Lawn Mower With Toro Power Tools

My toro self drive mower slips in &out of drive
Experienced gardeners share their insights in answering this question :
Check the belt under the mower. It runs from the shaft that the blade is on, to a little gear box. Sounds like it may be worn out.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Common causes of intermittent stalling may include a bad idle speed control (ISC) system, low fuel pressure, loss of ignition, vacuum or EGR leaks, or other problems we`ll get to later in this article.
Push the knobs until they are loose. Move the handle to the upper or lower height position. Pull the knobs until the square edges of each carriage bolt fits into its related square hole. Tighten the handle knobs as tight as you can.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Is the rubber on the drive wheel on the snapper mower fixed to the metal hub? The rubber wheel part of the drive is not securely attached to the metal frame and slips when the mower goes up hill. Should I replace the drive wheel?
ANSWER : Yes, it may have gotten excessive oil on it and swelled the rubber. Replace the drive wheel.

How to change drive belt – Huskee Tractor Replacement Riding Lawn Mower 42" Deck Mulching Kit fits Huske
ANSWER : Step 1 – Loosen tension and remove belt. Locate the adjustment fastener and loosen it. …
Step 2 – Inspect drive and drive pulleys. Check the drive and pulley wheels. …
Step 3 – Select correct replacement belt. …
Step 4 – Install V-belt. …
Step 5 – Correctly tension new belt. …
Step 6 – Start the engine.

Replacing drive and auger belts on a John Deere 1032 snowthrower
ANSWER : You don’t need to remove the any lever linkages but you will need to remove some of the pulleys.If you can give an exact model number of the tractor it would help.

Drive belt Have replace drive belt but mower still has no forward movement. Mower is only 2 years old but its already had to have another drive belt installed by the dealer last year. wanted to do it myself but when i install belt theres hardly any tension so mower doesnt move. Checked and rechecked the diagram and is installed correctly. Cant find a tensioner adjustment if it has one.
ANSWER : I don’t have an answer for you, but Do you have a diagram of the Drive Belt?

Drive belt popped off by limb i ran over need drive belt diagram
ANSWER : I’ve got a manual. Can I fax to you copy of diagram? Send your info to my fax no. 209-394-0868.

Need a diagram for craftsman 44″ riding mower drive belt. Mine threw belt and cannot locate original manual.
ANSWER : If you can find the model number of your mower, you should be able to find your manual here. I hope this helps.http://www.searspartsdirect.com/partsdirect/index.action

Wont blow the snow
ANSWER : Most of the time this is because of a worn belt or tensioner out of adjustment.

My self propelled mower doesn’t fully engauge
ANSWER : What usually causes this is called belt stretch, this happens due the weather and the heat from the engine