Inc Earthquake Mini Cultivator

Experienced gardeners share their insights in answering this question :
You probably need a new coil, if it is a 2 stroke then it will almost certainly be the coil. The defect is very typical and recognizable.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The Victory™ features a 209cc Viper™ engine that delivers optimal power to the rear-mounted counter rotating (CRT) tines which have aggressive soil turning capability.
One of the most common problems, especially because rototillers often sit unused for months, is stale fuel or a clogged carburetor. If you know you have fresh fuel, you can check for carburetor blockage by spraying a small amount of carb cleaner into the intake and attempting to start the engine.
Ardisam, Inc., Manufacturing Company warrants its Viper Engines under a two year limited warranty to be free from defects in materials and workmanship for the service life of the product not to exceed twenty four consecutive months from the date of purchase for consumer applications.
Authenticity. We are real people living in northern Wisconsin, designing, manufacturing and marketing tilling and hole-drilling equipment and related products.
If the rotary tiller still doesn`t start:

Check that the fuel tank isn`t empty: if necessary, add fuel. The fuel must be fresh, of good quality and clean: make sure that no dirt, water or incompatible fuel (such as petrol-oil mixture, if the engine is a 4-stroke) gets into the tank.

Soil Problems

The problem with your tiller`s digging power may not be with the machine; it could be the soil. When soil is dry and compacted, tiller tines basically bounce off it without digging into it or turning it. Combat compaction by watering the area thoroughly one or two days before you till.

IMPORTANT NOTE: Using an undersized cord, a larger number cord gauge (AWG) than recommended in the chart, will cause a loss in power and overheating of the tiller.
Lean Air/Fuel Mix

Your automobile needs air and fuel to start and run and it`s the carburetor`s job to mix it. If there is too much air in the mixture, the engine isn`t getting enough gas and can stall. A mixture that is high on air and low on fuel is called a “lean” mixture, and it will affect your engine performance.

You should change your tiller oil at least every spring, but ideally after every 50 hours of operation. Between oil changes, check your oil level before each use to ensure there`s enough oil present. Small amounts of oil may burn off during use, so you may need to occasionally top it off.
The Viper engine is a high-performance naturally-aspirated pushrod 2 valves-per-cylinder 90° V10 engine designed by Chrysler but with aluminum block castings designed by Lamborghini for use in the Dodge Viper. Despite its large displacement, it is based on the Chrysler LA V8.
Throughout five generations of developing and producing the Dodge Viper V10 engine, the horsepower output keeps increasing – and we aren`t mad about it. The first generation of V10 engine from 1992 gave us around 400 horsepower. The second generation saw a bit of a boost, gaining 50 extra horses.
Earthquake, the lawn and garden division of Ardisam™, started in 1960 in a small metal fabricating shop in the town of Cumberland, Wisconsin.
Merry Tiller | Mackissic – Tillers Made in the USA.
Tillers are more powerful than cultivators and have larger, heavy-duty tines that work the soil. Front-tine tillers can perform general garden maintenance such as weeding, soil preparation and composting in small or medium gardens.
How long do electric tillers last? Usually, cordless tillers can run for about 30 to 45 minutes per charge. However, certain factors can affect this, such as if you are working with hard, compacted soil, the battery will drain more quickly.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Engin runs fine at idle but stalls out at high idle and wont rev up.
ANSWER : Hi 5flash… Get an assistant and a can of starter fluid. Remove the air cleaner and spray some starter fluid into the air intake. Start it up and spray the starter fluid as you move it to high idle, repeat until it works properly. Joe

Thanks for choosing Fixya!

Read Full Q/A … : Inc Earthquake Mini Cultivator

My mantis tiller with a honda gx22 engine starts then shuts off after approx. 30 sec.
ANSWER : If your unit has a primer bulb, start your engine . When it starts to die push your primer, if the engine comes back to life you have a carb issue.

Read Full Q/A … : Inc Earthquake Mini Cultivator

After a few weeks of no use, my tiller started on the first or second pull but even after long warm up, it stalled as soon as I trottled up. This happens even on the stand with no resistance/load. The machine is not jammed–the tiller blades turn while the machine is idling. It just dies as soon as I try to work.
ANSWER : Hi there,Sometimes the gas filter in the gas tank gets plugged. Here are some instructions that will help. Thank You for choosing and good luck.

Read Full Q/A … : Inc Earthquake Mini Cultivator

Does not run, will start with starting fluid – Mantis 2-Cycle Tiller
ANSWER : You should never use starting fluid on this model.

Add a couple of ounces of 100% acetone (available at Walmart) to some fresh fuel. Attempt to start for several pulls. Let sit for several minutes and repeat until it sounds like it wants to run.

Then watch this video and do it:

Read Full Q/A … : Inc Earthquake Mini Cultivator

Earthquake tiller viper 43cc engine will not start
ANSWER : I have the same issue, I thought it was the carburetor so I cleaned it and put it back together, same issue, I put a new carburetor on it same issue, has great spark, if I spray carb cleaner into it, it will start and run for a few seconds even throttle up, but then it dies, and will not start again without carb cleaner spray, and fuel is fresh and properly mixed, very confusing indeed.

Read Full Q/A … : Inc Earthquake Mini Cultivator

Engine will crank with starting fluid, but dies.
ANSWER : Have you checked the spark plug and see if its clean and also check the fuel line and carburetor for clogs. And you can also check the air filter.

Hope you find this helpful.

Read Full Q/A … : Inc Earthquake Mini Cultivator

Tines continue to work with out touching safety or throttle. they engage as soon as I start the engine.
ANSWER : Remove H (high) L (low) plastic caps to allow you to further adjust the flow and you will be going. H (red) further out about 11 threads exposed and L (low) about 8 exposed; adjusting the low side will stop the tines, but remove tines before making any adjustments, thanks

Read Full Q/A … : Inc Earthquake Mini Cultivator

My Mantis Tiller won’t start and there is grinding type noise when I try and start it. I recently did some very lengthy trench digging over a period of about 2 months.
ANSWER : It sounds like the clutch springs may be overheated and the clutch shoes rub while you try to start it.If you loosten the screw that holds the engine to the gear box you can try to start it without the clutch and see if that is it.Good luck

Read Full Q/A … : Inc Earthquake Mini Cultivator