Sometimes it starts after clicking for a while.
Experienced gardeners share their insights in answering this question :
Check all contacts on the battery, solinoid, and starter. If that does not help, check the charge on the battery.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The clicking noise comes from a part called the starter solenoid. The solenoid connects the battery to the starter motor when the solenoid is energized. The key switch and the safety switches in the starter circuit combine to energize the solenoid. If the solenoid is clicking, the circuit that triggers it is working.
It might be a faulty starter
One of the symptoms of a bad starter is a single clicking noise when you turn the key or push the start button. Tapping the starter can sometimes get it going again, but no guarantees. Most likely, you`ll need to get your starter repaired or replaced.
Usually a rapid clicking noise is a good indication that your starter motor isn`t getting enough electrical current to engage – basically your solenoid is trying to engage but can`t make the connection.
One possibility is the solenoid. A single “click” sound comes from the engine compartment or from under the car. This could mean that the solenoid is trying to engage but that the internal components are stuck and unable to work properly. Repeated “clicking” sounds usually indicate a dead battery.
The starter relay makes a clicking sound, but the engine does not rotate, which indicates that the starter motor is not receiving enough current from the relay. This may also be a sign of low or exhausted battery power. Only when it transmits enough current to the starter, the relay starts to work.
Low fuel pressure can cause a backfire when there`s too much air and not enough fuel in the combustion chamber. This can be rectified on lawn mowers with speed settings by simply increasing the speed and thus increasing the fuel supply. Another possible cause is a failing fuel pump or even an old fuel filter.
Your lawn mower turning over but not starting due to several reasons, such as a faulty or disconnected plug, a disconnected spark plug wire, a clogged air filter, or a contaminated fuel tank. A faulty carburetor, a dirty cutting deck, or a dysfunctional flywheel brake can also cause this.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
My tractor does not stated
Battery may be dead try charging / jumping it
My cub cadet won’t start just clicks ,i changed the fuse and tryed to jump start it no luck what do i do now?
Check your soleniod.
When turning key to start, it will only make a click. Seems to have voltage to starter,could the battery be to weak to start? Voltage from battery is 11.4
Yes, it could be the battery…the voltage may be at 11.4, but may not have enough amps to turn the engine over…try putting it on a battery charger, see if this makes a difference
Engine wont start just get a click
Charge you battery or get a new one and you will click no more!!!!
Does not run, will start with starting fluid – Mantis 2-Cycle Tiller
You should never use starting fluid on this model.
Add a couple of ounces of 100% acetone (available at Walmart) to some fresh fuel. Attempt to start for several pulls. Let sit for several minutes and repeat until it sounds like it wants to run.
Then watch this video and do it:
Strimmer wont start plug very dry when i remove it?
Sounds like the gas is not getting to the cylinder—remove carb and disassemble–make sure all jets are clear and the float valve moves freely.
Toro clear won't start – Toro Power Clear 621 R
Bad gas , plug ,air filter , no spark ck all need all 3 to start
Snow blower wont start
Clean the fuel out and the carb , make sure you are getting spark close the choke to start then shut if off or it will foul the plug