Riding Lawn Garden Tractor 25hp Kohler 50″
Experienced gardeners share their insights in answering this question :
The tractor has a safety feature that doesn’t allow you to start the engine with the mower engaged. Just disengage the mower, then start the engine. Once you have it running, then engage the mower.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Discharged battery, faulty electrical connection (battery circuit), battery leads too long or wire diameter too small, or incorrect size battery (too small). To address these issues, check the battery and charging system for problems. Wrong oil viscosity for temperature expected.
Riding Mower Clicks but Doesn`t Crank
When you hear a click as you turn the key, a weak battery, bad starter solenoid, faulty wiring, failed starter motor or a seized engine could be the cause. This DIY troubleshooting will help you figure out what to fix.
Why does the tractor make a clicking sound and not start? If the riding mower makes a heavy clicking or a rapid clattering sound when the key is turned to the start position, there is a problem with the battery or a part of the starting circuit. The clicking noise comes from a part called the starter solenoid.
If a mower is hard to start, it may be the result of a dirty carburetor and/or a clogged air filter. Use a screwdriver to remove the carburetor and clean any dirt out of it with a rag. Clean the air filter or replace it if it`s disposable.
What to Do If Your Tractor Won`t Start, Just Clicks. If your John Deere won`t crank and all you hear are clicking sounds when you turn the key, you likely have a bad battery or a bad connection somewhere between the battery and the starter. Double check that the alternator and battery connections are clean and tight.
Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced. If the starter motor does not run, the motor itself is probably defective.
Usually, this points to a faulty relay or solenoid, or a bad or jammed starter motor. Solution: Rock your car back and forth or tap the starter motor with a hammer and try starting the engine again. If this works, you are good to go!
Your Mower Won`t Start:
Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.
Usually, this points to a faulty relay or solenoid, or a bad or jammed starter motor. Solution: Rock your car back and forth or tap the starter motor with a hammer and try starting the engine again. If this works, you are good to go!
Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced. If the starter motor does not run, the motor itself is probably defective.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Why my blade wont engage on my toro 74370 zeroturn mower
ANSWER : It has an electromagnetic clutch switch on it,that is more than likely bad. Try this,pull the pto switch out and start the engine,then disconnect the 2 wires coming from the switch and just tap them together and see if they will come on. If they do then you need to replace that switch.
Does not run, will start with starting fluid – Mantis 2-Cycle Tiller
ANSWER : You should never use starting fluid on this model.
Add a couple of ounces of 100% acetone (available at Walmart) to some fresh fuel. Attempt to start for several pulls. Let sit for several minutes and repeat until it sounds like it wants to run.
Then watch this video and do it:
http://www.alamia.us/mantis_parts_s/148.htm
Have a john deere sabre turn key won’t start thought battery was dead charged battery still won’t start jump start with car battery it will start then . try to engage reverse with blades running it shuts off. shut down tractor won’t start again .I,m thinking wiring not grounded but where or replacement switch somewhere.give best advise.
ANSWER : Some mowers have a mowing reverse safety switch. That safety will kill the mower if you try to reverse with the deck engaged. Some mowers even have an override button that has to be held while backing up. As for the battery thing, no matter how much you charge a bad battery you will not get it to start a mower if it has a bad cell or two. I would use a multimeter to check battery voltage, but the end result would still be the same, replace the battery.I hope this gets you going again.
Strimmer wont start plug very dry when i remove it?
ANSWER : Sounds like the gas is not getting to the cylinder—remove carb and disassemble–make sure all jets are clear and the float valve moves freely.
Toro clear won't start – Toro Power Clear 621 R
ANSWER : Bad gas , plug ,air filter , no spark ck all need all 3 to start
Tines continue to work with out touching safety or throttle. they engage as soon as I start the engine.
ANSWER : Remove H (high) L (low) plastic caps to allow you to further adjust the flow and you will be going. H (red) further out about 11 threads exposed and L (low) about 8 exposed; adjusting the low side will stop the tines, but remove tines before making any adjustments, thanks
My toro groundmaster 225 wont start. I started it up, drove it to the front of the driveway and when I engaged the PTO it died and hasnt started since. I replaced the battery but still I get nothing. Ive tried spinning the blades manually to turn the engine over a few times before starting and that does nothing.
ANSWER : Check for a loose ground on your battery and for a blown fuse in the electrical system
<!– from fixya rte –>Rj19lm plug gap for a 195cc 4cyl lawnboy – Lawn-Boy lawnboy" Mower Blade 21"
ANSWER : As a starting point in my shop i always use 0.30 in. For all my mowers