gaged. Any adjustments?
Pony Garden Tiller
Experienced gardeners share their insights in answering this question :
Yes there is an adjustment. follow your shift lever down and you will find a block of iron with 2 bolts holding it. you will also see ond the lever itself a spring loaded pin.most of the time this pin gets gummed up and does not engage the block completely.clean and ensure the pin moves freely. if this does not solve the prob then the block can be moved up or down by loosening the bolts.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the engine for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Powered by a 250cc, 11.5 OHV Briggs & Stratton PowerBuilt™ engine, the Pony has the strength to break up hard-packed soil quickly and easily. Just One Hand™ operation allows the tiller to be guided with literally one hand thanks to a well-balanced and easy to control design.
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
Consider this: A typical 5-ft rotary tiller with four tines can be run by a 25-hp tractor and the same 5-ft rotary tiller with six tines would need a 31-hp tractor to operate the tiller at peak performance. A 40-hp requirement jumps to nearly 50 hp with six tines.
Powered by a Briggs & Stratton 140cc EX 550 Series™ Engine.
Troy-Bilt TB130 160-cc 21-in Push Gas Lawn Mower with Honda Engine in the Gas Push Lawn Mowers department at Lowes.com.
You might also be interested to know that Troy-Bilt has been manufacturing gas-powered yard equipment since 1937, and the company has a solid reputation for producing reliable small engines. In addition, all of these models come with a three-year warranty.
Disconnected, dirty or fouled spark plugs are common causes for engines that won`t start. For small engines, spark plugs typically need to be replaced every season or after 25 hours of use. You should also check to make sure the spark plug gap is set correctly.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
You should change your tiller oil at least every spring, but ideally after every 50 hours of operation. Between oil changes, check your oil level before each use to ensure there`s enough oil present. Small amounts of oil may burn off during use, so you may need to occasionally top it off.
IMPORTANT NOTE: Using an undersized cord, a larger number cord gauge (AWG) than recommended in the chart, will cause a loss in power and overheating of the tiller.
Hold the belt between finger and thumb at this point and move it from side to side. See how much it deflects at the centre of the run. If it moves more than 1/2 in. (13 mm) it is too slack – any less movement and it is too tight.
Slotted-link adjuster
The arm swings on a pivot bolt, and has a locking bolt through the slot – loosen both bolts and free the adjuster bolt locknut. Turn the adjuster bolt to tension the belt, then tighten the pivot and locking bolts, checking belt tension at each stage. Finally, tighten the adjuster bolt locknut.
Static balancing
Rotate the pulley by hand and let it come to rest on its own. Mark the point at the very bottom center of the pulley. Rotate it again and let it come to rest. If it stops with the same point at the bottom center, then its weight is not balanced – the pulley is heavier at that point.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die
By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die
By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.
If your lawn mower starts, runs for a while, then dies, check the ignition coil, gas cap, and spark plug. One or more of these parts could be causing your problem. Follow our repair and symptom guide to help you fix this.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die
By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.
If your lawn mower starts, runs for a while, then dies, check the ignition coil, gas cap, and spark plug. One or more of these parts could be causing your problem. Follow our repair and symptom guide to help you fix this.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Troy Bilt Pony s/n P92695 5Hp Briggs. Drive wheels won’t stay engaged. Lever jumps out. Can hold lever in with not much effort and will stay engaged. Any adjustments?
ANSWER : Yes there is an adjustment. follow your shift lever down and you will find a block of iron with 2 bolts holding it. you will also see ond the lever itself a spring loaded pin.most of the time this pin gets gummed up and does not engage the block completely.clean and ensure the pin moves freely. if this does not solve the prob then the block can be moved up or down by loosening the bolts.
Read Full Q/A … : Pony Garden Tiller
I have a troy bilt pony and the drive belt to engage to blades keeps coming off. I have replaced the belt and the pully what else could it be?
ANSWER : Well i would take a long look at the spring which holds the tension pulley in place. if it is weak, or not connected correctly, there will be inadequate tension and the belt can come off. I would also take a look at whatever fasteners keep the deck in place as if it is not kept to the rear, there again will be too much play in the deck belt.
Read Full Q/A … : Pony Garden Tiller
Troy tiller won't crank – Troy-Bilt Pony Garden Tiller
ANSWER : Is it electric start or manual pull?? remove pulg and see if it cranks over. Could be mouse nest under recoil cover or under flywheel, could be rusted to the magnets. need more info. Oh yea make sure belts are not holding you back remove them or make sure they are loose.
Read Full Q/A … : Pony Garden Tiller
Troy-bilt tiller The tires will not move freely when I attempt to move the tiller. The tiller will rotate the tires when engaged and move forward. Also, I am able to reverse the tiller and the tires will rotate to move the tiller backwards. When the tiller is shut off the tires will not move.
ANSWER : The only way to roll around is to remove the pins on the axle and slide the wheels in and replace the pins. If this has never been done sometime its rather hard to do. Hope this will help
Read Full Q/A … : Pony Garden Tiller
Pony wont start. i have replaced gas, cleaned carb, replaced plug. it will turn over but wont start. getting gas and fire.
ANSWER : Look to see if there is any trash under the seat.there is a safety device and if it is not making contact it will not start.try to put the mower in forward and engage the blades,while not running.push on the mower a few times then try to start it again,
Read Full Q/A … : Pony Garden Tiller
Troy Bilt Rear tine tiller model 643 Bronco, won’t start,it ran out of gas, put in new gas and it started but wouldn’t stay running. Put in new spark plugs, cleaned filters, changed out gas,still won’t start
ANSWER : Did it run out of gas when you added gas it could be that the fuel line has plugged up with something from the bottom of the tank take the fuel line off and try blowing threw it and take a air hose and blow out the carb and carb cleaner
Read Full Q/A … : Pony Garden Tiller
I need to tighten the drive belt between the engine and transmission on my Troy-Bilt 3312 GRS lawn tractor
ANSWER : I REPLACE THE DRIVE BELT AND THE MOWER STILL WON’T MOVE
Read Full Q/A … : Pony Garden Tiller
I have a Troy built front wheel drive mower made in 5/94, model # 34022 with a 6 speed trnsmission. When I put it in gear the wheels barely turn. How do I fix it?
ANSWER : It sounds like you need a new belt for the front wheels.
Read Full Q/A … : Pony Garden Tiller
