mower to make sure it`s clean, and replace it if needed.
A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Check that all the safety switches are working correctly, it is possible the seat switch is bad or loose plug/ bad wire. Also if battery weak or charging system weak/faulty the clutch will stall out engine, charge battery up with charger and try.
An unbalanced blade spinning that fast will cause a significant amount of vibration, which will put stress on yout blade shaft, spindle, and even the engine. So if you want to get the most life out of your mower… keep the blades balanced! If playback doesn`t begin shortly, try restarting your device.
If your bike is only running with the choke on, it`s probably because it`s running too lean. This can be caused by a few different things: All internal combustion engines need three things to run: fuel, air, and spark. If any of these are missing or not working properly, the engine won`t run.
Common signs include reduced engine performance, black smoke coming from the exhaust, backfiring, overheating, or hard starting.
With the choke on, the fuel blasts its way in and provides the carburetor with the fuel it needs. While this is relatively safe and doesn`t harm any of the internal parts of the bike, it does lead to higher consumption of fuel.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

How do i install a mulching plug on my craftsman lawn tractor?
ANSWER : It covers the hole on the deck

I have problem with pulles an my craftsman 17 hp 42in
ANSWER : YOU MUST USE SEARS BELTS ! THERE A ODD SIZE

Why does my lawn tractor shuts off – Craftsman 20 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : How your fuel cap vent?

Need mower deck belt size – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : Www.searspartsdirect.com

Craftsman riding mower lt-1000 leaks gas – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : Need to fix that. it may be a fire hazard.

Problem for Craftsman 20 hp 42 in. Deck Lawn Tractor – ca model
wheel alignment: both wheels point outwards
ANSWER : The bar connecting the wheels is bent. this is easy to change. just pull the pins out on both sides and lift the rod out. you can straighten it in a vise or order a new one through sears. cost about $12. our local repair shop keeps them on hand.

Can’t get front wheel back on lawn tractor
ANSWER : Grease your shaft and make sure you have no dirt on it, even dust can hinder getting it on right.

What type of oil for 17.5 42 500 cc – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : I use straight 30wt.