Poulan

I am replacing my fuel lines but they were cracked and broke off when removing the carb. Now I dont know where the lines route.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The (clear) main fuel line with the filter (filter inside the fuel tank) goes to the bottom of the carburetor (or the elbow shaped nipple). The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb.
The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb. The return line (blue) comes from the long post on the back of the primer bulb and goes into the bottom of the fuel tank.
Fuel lines are made of durable metal, plastic materials and though they are located in the undercarriage of the vehicle, and seemingly in a vulnerable position, they are placed in areas that cannot be damaged due to elements, road conditions, or exposure to heat from the engine`s exhaust or other components.
The return line should direct fuel close to the bottom of the tank and away from the pickup.
One is the high pressure line, which sends fuel to the injectors. The other is the return line, which dumps fuel that the injectors don`t use back into the tank.
Most vehicles have rubber fuel hoses connecting the fuel pipes on the chassis to the fuel pump or carburetor on the engine. Rubber hoses are flexible and can be cut to length as required, but they have a tendency to perish over time and can rub through if not properly secured.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Replaceing fuel line in polan 3300 chain saw – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : Hi owjbhend…
Use a piece of wire and insert it into the fuel line, then bend a hook in the end and hook it over the end of the fuel line…lubricate the fuel line with some vaseoline very lightly…about the first one inch of the fuel line and then use your fingers to start the fuel line into the tank, once you have the fuel line in the tank give enough to hook the fuel filter to and so it can be dropped back into the tank.
Below is a drawing of how to route the fuel lines.
Please take time to rate me thumbs up
Please take time to rate me thumbs up

Read Full Q/A … : Poulan

Poulan te 450 cxl fuel lines need routed correctly two line both in tank one to fuel filter other line?
ANSWER : Other line is just left open like to send gas back from the carb.

Read Full Q/A … : Poulan

How do I replace the fuel line for a Poulan ppbp30?
ANSWER : Open the top of the machine to access the carb, Normally it is easily done with needle nose pliers.

Read Full Q/A … : Poulan

Poulan chainsaw 18″ 42 cc, pro gas filler cap?
ANSWER : Yep they swell after a while and will not screw in or out!
Sand the threads down so that the circumference is reduced with a course file or plumbers cloth, chamfer the threads a bit on the edges. A new one will do the same thing after a while so just fix the one you have.

Read Full Q/A … : Poulan

How do i gey new fuel line through case and into tank?
ANSWER : Is there a metal fitting on the tank top that will unscrew? If so, pull the old line out with the fitting (remove the filter first). Be sure to use original type line, not plastic which is not flexible enough. Hope this helps!

Read Full Q/A … : Poulan

The saw starts up fine, runs fine but not for long. it runs for about 1 minute and dies. like it is out of fuel or sucking air, i noticed there is no filter on the suction line and there is another nipple entering the fuel tank which appears to need a hose on it , is this just a return line, or should the long line in side the tank press on to this nipple? thanks,
ANSWER : I’ve had my pp4218 for about 2 years and the fuel lines have rotted. I’m thinging from ethanol in the gas. However, I’m replacing them and cannot tell which lines go where. Does the large line from the bubble go to the filter and the little line return?

Read Full Q/A … : Poulan

Routing of fuel lines from tank to primer bulb to carb
ANSWER : Line with filter goes to carb inlet,
Line from carb goes to inlet side of bulb.
Line from bulb goes to tank

Read Full Q/A … : Poulan

How to replace fuel lines on a ut08514 blower
ANSWER : Go to youtube.com and watch the video and it will show you how to replace the fuel lines. Hope this helps.

Read Full Q/A … : Poulan