Poulan

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A single fuel pipe runs from the tank, under the floor of the car to a mechanical pump on the engine. The pump delivers fuel to the carburettor. Whenever you check fuel pipes, disconnect the battery to prevent stray sparks igniting petrol or petrol vapour.
The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb. The return line (blue) comes from the long post on the back of the primer bulb and goes into the bottom of the fuel tank.
Replacing the fuel hose on your vehicle is going to take time and patience, and it could require getting underneath the car. It`s also going to take the right tools for the job.
Most vehicles have rubber fuel hoses connecting the fuel pipes on the chassis to the fuel pump or carburetor on the engine. Rubber hoses are flexible and can be cut to length as required, but they have a tendency to perish over time and can rub through if not properly secured.
You can find Poulan Pro products both in-store and online at home improvement retailers, hardware stores, and mass merchants all over North America. We are here to help you tackle… ANY YARD.
Engine misfires, hard starting, and stalling

A fuel leak due to a worn or damaged hose can cause the vehicle to experience issues such as misfires, hard starting, stalling, and can even prevent the vehicle from running at all.

In this application three types of hose are used nitrile, nylon and braided. Let`s deal with nitrile rubber style first. This is the most common of the three. Typically being constructed of a premium inner layer made from NBR (Nitrile), a reinforcing spiral wrap and an outer cover.
The main colors used in ISO 14726 are as follows:

Blue – Fresh water. Brown – Fuel. Green – Sea water. Grey – Non-flammable gases.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Replaceing fuel line in polan 3300 chain saw – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : Hi owjbhend…
Use a piece of wire and insert it into the fuel line, then bend a hook in the end and hook it over the end of the fuel line…lubricate the fuel line with some vaseoline very lightly…about the first one inch of the fuel line and then use your fingers to start the fuel line into the tank, once you have the fuel line in the tank give enough to hook the fuel filter to and so it can be dropped back into the tank.
Below is a drawing of how to route the fuel lines.
Please take time to rate me thumbs up
Please take time to rate me thumbs up

Read Full Q/A … : Poulan

How do I replace the fuel line for a Poulan ppbp30?
ANSWER : Open the top of the machine to access the carb, Normally it is easily done with needle nose pliers.

Read Full Q/A … : Poulan

Poulan te 450 cxl fuel lines need routed correctly two line both in tank one to fuel filter other line?
ANSWER : Other line is just left open like to send gas back from the carb.

Read Full Q/A … : Poulan

How to replace fuel lines on a ut08514 blower
ANSWER : Go to youtube.com and watch the video and it will show you how to replace the fuel lines. Hope this helps.

Read Full Q/A … : Poulan

Fuel line is bad and needs replaced. need to know
ANSWER : One line should be hooked to a small fuel filter or screen.
The other one is a dump or over flow that will put a small amount of unused fuel back into the tank.
You can buy this type of line at most Lawn Mower shops as a kit. 2 lines and a filer/screen.
You can use line for air shocks that fit some cars ie. Cadillac’s

Read Full Q/A … : Poulan

Need to replace fuel lines on my Troy Bilt gas hedge trimmer. Where can I get replacement fuel lines… or better yet… what size are the lines and where can I buy a few feet of the lines. Note: I have reviewed the parts assembly and it would seem to indicate I have to replace the entire handle assembly (Part #1) instead of just buying replacement hose(s). Any help to resolve my issue would be greatly appreciated and thanks in advance
ANSWER : Replacement fuel lines should be readily available at your local lawnmower repair shop. Your TroyBilt hedger uses fuel line that is 3/32″ (2.4mm) interior dimension, 3/16″ (4.8mm) outside dimension, with a 3/64″ (1.2mm) wall dimension.
Most manufacturers don’t offer replacement line, only fuel tank assemblies. Find your local shop, and try to get the TYGON brand…it is yellow. Tygon lasts the longest. You should be able to buy it by the foot for less than $2 per foot. You will need 2 feet of hose to replace both lines.

Make sure to clean the in-tank filter when replacing hoses.

Good luck.

Read Full Q/A … : Poulan

Why won’t it start
ANSWER : You’ve got to see if you have spark and fuel first. Then get back to me.

Read Full Q/A … : Poulan

The saw starts up fine, runs fine but not for long. it runs for about 1 minute and dies. like it is out of fuel or sucking air, i noticed there is no filter on the suction line and there is another nipple entering the fuel tank which appears to need a hose on it , is this just a return line, or should the long line in side the tank press on to this nipple? thanks,
ANSWER : I’ve had my pp4218 for about 2 years and the fuel lines have rotted. I’m thinging from ethanol in the gas. However, I’m replacing them and cannot tell which lines go where. Does the large line from the bubble go to the filter and the little line return?

Read Full Q/A … : Poulan