Craftsman
Experienced gardeners share their insights in answering this question :
I\’d try to loosen the Gas cap and see if that helps.. Sometimes the Gas Tank Vent Clogs and the engine can\’t suck gas after it has created a vacuum in the gas tank.Or the carburetor is slightly clogged and gas is not filling the Bowl fast enough. It runs out of gas and then slowly fills again. The Carb may need to be cleaned. Todays Ethanol gas is VERY bad for anything with a carburetor. Tell your Congressman to Vote to bring back \’Real\’ gas.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
If your lawnmower is starting and then stalling, the most likely issue is the carburetor. The most common issue is that the carburetor is dirty. Here`s what you need to know about how a dirty carburetor can cause a lawnmower to start, then stall out and die.
If your lawn mower starts, runs for a while, then dies, check the ignition coil, gas cap, and spark plug. One or more of these parts could be causing your problem. Follow our repair and symptom guide to help you fix this.
The most common cause of a mower that runs for thirty minutes and then dies is a faulty armature. A faulty gas cap is the second most likely cause.
Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that`s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
The most common reason your car starts then dies immediately is because of a lack of fuel in the engine. This often happens because there is a small amount of fuel in the fuel rail, which helps to start the engine. However, there is no fuel pressure to keep the engine running.
Clogged or Dirty Air Filters
It is one of the most common problems that cause lawnmowers to sputter. The mowers take the air from the surrounding through air filters and mix it with fuel inside the engine. So, if the air filter is clogged or dirty, it will affect the flow of air into the carburetor.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
It’s brand new, when I finally get it started it will run good for about 1 min. or less, and then it dies. I pull the choke out all the way, pull it a couple of times, push it half way in, it starts but it’s like it doesn’t have the power to turn the chain, bogging out and then it dies, I will never buy another homelite product, or recommend anyone else to, this is my second one, the first one leaked gas, Home Depot really should quit selling them, there making you look bad too!!
ANSWER : Hi paulbonser… Set your point gap to .20 using a feeler gauge… You can also use a paper matchbook cover, it ia approx. .20 to set the gap on the points. Please take time tor rate me
Read Full Q/A … : Craftsman
My Z5426 won’t start. When I pull out the choke and turn the key, gas starts leaking out of the exhaust system just before it gets to the muffler. Last time it did start, it ran really rough. So, I turn off the engine and then tried to restart and that’s when I noticed the fuel leak.
ANSWER : Maybe bad fuel, fuel line leaking, flooding of the carburetor, since it did start and ran rough I am assuming that the gas was left set and more then likely this gummed up the carburetor, you will have to clean/rebuild it. If you have a can of carburetor clean you may be able to spray that into there and clean it up, I would not choke it to start it as it sounds like it got/is flooded/ing. Good Luck Tim
Read Full Q/A … : Craftsman
Will only start and run in choked position, when throttle applied chokes out. If started with out choke and throttle position in low speed will start and run for 10 sec then like it runs out of gas.
ANSWER : I have your solution guaranteed, I fixed mine yesturday remove H L screw plastic caps and on high 11 threads exposed and on the low side 8 threads exposed. removing the plastic caps allows u further adjusting these wear out or move soo just take them things off and you will be rolling
Read Full Q/A … : Craftsman
Does not run, will start with starting fluid – Mantis 2-Cycle Tiller
ANSWER : You should never use starting fluid on this model.
Add a couple of ounces of 100% acetone (available at Walmart) to some fresh fuel. Attempt to start for several pulls. Let sit for several minutes and repeat until it sounds like it wants to run.
Then watch this video and do it:
http://www.alamia.us/mantis_parts_s/148.htm
Read Full Q/A … : Craftsman
It won’t stay running. have cleaned the gas tank and it just had a tune up. runs fine then gets rough and quits. If I push the bulb it smooths out and runs fine for a couple of minutes and then begins hesitating again. Now today it ran for about 15 min. and now it won’t start. It wants to. runs for a couple of seconds 5-10 and then quits.
ANSWER : Remove the float bowl and empty the contents out clean and replace
Read Full Q/A … : Craftsman
Weed eater starts but won't stay running – Weedeater 19 in 25cc Gas Hedge Trimmer
ANSWER : Probably “gum” and “varnish” build-up clogging the TINY passages [called ‘galleries”] inside the carb!
Read Full Q/A … : Craftsman
Saw starts, runs fine for short time( 2 min) then quits like runs out of gas. I blew out all lines and filter,didn’t help.
ANSWER : Your jets are out of whack on your carb I think. Try bringing it to someone who knows how to adjust them.
Read Full Q/A … : Craftsman
Key will not work on ignition.
ANSWER : It has and oil safty switch on it you will have to push it to some flat ground to start it you will have to wait to start it let the oil settle down to level dont leave lawn mower on a hill it will happen every time
Read Full Q/A … : Craftsman
