17.5 hp 42 in. Deck Lawn Tractor – CA Model
I was cutting the grass last night and the mower just stopped dead. I tryed to start it but no sound. It’s completely dead. I just bought a brand new Sears gold battery, so I know it’s not the battery. What else could I check? The mower only has 13 miles on it, but it did sit for 2 years. I had someone cut my grass for 2 years. I would appreciate any help.
Experienced gardeners share their insights in answering this question :
Clean and tighten all connections from the battery to the starter and selenoid connections too
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
First, check for a blown fuse because you can usually see a blown fuse just by looking at it. The fuse on most riding mowers is connected to the small red wire that connects to the starter solenoid post. Check the fuse and replace it if it`s blown.
Other things that could cause this issue are bad fuel, weak/colapsed/kinked fuel line, faulty spark plug, faulty ignition/coil, oil over full, clogged air filter, plugged/dirty carburetor, worn engine parts internal rings/valves/etc.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Lawn mower cranck but wont start…
Since you already checked for spark and air I would drain all the fuel out of it and check that fuel for water. Over time some lawn mowers end up with contaminated fuel. You can see the water sitting on the bottom of the fuel if you let it stand for a bit in a small plastic bowl.
Be sure to empty and dry out you fuel can as well. Especially if the mower stopped running right after a refuel. Which is a good sign your gas can is contaminated too.
I have had a poulan pro 550 series push mower for almost 1 year at the end of the season last year the mower would start briefly and then stop. i have cleaned out the air filter and that did not help.the mower started, i made one revolution around the yard 3/4th of the way the mower quit. I then primed the mower it started then quit and now it will not start at all. Does anyone have any suggestions of what to do. Thanks
There is a little spring that works the carburetor arm. If that popped off then the mower will not run.
I have a black and decker lawn mower which is electric and it suddenly stopped working. I checked the power cord and it seems to be fine. When I try to start the lawn mower, I hear the click sound but the mower does not start
Any ideas or suggestions is highly appreciated.
Took the mower to the Black and Decker warehouse where they replaced the switch in the handle. It cost $53.73 total.
I have a Poulan push mower that after mowing in a ditch started making a loud noise and running rough. It almost sounded as if metal was hitting metal. The mower was vibrating more than normal. I checked under the mower and nothing is hitting. After a few times of stopping the mower engine because it sound as if it is going to die down the mower will not start now. The shaft does not appear bent and the blade appears ok. The mower has oil, a good spark plug and a clean air filter. It was running fine until that moment. I did not see anything that I hit but it is possible I hit something in the ditch like a pine cone or branch. What could the problem be and how would I go about fixing it?
If you are sure the oil level is correct then it sounds like it’s about to die, unfortunately. A pine cone shouldn’t cause any damage, but a large branch may do so. Was it smoking before you shut it down? The vibration could be caused from a bent blade. It could also be caused from a part breaking in the motor. I wish I could have given you better news!
Mower start up and runs, but starts to cut back, and smokes just a little bit. The mower stops smoking when it throttle up. It will continue to run but not at full throttle. I can hold a finger gently over the fuel primer bulb and it will throttle up for a small time.
It sounds like she’s being deprived of the correct fuel / air mixture due to a dirty carburetor (the biggest problem with mowers when gas is left to sit for a period of time). If you do not know how to take the carburetor apart and clean it thoroughly, then I suggest taking it to the local shop (hardware store or mower shop) and having it tuned up. It’ll probably be just fine and worth the money. Hope this helps and good luck.James
I have a problem with a Black and Decker electric lawn mower model MM525. While cutting some high grass today, the mower slowed down, then quit and would not restart. I checked the electrical outlet and there was no power–the fuse was burned out in the switch box. I replaced it, tried again, and again it would not start or even give any response at all, but again it blew out the fuse in the box. The fuse is 25A and the mower is only 12A so that’s not an issue, besides, I’ve used this mower from that outlet for about 4 years since I first got the mower and never had any problem before. My question is: is whatever is causing the mower not to start and to blow out my fuse something that can be repaired or should be? Thanks.
I can think of only one or two things that are causing your problems. It could either be approx. a $14.00 switch in the handle that has shorted out, or 2 bad brushes $1.75/ea.on the armature (motor). Both are fairly simple fixes with just a screwdriver and maybe pliers. You might also check and see if the power cord has been chafed or damaged and is shorting out. See below for parts:http://email@example.com
Lawn mower motor runs good, the drive wheels run good but the blade won’t stay enguaged. Thanks
Check your cable that controls the blade engagement.
I have trouble starting a toro walk behind mower
All, I thought my carb was shot, so I replaced it. Still, start but no run (and had to use starting fluid). THEN!!! I noticed the spring to the “rev limiter” (just below and towards rear of carb) was not “tight”. The stupid bracket that holds the end of that spring had been bent down ~1/16″ and that caused all this heartache. CHECK YOUR REV LIMITER!!!