13.5hp Briggs And Stratton Intek Lawn Mower Engine

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Craftsman Husqvarna 140294 Lawn Tractor Ground Drive Belt, 1/2 x 82-in Genuine Original Equipment Manufacturer (OEM) Part.
A: Your mower has two belts. Both play a role in making the blades turn. The “Deck Belt” goes around the pulleys right above the blades on the deck and then to a double pulley. The “Drive Belt” on your mower goes from the transmission, around an Idler pulley then over to the double pulley I mentioned before.
An easy way to determine belt size is to simply “add 2″ to your off-the-rack trouser size. For example, if you wear a 36” waist trouser, then a 38-belt size will be a safe bet. Most will find this simple formula works best for pants worn at a traditional height–close to the natural waistline.
Start the tape measure at the hole you use and measure to the end of the belt, where it meets the buckle. Belts are measured in inches and you should round to the nearest inch. If you measure 36 inches, you will want to purchase a size 36 belt.
x 96-5/8 in. for 42 in. Deck Riding Mowers, Fits Cub Cadet, MTD, John Deere and more (R-75-813)

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

My Toro mower with a Briggs & Stratton engine starts and then cuts off after a few seconds. How do I fix this?
ANSWER : If it starts on choke and then stops may need to clean out carby and fuel tank

How do I remove and clean air filter? – Briggs & Stratton Lawn-Boy 10640 20-Inch 6.5 HP Gas Powered Lawn Mower
ANSWER : There should be a square of plastic on the side of the engine which is opposite of the muffler. It has a small hex head with a slot cut in it. Remove this plastic cover and the air cleaner should be inside of it.

Backfires and will not start – Parks Optical 13.5hp Briggs And Stratton Intek Lawn Mower Engine
ANSWER : Be more specific make sure your motor has an exhaust the motor should be sucking in fuel and you might want to rev the motor as soon as you start it

I have a lawn mover that has the Briggs@Stratton engine. The model number is 28R707 Type 1120-E1.

Recently, I notice the engine oil level rises; and when I start the engine, oil spits out from the vent that is located in the carburetor housing. I like to know how does it do that? Your answer is really appreciated.

ANSWER : Your float has stuck in your carb,and that is why your oil level is rising need to buy a new needle and seat ,change you oil.

Riding mower keeps back firing and will not start
ANSWER : You have a sheared timing key it is under thefly wheel replace says the red neck

Have a 10.5 briggs that is pushing gas and oil out the blow by pipe.what can i do
ANSWER : The oil level is to high or air filter pluged.

Lawn mower will turn over a bit with booster conectd then it doesnt start. Already have a new plug in it.
ANSWER : Adjust the valves to .04 this will do it if you havent damaged starter already, and the battery is good

Front propulsion not engaging – Craftsman 675 Series 190cc 22" Briggs Stratton Rear Bag Front Propelled Lawn Mower ()
ANSWER : This is probably a belt driven machine…remove the cover. (could have Torx screws). and see if the belt is on the lower engine pulley and is on the pulley to the drive transmission…If OK, then check the action of the spring that helps engage the transmission.