23HP VTwin Dual Hydrostatic 48″ ZeroTurn Radius Mower

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Typically, however, on vertical shaft engines, the oil drain plug is located beneath the engine block near the crankshaft. To remove the square plug, all that is required is a standard size 3/8″ ratchet and extension (no socket).
Look under the car and locate the drain plug: It is a large nut or plug located under the oil pan (large tank) at the bottom of the engine.
Use a work light or flashlight to look under your car. You should be able to see and reach a large nut or plug located under the oil pan at the bottom of the engine (see Figure 13-6). This is the oil drain plug.
Use a work light or flashlight to look under your car. You should be able to see and reach a large nut or plug located under the oil pan at the bottom of the engine (see Figure 13-6). This is the oil drain plug.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

What type of oil doe it use – John Deere Gx75 Rx75 Srx75 Sx75 130 9hp Starter
ANSWER : 10W-30 Turf Gard

http://www.greenpartstore.com/John-Deere-GF-3-10W30-Turf-Gard-4-Cycle-Motor-Oil-Quart-TY22029.html

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

What is the spark plug gap for a john deere 14sb lawnmower with a kawasaki engine
ANSWER : Check this link for more information .025

I have changed the fuel filter on a John Deere L130 garden tractor and the engine is still not getting gas. Is there a fuel pump or other part which would stop the flow of gas to carbuerator?
ANSWER : Underneath carb bowl should be a wire. Unplug it and remove ( unscrew) electric gas shutoff. Replace.

Free belt diagram john deere freedom 42 – John Deere 42 in. EZ Trak Bagger

Spake plug is not spakeing – John Deere Original 130 160 165 175 180 185 Operators
ANSWER : Hi Lloyd
Make sure you are getting spark at the spark plug, to do this:Remove your spark plug and check to be sure you are getting a bright blue spark at the spark plug.You do this by grounding the plug on the head of the engine and cranking the engine or by pulling the crank rope…watching the plug for spark.If you are getting a nice blue spark then skip A below and go to B.
A…If you do not get a nice blue spark then you may need to replace the electronic module.Note: If you have to replace the module be sure to measure the position it is in, it is critical to starting.The clearance can be measured with a “business card”…use the card for the right clearance between the coil and the flywheel.Take a picture for later reassembly.
B…Also take some fine grit sandpaper (not emery) and lightly sand the flywheel where the magnet is located to clean any rust or corrosion from the magnet area.Please rate meBud

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.