Garden

Experienced gardeners share their insights in answering this question :
Fuel delivery most likely? a test is a little gas on the air filter see if it runs a little longer. That will confirm fuel delivery issue. But don’t get the gas on any hot parts!

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If your lawnmower is starting and then stalling, the most likely issue is the carburetor. The most common issue is that the carburetor is dirty. Here`s what you need to know about how a dirty carburetor can cause a lawnmower to start, then stall out and die.
Electric lawnmowers may cut out for two main reasons: A faulty power switch or a loose cable connection. An overheating motor can cause the thermal cut out to trip.
If your lawn mower starts, runs for a while, then dies, check the ignition coil, gas cap, and spark plug. One or more of these parts could be causing your problem. Follow our repair and symptom guide to help you fix this.
The problem may be in the recoil starter itself. A tangled coil of rope or a broken spring may be the problem. In many cases the recoil starter is easily replaced as a single assembly. DO NOT attempt do take the starter apart.
The most likely culprit is a dirty or clogged air filter. Issues with your fuel pump or fuel filter can also cause your engine to idle then die with any throttle. If you have an older car, it could also be a bad carburetor.
Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
Use Carburetor Cleaner

Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.

Mower Gas Cap

If the tank is sealed, the fuel becomes air locked, and the mower stalls. This typically happens after a short period between ten and thirty minutes and also depends on factors like weather and gas tank fuel level.

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the engine for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
The spark plugs are worn or damaged

If you find that your lawnmower keeps dying, or keeps stalling while cutting grass, then inspect the spark plugs. Look for signs of damage or wear. Something as simple as a cracked porcelain insulator can mean an electrode has been damaged or burned away.

Use Carburetor Cleaner

Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Troy Bilt Lawn Mower pull Cord broken
ANSWER : There should be four bolts holding the cover on that houses the pull cord assembly take the bolts out look inside you should see the rest of the broken cord at the other end there is a spool that the cord rolls up in to pull the cord until it stops the other end of the cord is a not in the cord pull on the knot the broken peice should come out turn the spool 2 times in the direction that is against the pressre while holding the spool in place feed the new cord in through the whole that you pulled the broken cord out of then tie the cord in a knot wind the rest of the cord up then feed the other end of the cord through the new pull handle tie the cord in a knot put the housing back on

Read Full Q/A … : Garden

Pull cord is difficult to pull after third pull becomes stuck but will turn if pull hard repeats every three to four pulls.
ANSWER : No response to clarification request.

Read Full Q/A … : Garden

Why is small engine pull cord stuck? cannnot start lawnmower
ANSWER : The recoil starter is broken and needs to be repaired.

Read Full Q/A … : Garden

How do I replace broken pull start cord? – RTO Toro Lawn Boy 21in Insight Series Steel Deck Mower
ANSWER : There are screws holding the top of the mower on, you should be able to remove those and lift them to get access to the cord. From there it is easy. just put new cord back the opposite of the way you removed it, making sure that you get it wrapped the correct direction. you can get a cord anywhere they sell mowers.

Read Full Q/A … : Garden

What to do when craftsman mower pull cord won’t recoil?
ANSWER : Sounds like the spring inside the recoil has either broken or let go so it won’t recoil. If you are lucky it could be the wheel that the cord goes on is seized or stuck. You can take the recoil off most mowers by taking out two or three screws and lifting it off the engine. They can be repaired but it takes time having to be careful the spring won’t spin and hurt you. I have even taken a recoil off another engine and if the holes for the little screws don’t line up just drill little holes beside the old ones and reinstall the little screws.
I even used a 18 volt cordless drill to crank the engine using the bolt on the fly wheel and the right size socket. Leaving the recoil off You have an electric start that way.

Read Full Q/A … : Garden

The pull cord on my ZR29550 string trimmer is stuck in the fully retracted position. I can’t pull it to start the machine. Also the electric starter can’t turn it over.
ANSWER : Well its not going to start with electric because the cord is out of it…
just take it apart becareful do not pull the recoil out or your in a mess….
but this should help you out if you need to know more just ask…

Read Full Q/A … : Garden

The pull cord will not recoil. what do i do? the spring behind the cord was just assembled and went to pull it and it wont recoil the pull cord.
ANSWER : It needs a pre-tension. At about 1 minute and 22 seconds it is explained clearly here:
SmallEng.com

Good Luck
Lou

Read Full Q/A … : Garden

Starter cord pulled out of the housing, it
ANSWER : If it’s new take it back should have a one year warrenty on it if yo can’t get it done for free get back to me so I can help you you may have a damaged windind head.

Read Full Q/A … : Garden