42 In Deck 19 Hp Kohler Courage Twin Cam Zero Turn Mower

Experienced gardeners share their insights in answering this question :
Sounds like the coil is breaking down at high temperature. make sure the engine is not covered with grass clipping and dirt. replace the coil. i think this will solve your problem

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the engine for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
If your mower engine is a Honda or Kohler, the fix is simple. Honda and Kohler`s surging is commonly caused by a blocked idle jet see “Gas starvation” towards the end of the page.
Yes, Kohler makes good engines and is known for durability and performance. It`s easy to operate and has various features depending on your needs. Kohler makes mower engines for extensive personal and professional uses. Essentially, Kohler offers a wide variety of choices based on conditions.
Clogged or Dirty Air Filters

Dirty air filters are one of the most common reasons lawn mowers sputter. Dirt can be present in the apertures that lead from the carburetor and the fuel filter and interrupt the flow of fuel supply to the combustion chamber. You want to be sure to clean or replace dirty air filters.

Other things that could cause this issue are bad fuel, weak/colapsed/kinked fuel line, faulty spark plug, faulty ignition/coil, oil over full, clogged air filter, plugged/dirty carburetor, worn engine parts internal rings/valves/etc.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

The most common cause for engine hunting is a blockage in the carburettor. Put simply, this restricts the fuel flow in the carburettor causing the engine to slow down. To try to compensate for this, the engine`s governor opens the throttle to allow more fuel into the engine.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Have a craftsman 16″ chain saw 358.360260. Could not initially get it started after it had sat for a couple years with fuel stabilizer in it. When I went to use it the fuel had all evaporated and the fuel pick line was rotted. I replaced that with some difficulty but finally got it on. Saw still wouldn’t start. Replaced the fuel filter. Still wouldn’t start. Pulled the carb apart and cleaned and recleaned everything. Diaphragms were good and I didn’t adjust any of the mixture screws because as I said it ran fine before storage. Non of the carb passages were clogged. Fresh gas 40:1, good spark plug and good spark. Airfilter is good. Engine has maybe about 4 hours of total run time on it. It’s a ZAMA (?) carb. It will run for about 30 seconds when I manually prime it by pouring a small amount of fuel directly though the carb. When I was disassembling the carb the vent hose that goes back into the fuel tank seemed to have a small out of ?substance? in it which I cleaned out. It was right at the end the of the hose that goes back into the fuel tank and not up by the carb. It didn’t appear to be like your typical gummy deposits/varnish though. I hope it wasn?t some type of spongy check valve stuff that is supposed to be in there. That might explain some of my problems. Anyway, I also can not seem to get the primer bulb to fill. When I open the fuel tank, look in side and depress the primer bulb, air bubbles come out of the fuel filter. But when I let the bulb reexpand there’s no fuel that gets sucked up the hose. I can however seem to fill the primer bulb when the fuel tank is full and the chainsaw is laying on it?s pull cord side and the bulb is depressed a bunch of times. The saw will also start and run again for about 15 seconds then die. It’s definitely not getting/fuel and probably running out . Thanks.

Have to run on half choke,just stops if i turn it off.fuel is 25 to 1. thanks alan.
ANSWER : More than likely a small passage way in the carb is clogged. You can try some carb cleaner, but you may need to disassemble the carb and clean it out. Be advised that these passageways are sometimes as fine as a human hair, and almost impossible to clear sometimes. A new carb may be required if it is worth it to you. Sorry.

Will only start and run in choked position, when throttle applied chokes out. If started with out choke and throttle position in low speed will start and run for 10 sec then like it runs out of gas.
ANSWER : I have your solution guaranteed, I fixed mine yesturday remove H L screw plastic caps and on high 11 threads exposed and on the low side 8 threads exposed. removing the plastic caps allows u further adjusting these wear out or move soo just take them things off and you will be rolling

Runs good until hot chokes itself out or runs out of fuel engine reavs high then for 3 or 4 times then cuts off
ANSWER : Sounds like the coil is breaking down at high temperature. make sure the engine is not covered with grass clipping and dirt. replace the coil. i think this will solve your problem

My mantis will not stay running unless the choke is full on
ANSWER : Sounds like the fuel pump diaphram in the carb. you need to either be familar with it or take it to thae shop to replace

Cranks up and runs fine ,then starts cutting out then runs fine and starts cutting out again
ANSWER : I am no pro but my suggestion to you is if you have changed your spark plug recently check the gap on it and make sure it is right and make sure is the right spark plug for it. Also check the oil if it is low the motor as it gets hot will start to sputter or if it has to much oil it will have an air lock and blow you Lhead gasket after a while. Another thing to check is the air filter to make sure it is clean and check the timing with this if you don’t trust your self ask an repair expert for your brand of mower.

While running what setting does the choke lever need to be placed in
ANSWER : Depending on how your unit runs, it may need to be on half choke until the motor warms up. After the motor gets hot it should run with the choke fully off.

Engine quits running at full throttle and hot
ANSWER : Sounds like coil but check oil