Poulan

Want to replace the two fuel line in gas tank

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

“belt” or “pump”. This is the replacement fuel line 25 Inch for several OPE products that use small engines. The fuel line carries fuel from the tank to the carburetor.
Fuel line diameter matters A LOT! A larger diameter is generally better, but the correct diameter is the best choice. If the diameter is too small: you won`t be able to support your horsepower goal. If the diameter is too big: the lines will take longer to pressurize.
A: Our units run on 87 octane regular unleaded gasoline. You can use gasoline which is blended with a maximum 10% alcohol. Never use E85 or diesel fuels. Remember to use fresh gasoline and to mix it with the recommended 2-cycle oil.
Designed for use in Poulan Pro, Poulan and Weed Eater 2-Stroke air cooled engines that require 40:1 fuel + oil mixture. This ethanol free, high octane fuel stays fresh for years solving long term storage needs.
You can find Poulan Pro products both in-store and online at home improvement retailers, hardware stores, and mass merchants all over North America. We are here to help you tackle… ANY YARD.
Replacing the fuel hose on your vehicle is going to take time and patience, and it could require getting underneath the car. It`s also going to take the right tools for the job.
Fuel Line: 1/4″ I/D.
A: Mix 3.2 ounces of Poulan 2-cycle air cooled engine oil to one gallon of fresh unleaded gasoline to obtain the recommended 40:1 fuel to oil ratio.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I need the fuel line size on Homelite gas blower. Is the fuel filter a washable/cleanable filter?
ANSWER : I think they are 1/8 in hoses on them and if it is a foam filter they are washable,mild soap and then a light coating of oil

Read Full Q/A … : Poulan

Need to replace fuel lines on my Troy Bilt gas hedge trimmer. Where can I get replacement fuel lines… or better yet… what size are the lines and where can I buy a few feet of the lines. Note: I have reviewed the parts assembly and it would seem to indicate I have to replace the entire handle assembly (Part #1) instead of just buying replacement hose(s). Any help to resolve my issue would be greatly appreciated and thanks in advance
ANSWER : Replacement fuel lines should be readily available at your local lawnmower repair shop. Your TroyBilt hedger uses fuel line that is 3/32″ (2.4mm) interior dimension, 3/16″ (4.8mm) outside dimension, with a 3/64″ (1.2mm) wall dimension.
Most manufacturers don’t offer replacement line, only fuel tank assemblies. Find your local shop, and try to get the TYGON brand…it is yellow. Tygon lasts the longest. You should be able to buy it by the foot for less than $2 per foot. You will need 2 feet of hose to replace both lines.

Make sure to clean the in-tank filter when replacing hoses.

Good luck.

Read Full Q/A … : Poulan

Poulan te 450 cxl fuel lines need routed correctly two line both in tank one to fuel filter other line?
ANSWER : Other line is just left open like to send gas back from the carb.

Read Full Q/A … : Poulan

Replaceing fuel line in polan 3300 chain saw – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : Hi owjbhend…
Use a piece of wire and insert it into the fuel line, then bend a hook in the end and hook it over the end of the fuel line…lubricate the fuel line with some vaseoline very lightly…about the first one inch of the fuel line and then use your fingers to start the fuel line into the tank, once you have the fuel line in the tank give enough to hook the fuel filter to and so it can be dropped back into the tank.
Below is a drawing of how to route the fuel lines.
Please take time to rate me thumbs up
Please take time to rate me thumbs up

Read Full Q/A … : Poulan

How to get new plastic fuel lines in fuel tank in my weed-eater hedge trimmer. the line is larger than the hole in the tank.
ANSWER : Oftentimes it helps to use scissors to trim back a portion of the new line. Start at the bottom and cut upwards at an angle. Put some lubricant (WD40, perhaps) on the line and slide the sharp point into the fuel tank. Using needle nose pliers, grab the line and pull it through. This will only work if you have the correct size line. If the new line you are using is too large, you probably can’t pull it through.

Read Full Q/A … : Poulan

Replaced fuel lines and pressing the primer pump does not feed gasoline to the car.
ANSWER : Sounds like you have the fuel lines switched around. The fuel line closest to the primer bulb will be the shortest line. It only goes 1″ or so into the tank. The other line will be the longest line, and sometimes the smallest in diameter of the two depending on the size of your trimmer, and must rest comfortably on the bottom of the tank.Jim

Read Full Q/A … : Poulan

Which fuel lines go where on Craftsman hedge trimmer, just replaced fuel lines and forgot where big line goes and small line goes
ANSWER :

Read Full Q/A … : Poulan

Fuel return line ;is it the same size or smaller than feed line
ANSWER : Diameter of return is smaller and avaiable at the dealer or model car-airplane shops

Read Full Q/A … : Poulan