Bilt 175HP Manual 42″ Riding Mower

Yesterday, as I was mowing, the steering was stiff either way it was turned. If I made a deep turn, the steering would make a “pop” sound. After a short time of mowing, approx. half and hour, and lots of turns, the steering stopped turning left. It still turns right just fine. When you try to go left, the steering wheel just spins and the wheels stay straight. Can someone please tell me where to begin in trying to fix this problem?? I have the manual, I just don't know where to begin. Thanks so very much.
Experienced gardeners share their insights in answering this question :
Hi, mam i want to solve this prolem try contact or text this number 0927642929 / ( 032) 5127262

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
Please make sure your tires are properly inflated. Then look along the steering shaft for a grease fitting, and grease the shaft. Check for any worn guides or bushings along the steering shaft.
A dirty carburetor is one of the most common causes for a lawn mower not being able to start after sitting unused for months or years at a time.
The most common cause for the engine not turning over is simply the battery. Either the battery itself is dead, the terminals are corroded so the current can`t travel through them, or the battery cables themselves are damaged. Inspect your battery terminals and cables, and test the battery.
Check the fuse

The fuse on most riding mowers is connected to the small red wire that connects to the starter solenoid post. Check the fuse and replace it if it`s blown. If you replace the fuse and it continues to blow, you`ll need to find the short in the wiring or component that`s causing the fuse to blow.

A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
A clogged fuel filter is most commonly caused by leaving old fuel in the lawn mower. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and make the engine hard to start.
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel.

If your tractor cranks, but won`t start, you`ll want to look at a few different engine components. Is the fuel making it to the cylinder? Check the fuel level, the shutoff valve, and the fuel filter. If those components look ok, air might not be making it to the cylinder.
You hear a single click

Usually, this points to a faulty relay or solenoid, or a bad or jammed starter motor. Solution: Rock your car back and forth or tap the starter motor with a hammer and try starting the engine again. If this works, you are good to go!

Place a large bar in the flywheel and gently rock back and forth to loosen. If this doesn`t work – or if you are uncomfortable with placing a pry bar in the flywheel – try putting the tractor in a high gear and rocking the rear tires back and forth. Once the flywheel is loosened, do a quick tune-up on the carburetor.
Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced. If the starter motor does not run, the motor itself is probably defective.
A clogged fuel filter is most commonly caused by leaving old fuel in the lawn mower. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and make the engine hard to start.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

Use Carburetor Cleaner

Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Starts then dies – Troy Bilt 5.5hp Self Propelled Mower
ANSWER : Check oil level. all mowers have oil level cutoff. 30w oil. Remove air cleaner, try to start. Replace filter if dirty.

I need to tighten the drive belt between the engine and transmission on my Troy-Bilt 3312 GRS lawn tractor
ANSWER : I REPLACE THE DRIVE BELT AND THE MOWER STILL WON’T MOVE

How do I change the oil on my Troy – Bilt squall 5521 ? Which oli weight do I use ?
ANSWER : There should be a plug at the end of the oil fill tube or its under the mower by the blade.clean the bottom of the motor and you will find a plug with a square head that a 3/8 drive rachet and extension will fit into.summer time use sae-30.

I have replace the entire fuel system and new gas, it was running fine until today. It died and won’t restart what could be the problem??
ANSWER : If you have no spark then the coil failed a bad spsrk plug would just cause a week spark not no spark

Troy bilt mower not idling very much…
ANSWER : Turn the high screw on the carb to the left just a little

When I turn the key on to start my Troy-Bilt RZT 50 zero turn mower, there is nothing. No ignition light, nothing. I have a new battery and I put a new fuse unit but still nothing. Help!
ANSWER : Do you hear a clicking sound???NO ?? Do you have the speed ?turning handles in the extrem OUT position? Is the ground cable connected to the engine block?? Is the Red cable connected to the + Positive post on the battery?? Is the BLACK cable connected to the – Negetive post on the battery?? Why did you need to replace the fuse? Is the battery charged??

If none of the above corrects the problem replace the ignition switch

Our Troy bilt lawn tractor wont start. It seems like a short
ANSWER : Hit some thick grass and smoke bellowed out as it stalled,started it again and ran fine changed oil and now it just turns slightly at ignition

NEED A DIAGRAM OF HOW TO ROUTE A BELT ON A TROY BILT RIDING LAWN MOWER (DECK BELT) NOT DRIVE BELT. THANKS
ANSWER : Type in your model number to your search engine. find your model and the diagrams will be there.
hope this helps.