Craftsman

I lost my owers manual and want to make sure I’m using the right oil and gas to oil mixture ratio. I haven’t been able to find it online. Thanks.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Most models require a 40:1 ratio. To achieve that mix, add a 3.2 oz. bottle of 2-cycle oil to each gallon of gasoline.
According to Craftsman, the proper fuel mixture ratio for this blower is 40:1.
A: The fuel-oil mixture ratio is 40:1. You can obtain this ratio by mixing 3.2 oz. of two cycle air cooled engine oil with one gallon of regular gas. Over a period of time oil will separate from gasoline.
Use a 40:1 two-cycle oil mix ratio. One gallon of gasoline combined with 3.2 oz of two-cycle engine oil. Unsure of the age of your equipment?
50:1 (2%) fuel / oil mix ratio is recommended with the use of genuine Husqvarna two-stroke oil for best performance.
For a 50:1 ratio of gas to oil, use 2.6 fluid ounces of oil per gallon of gas. For a 40:1 mixture, use 3.2 fluid ounces of oil per gallon of gas.
A: Yes, simply pour it into the gas tanks of 2 cycle engines. I use it in a chainsaw, blower, and weed wacker.
MTD two-cycle snow throwers use a 50:1 ratio of gasoline to 2-cycle oil, which is one gallon of gasoline to 2.5 oz of 2-cycle oil.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Do you mix gas and oil in this trimmer – Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer
ANSWER : Yes. Verifythe ratio, either 40:1 or 50:1

Read Full Q/A … : Craftsman

Oil to gas ratio – RTO Echo Pb-755 Backpack Blower In Box
ANSWER : The ratio is 50:1. You can usually by oil in a container that matches the size of your gas can, takes the guess work out of it.

Read Full Q/A … : Craftsman

What type of oil goes in the Ryobi 08570 Blower? What is the oil gas mix ratio?
ANSWER : You need 2 stroke motor oil or chain saw oil.Mix it according to the lable to make up 50:1 oil/gas mix.

Read Full Q/A … : Craftsman

Need gas mix solution – Craftsman 25cc 2-Cycle Gas Blower/Vac
ANSWER : Check age of gas. Cannot be more than 30 days old.

Make sure to use fresh gas w/synthetic 2-cycle oil @ 40:1 ratio
(1 gal.) Gas to 3.2 oz. Oil).Do not use old or stale oil/gas mixture. Always
use the proper oil/gas mix. If you do not, your engine will suffer rapid,
permanent damage.

Read Full Q/A … : Craftsman

Do I need gas and oil mix – Poulan Super 250a Chainsaw Plate
ANSWER : I think Poulan uses a 40:1 ratio to one gallon of gas, however I have always used 50:1 the same as my sthl saws with no issue. I would rather have more oil mix that to little.

Read Full Q/A … : Craftsman

What is ratio of oil in gas – Hitachi RB24EAP 23.9cc 2 Stroke 170 MPH Gas Powered Handheld Blower
ANSWER : Anywhere between 25:1 and 50:1

Read Full Q/A … : Craftsman

What is the oil and gas mixture ratio for a gas powered leaf blower?
ANSWER : Per http://www.echo-usa.com/faqs/ it 50:1, there is a chart at the site that shows how to mix it.

Read Full Q/A … : Craftsman

Blower starts and runs for 5 seconds and cuts off. Is it an oil to gas ratio. Is is 32:1 or 40:1? For the Echo PB250 gas blower.
ANSWER : I don’t think the oil-gas ratio will cause that problem. Did you check to see if the fuel lines or fuel filter is clogged?

Read Full Q/A … : Craftsman