Riding Lawn Mower 46 Cut Kohler Yth21k46

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A hydraulic jack takes a lot of the work out of lifting a heavy item, such as a riding lawn mower. However, a jack must be positioned properly or the lawn mower risks crashing down. This not only damages the mower but can cause you severe injury.
For most effective results, a lawn mower deck should have a pitch, or height difference of 1/8-inch to 1/2-inch between the front of the deck to the back of the deck. Naturally, this makes the sweet spot about 1/4-inch of pitch, depending on the mower model.
Tire Inflation

Front tires that are too low or rear tires that are overinflated can cause the appearance of a poorly adjusted mower deck. Always check and fill tires with the mower turned off and parked on a flat, level surface.

Insert an adjustable wrench on one of the lift-link adjustment nuts behind the driver`s seat. A lift-link adjustment nut is on each side of the mower. Turning the nuts counterclockwise lowers the deck, and turning them clockwise raises the deck.
For most effective results, a lawn mower deck should have a pitch, or height difference of 1/8-inch to 1/2-inch between the front of the deck to the back of the deck. Naturally, this makes the sweet spot about 1/4-inch of pitch, depending on the mower model.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I have a problem leveling my mower deck. I level it at the sides and front .I use the mower and it cuts uneven. mower is deck is out of alignment. less than 1 hour on it.
ANSWER : The deck could be bent, or you will probably have to level the back of the deck as well. Another thing to check is the air in the tires, this can cause an uneven cut. Although the tire may look pumped up, with the weight of a person on the tractor can cause an uneven cut.

I have a problem with a Black and Decker electric lawn mower model MM525. While cutting some high grass today, the mower slowed down, then quit and would not restart. I checked the electrical outlet and there was no power–the fuse was burned out in the switch box. I replaced it, tried again, and again it would not start or even give any response at all, but again it blew out the fuse in the box. The fuse is 25A and the mower is only 12A so that’s not an issue, besides, I’ve used this mower from that outlet for about 4 years since I first got the mower and never had any problem before. My question is: is whatever is causing the mower not to start and to blow out my fuse something that can be repaired or should be? Thanks.
ANSWER : Hello blumph,
I can think of only one or two things that are causing your problems. It could either be approx. a $14.00 switch in the handle that has shorted out, or 2 bad brushes $1.75/ea.on the armature (motor). Both are fairly simple fixes with just a screwdriver and maybe pliers. You might also check and see if the power cord has been chafed or damaged and is shorting out. See below for parts:http://www.ereplacementparts.com/black-and-decker-mm575-electric-lawnhogtrade-mulching-mower-parts-c-4167_9514_9550.htmlyurcarguyken@yahoo.com

How to adjust the mowing deck properly? – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : I use a string level just sit it on deck level front to back

My front two wheels on my toro lawn mower will not move, and when I pull the handle up for self-propel, the wheels still don’t move and the mower makes a funny noise. Any ideas?
ANSWER : Look to see if the belt can off or broke… good luck.

What causes JD 260 riding mower to start dying when you engage the mower deck? It runs fine when you disengage the mower deck.
ANSWER : It’s the safety system that causes this. There is a switch under the seat that should activate when you are sitting in the seat. The switch can come loose or fail, the mounting can break, or the wires can come loose – any of these would cause the “engine dies when I engage the mower deck” behavior. Lift the seat, examine the switch. Rmove the switch and keep the plunger in with a piece of tape. Fixed? Then it’s just the mounting or adjustment. Not fixed? It’s the switch itself or the wires or connectors to it.

It is idling too fast and has a terrible vibration
ANSWER : The idle can be adjusted by moving, either left or right, a small lever in the front of the engine. The vibration is most probably caused by a lose or damaged blade or and excessive build-up of clipping under the deck.

Lawn mower cranck but wont start…
ANSWER : Since you already checked for spark and air I would drain all the fuel out of it and check that fuel for water. Over time some lawn mowers end up with contaminated fuel. You can see the water sitting on the bottom of the fuel if you let it stand for a bit in a small plastic bowl.

Be sure to empty and dry out you fuel can as well. Especially if the mower stopped running right after a refuel. Which is a good sign your gas can is contaminated too.

I have had a poulan pro 550 series push mower for almost 1 year at the end of the season last year the mower would start briefly and then stop. i have cleaned out the air filter and that did not help.the mower started, i made one revolution around the yard 3/4th of the way the mower quit. I then primed the mower it started then quit and now it will not start at all. Does anyone have any suggestions of what to do. Thanks
ANSWER : There is a little spring that works the carburetor arm. If that popped off then the mower will not run.