Doesnt run right
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Over time, the spark arrestor can become clogged with soot. If the spark arrestor is clogged, the chainsaw may run stall or run rough. To unclog the spark arrestor, remove it and clean it with a wire brush. You can also replace the spark arrestor.
If your STIHL chainsaw is going to have a problem, it`s likely to be with a worn carburetor, bad spark plugs, loose fuel hoses, or clogged fuel lines. You should also inspect the fuel intake system and ensure that there are no compression issues.
The fuel line may be clogged from stale fuel deposits, more reasons to cause your chainsaw to cut out when applying throttle. If a fuel line is cracked, it will leak gasoline and draw air from outside into the fuel line. If the line is leaking fuel, it needs to be replaced.
If your saw idles fine, and then bogs down when pressing the throttle, then adjust your `H` screw by unscrewing. This will increase the amount of fuel to the carburetor under load. If your saw idles fine, then runs lumpy with a lot of smoke when pressing the throttle, then adjust your `H` screw by screwing in.
What Causes Chain Saw Kickback? There are two circumstances that can cause kickback when using a chain saw. The first occurs when the moving chain at the tip or the nose of the guide bar strikes an object. The second situation is when the wood closes in, pinching the saw chain in the middle of the cut.
If the clutch pads are worn out, the motor will run, but the clutch pads will not engage the clutch drum. As a result, the chain won`t turn. Make sure that the stop lever is disengaged. If the stop lever is engaged, the chain won`t turn.
If you notice the blade is not turning, check the belt. Start by removing both side covers – depending on your model, one cover may be the recoil. If the belt is broken, it needs to be replaced. From here, release the tension on the belt by turning the nut counter clockwise until it stops.
If your chainsaw does not start, the fuel may be too hot. To prevent this from happening, always use fresh fuel and reduce your operating time when the weather is warm. If your chainsaw will not start, place it in a cool area away from sunlight for at least 20 minutes.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
How to replace a oiler on a stihl chainsaw ? – Stihl Service Manual for 031AV Chainsaw with Parts List
Remove the worm, sealing ring and washer, loosen the pan head screws on the oil pump and replace. Check if the gasket is re-usable.
I HAVE AN O17 STIHL CHAIN SAW AND IT LEAKS CHAIN OIL
EVEN WHEN IT IS NOT BEING USED
That can happen. When you go to store it, open the oil cap and then close it to lose the pressure the pump builds up inside.
Starter coil on stihl 017 – Stihl 017 018 Ms170 Ms180 Chainsaw Starter Stbx759
If you are asking for the part number, it is 1130 400 1302 if you have two ground wires and one lead wire. If you only have one ground wire and one lead wire, the part number is 1130 400 1300.
Is there supposed to be a cyntrifical clutch on a stihl 028 av super electronic quickstop?
Yes; see page 37 in your OM. You read it before using your saw right?
If you have more questions or need additional help please reply below and I will get back to you. Thank you for using FixYa and Good Luck. HTH
How to remove stihl 023 handle bar?
There are three mounting points. You need to remove the screws behind the plug caps with a T27 bit. Then, the tank should separate from the crankcase and you can pop the AV mount from the crankcase to replace it.
Find a manual for a stihl 015l chainsaw – Stihl Service Manual for 015, 015L Chainsaw Model 1116
What settings should i start off with on carb. @stihl 025
Screw the screw fully in but not tight then turn it out 3/4 of a turn
How to adjust chainsaw oiler on stihl MS230
You cant. the oiler on an Ms230 is preset and non adjustable. Make sure the oil worm gear isnt damaged