WON’T STATR
Garden

Experienced gardeners share their insights in answering this question :
A couple of questions first, when you replaced the plug, did you use a Champion RCJ6Y? When you changed the gas lines and filter, did you make sure you put the lines in the correct order (there are 2 lines, one is a supply the other is a return…the supply is usually a smaller diameter than the return and should connect to the bottom port of the carburetor), did you check the cap (there is a filter and a check valve in there, if faulty the cap needs to be replaced)…

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Incorrect fuel mixture can cause the Blower to not start or run roughly, make sure you are using the correct fuel mixture with your blower. Ryobi Blowers run off a 50:1 ratio, this means 50 parts unleaded fuel to 1 part 2-stroke oil. The choke being left on will cause your Blower to not run correctly and shut off.
First remove and reinsert the battery to ensure that it`s seated properly in the Blower. If this doesn`t work, check the battery charge level by pushing the battery indicator button. If the battery is low, stop and charge the battery before use.
The carburetor or fuel filter might be clogged.

First, check the carburetor to see what has happened. If it`s clogged, there are three options: clean the carburetor, rebuild it, or replace it entirely. If a clogged fuel filter is the source of the issue, you`ll likely need to replace it.

Check the spark plug

If your leaf blower runs on petrol and won`t start, the spark plug might be faulty. Typically it needs to be changed every year but can be done sooner with high usage. Start by unclipping and giving it a clean using plug-specific cleaner and a wire brush.

Blower motors are designed to circulate air, so they won`t work if there`s no air to move. You should always check the filters and vents surrounding the blower to make sure that the blower isn`t having a hard time working. Look into your air filter`s housing and check the markings on your filter.
If your blower is having a difficult time starting, then you may be dealing with a carburetor issue. The carburetor`s job is to ensure the proper mix of fuel and air is directed to the blower`s engine. As mentioned, the carburetor can become clogged, making it difficult for fuel and air to enter the engine.
If your leaf blower engine is lacking power, it could be due to a blocked air filter. A plugged air filter will restrict air flow into the engine, reducing power and performance. Changing the air filter is an easy fix, and should solve this issue.
To completely start over the game, including all challenge progress, go to Options > Misc > Hard reset. The same result can be achieved by deleting the save. dat file. This will also reset options, which you can preserve by copying options.
The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the leaf blower. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog the fuel filter and cause the engine to stall.
The fuel lines on your blower carry fuel from the tank to the engine. If these fuel lines are obstructed, it can`t allow the proper amount of fuel to enter the engine, which will cause it to run for a short time, but ultimately stall out. You may be able to clean out the fuel lines and solve this problem.
Dirty or Worn Spark Plug

Among the first things to check if your trimmer won`t start is the spark plug. In some cases, the spark plug may simply be dirty and need a thorough cleaning. To clean your spark plug, disconnect it and clean the area around it before removing it, advises Briggs and Stratton.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Do you mix gas and oil in this trimmer – Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer
ANSWER : Yes. Verifythe ratio, either 40:1 or 50:1

Read Full Q/A … : Garden

I have no spark on my ryobi 990r. i have replaced sparkplug. i have checked and have plenty of fuel
ANSWER : Make sure the gap on the plug isnot to wide other wise u will not get any spark or just a weak spark

Read Full Q/A … : Garden

Ryobi No Fire at spark plug – Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer
ANSWER : Have you checked just the plug wire for spark. If you’re not getting any here, then you may have a bad magnet-or. So if the spark is happening only at the wire and not through the plug. Change the plug. Also check the cut off switch. It could cause the no spark, to keep it from starting.

Read Full Q/A … : Garden

Ryobi gas blower 200mph 2 cycle what is the ration gas to oil
ANSWER : I mix mine 50:1

Read Full Q/A … : Garden

What type of oil goes in the Ryobi 08570 Blower? What is the oil gas mix ratio?
ANSWER : You need 2 stroke motor oil or chain saw oil.Mix it according to the lable to make up 50:1 oil/gas mix.

Read Full Q/A … : Garden

I have no spark on my Ryobi Brush Cutter. Replaced spark plug but still no spark.
ANSWER : If the spark plug you have put in has the correct gap then u will next have to check or change the HT lead Change it if no spark is showing

Read Full Q/A … : Garden

What is the spark plug gap for a ryobi string trimmer model # ry30550 ?
ANSWER : I can’t say for sure, but it’s PROBABLY about 0.035″.

Read Full Q/A … : Garden

Ryobi ry08576 Why do i have to pull 20+ times to finally get it started.Oil is seaping out of the muffler once it’s started. Is the problem the spark plug or my mixture of oil and gas?
ANSWER : Make sure your fuel is fresh and mix at 50:1
then remove the muffler and try to start it holding the throttle wide open… if it starts and runs fair suspect a flooded engine, plugged muffler
if not, suspect a carb adjustment issue and then a carb

Read Full Q/A … : Garden