Garden

Experienced gardeners share their insights in answering this question :
If it is model with the stand mounted to the back, Put the mowe in the off position and remove the key, slowly pull on the rope until you feel compression, tighen the fuel cap vent completely down and tip the mower completely up, rear of machine on ground front of machine facing up, the posts on the back of the machine will keep it steady, if it is a different style machine I will need a model number

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

How To Sharpen Lawn Mower Blades Without Removing Them
  1. Step One – Gather the necessary tools. …
  2. Step Two – Cut the power or seal the tank. …
  3. Step Three – Tilt the mower. …
  4. Step Four – Clean the blade. …
  5. Step Five – Start sharpening the blades slowly. …
  6. Step Six – Lower the mower and unseal the tank.
24 déc. 2021

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

How do i add transmission oil – Ariens Lawn Tractor 46"" Riding Lawn Mower 936053"
ANSWER : Should a plug or cap on top of transaxle.

Read Full Q/A … : Garden

Blades wont ingage on my craftsman lawn tractor #917.274811?
ANSWER : After hitting a tree root, blades will not cut when I press to engage

Read Full Q/A … : Garden

I have a Crafstman Riding mower model #917.273643. That ran fine one second, I shut it off for five minutes. When I went to start it back up it wouldn’t start. Cranks fine, checked the wires, fuse, and spark plug. The plug was dirty so I cleaned it. But I am not getting any spark. I bought a new plug still no spark. I also checked the plug on another motor and I had spark so the plug wasn’t bad. Any suggestions on how to troubleshoot this or what may be wrong?
ANSWER : Sounds like your coil went bad

Read Full Q/A … : Garden

I need to get the blade of the lawn mower sharpened.Any tips on how to disconnect the blade fropm the lawn mower?
ANSWER : There is a jig that you can buy that makes this job SO much eaiser. It is a universal jig that clamps onto the deck and keeps the blade from spinning so you can use a ratchet to remove the nut holding the blade on. One name brand is called a “Blade Hog”. You should be able to find one of these at one of the bog box hardware stores.

Hope this helps,
Chad

Read Full Q/A … : Garden

Nxt 2346 trouble shooting guide
ANSWER : Check for a lock pin that you have to move out of the way. push on the deck height control pedal and pull the lock lever out of the way. this is what keeps the deck up when travelling.

Read Full Q/A … : Garden

Which direction do you turn the bolt holding lawn mower blades on?
ANSWER : Clockwise to tighten. Remove the spark plug wire before working under there! Use a piece of wood to jam the blade against the housing so it will not turn.

Read Full Q/A … : Garden

Mower jerks when going up an incline. – Husqvarna Riding Lawn Mower 46 Cut Kohler Yth21k46
ANSWER : Belt spilling

Read Full Q/A … : Garden

The engine starts and the blades can turn. Both of the belts are on, but the mower will not move in either direction. The blades were raised before going over a tree root. the mower rock back and forth because of the root and the mower stopped
ANSWER : Sounds to me as if you have broken a shear pin in one of the drive pulleys. They are made this way so a shear pin will break instead of doing real damage to the drive train itself.

Read Full Q/A … : Garden