Mighty Lite Lawn Trimmer

How do i get to the pull starter to rewind it. for it is all out.????
Experienced gardeners share their insights in answering this question :
Disconnect throttle cable from carb lever. remove about 5 black star bit screws from front of housing. engine will slip back out. swing to side to get to the spool, or remove the two kill switch blades from their posts to totally remove engine out of way.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The most common reason for the cord refusing to rewind is a broken or worn out recoil spring. This tiny spring hooks onto the pulley and is stretched out when you pull the cord; when you let go the spring is meant to snap back to its original position.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

The pull cord on my ZR29550 string trimmer is stuck in the fully retracted position. I can’t pull it to start the machine. Also the electric starter can’t turn it over.
ANSWER : Well its not going to start with electric because the cord is out of it…
just take it apart becareful do not pull the recoil out or your in a mess….
but this should help you out if you need to know more just ask…

Read Full Q/A … : Mighty Lite Lawn Trimmer

Starter cord has jammed – Ryobi 30cc 17" String Trimmer Zrry30530 Wcurve Shaft
ANSWER : You will have to remove the starter rewind mechanism and rewind the cord around the pulley, then pre- load a certain amount of tension on the rewind spring.

Read Full Q/A … : Mighty Lite Lawn Trimmer

String stuck out and cant get cover off to rewind it.
ANSWER : Disconnect throttle cable from carb lever. remove about 5 black star bit screws from front of housing. engine will slip back out. swing to side to get to the spool, or remove the two kill switch blades from their posts to totally remove engine out of way.

Read Full Q/A … : Mighty Lite Lawn Trimmer

Pull cord will not pull out for model 358.794765 on craftsman blower/vac
ANSWER : You may have blown your engine. try to move the piston up or down when you take off the spark plug. if it does not move you may have broken a piston ring and the piston may be stuck because of the broken ring. you can also try to check the starter string where it is coiled in the spool. it may be just tangle up. remove the casing and check the string off of the engine.

Read Full Q/A … : Mighty Lite Lawn Trimmer

Won’t start. on/off switch stuck, choke won’t engage.
ANSWER : Take off the on/off switch, locate spring underneath and find where it’s hitting. Shave the plastic part where it’s sticking (I just used a flat head screwdriver) & it’ll work just fine. Just started mine up and it runs like a champ. Very cheap (free) & easy fix.

Read Full Q/A … : Mighty Lite Lawn Trimmer

I can pull my string from a ryobi cs 30 and it wont go back
ANSWER : Either the rewind spring is broken or the starting spool is stripped. Either way you have to open up the entire unit. Check those two things and good luck…Lee

Read Full Q/A … : Mighty Lite Lawn Trimmer

Coil My string Husqvarna 128CD trimmer quit working. Think it is getting enough fuel. Think it is the coil. how do i replace the coil.
ANSWER : Here is a link you the IPL, shows complete brakedown od machine.

Read Full Q/A … : Mighty Lite Lawn Trimmer

Husky 435 chain brake is stuck in “locked” position with clutch cover off. How do I release the brake, so the cover will fit over the flywheel?
ANSWER : Hi, grab the cover in a vise in the same place the bar nuts tighten up to. Then pull the chainbrake lever back towards where the handle bar would normally be until it clicks and locks back. This will require a bit of force. Then refit the cover as normal. Hope this helps, regards Phil.

Read Full Q/A … : Mighty Lite Lawn Trimmer