There is no spark at the spark plug
Experienced gardeners share their insights in answering this question :
HOW DO YOU CHECK TO SEE IF THE SWITCH IS BAD ?
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The most common problem with a strimmer not starting is that there`s a problem with the fuel mix. Double check that you`ve used 40 parts fresh unleaded petrol to 1 part 2-stroke oil (40:1). Check the petrol you`ve used isn`t stale.
With both manual and gas-powered rotary edgers, the general technique is to push the tool forward as the blade rotates, cutting a clean edge along the border. What is this? It is essential to maintain a steady pace and avoid forcing the tool, as this can result in an uneven edge. Just let the blade do all the work.
When your trimmer starts and runs on choke, it could be because the check valve in the gas cap is clogged. Start the trimmer and gently unscrew the gas cap halfway off. Turn the choke off and assess. If the engine is still running, that means the gas cap may be the culprit.
Turn on the ignition switch and pull the starting cord quickly. You should see a spark in the plug gap. Since the spark may be faint, it may help to do the test in a dark area. If there is no spark, check for a broken or shorted (bare) lead wire or bad switch.
If your RYOBI Edger isn`t starting: For 18V or 36V Battery models: check the battery has charge by pressing the fuel gauge. For AC models: turn the power point switch off and check the cord is inserted correctly in the extension lead. Use a heavy-duty extension lead no longer than 25m for optimal performance.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Brand new electric power Weed Eater lawn Mower, started up like a champ, started vibrating and was loud, shut it down, now it won’t start. Checked the extension the outlet all seems fine. Didn’t even use it yet. Why will it not start?
Battery no good from factory bad battery connection maybe put together on a Monday or maybe battery internal charger no good
Weed eater will start but the head will not rotate. its like some thing is not connected.
From your Description it Sounds like the Shaft May have Slipped Out of the Power Head and the Drive Cable is Not Engaged to the Drive, the Clutch is Worn Out, the Drive Cable is Worn and Requires Replacing, the Trimmer Head has Slipped and is Not Engaged to the Drive Cable or the Trimmer Head Gearbox is Bad and Requires Replacing.
>>Send me the Model Numbers Off the Unit, Please. With these I can Locate the Proper Manual and Better Assist you.
Please, Do Not Hesitate, If I Missed Something or you Hit a Snag or this Does Not Correct the Problem, I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Be Safe and Be Happy. Thanks.
My stihl weed eater fs85 hard to start when hot
Try loosening the gas cap to relieve any pressure, then tightening it back up. Usually you will just need to barely unscrew it and then screw it back even before you pull the rope.
<!– from fixya rte –>Rj19lm plug gap for a 195cc 4cyl lawnboy – Lawn-Boy lawnboy" Mower Blade 21"
As a starting point in my shop i always use 0.30 in. For all my mowers
I have trouble starting a toro walk behind mower
All, I thought my carb was shot, so I replaced it. Still, start but no run (and had to use starting fluid). THEN!!! I noticed the spring to the “rev limiter” (just below and towards rear of carb) was not “tight”. The stupid bracket that holds the end of that spring had been bent down ~1/16″ and that caused all this heartache. CHECK YOUR REV LIMITER!!!
My weed eater hedge trimmer runs for about 10 minutes and cuts off. It seems as though it is flooded, because it won’t start again until some time later. But it continues with the same pattern. I purchased a can of premixed gas/oil to make sure it was my mixture, to no avail. I have not replaced the spark plug yet, but I don’t think that has anything to do with it. Do you have any suggestions?
The plug can be the problem but also the air mix as well get the best plug you can
Weed eater won’t run
Sounds like you may just have a dirty carburetor.Youwill need to disassemble the carburetor and spray with carb.cleaner.Make sure the small screen is free of debris. (Should be able to seedaylight through it.)Use a Den Tek Brush, (http://www.drugstore.com/products/prod.asp?pid=165357&catid=1152),to clean the small portals in carb. These portals can become blocked. Reassemble and start.If the carb. parts are more than 4 years old, you may have to replace them.If you need further assistance, just let me know.Jim
Why wont my mower start and gas comes out of muffler
Carb is flooding out ether bad plug or your carberator needs rebuilt