gas.
Wild Thing 2375 18″ Gas Chain Saw 2.5 Cuin

Experienced gardeners share their insights in answering this question :
Try reversing the lines on your primer.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A: The spark plug gap on all products is . 025-inch.
If the chainsaw won`t start, or starts and then stops and you find the spark plug wet with fuel mixture, it means that the engine is flooded (you will probably smell petrol). It happens when too much fuel enters the combustion chamber, possibly because you have pressed the primer many times.
The carburetor on a chain saw is pretty simple, as carbs go, but it`s not entirely uncomplicated. The job of the carb is to accurately meter extremely tiny quantities of fuel and mix it with the air entering the engine so that the engine runs properly.
Spark plug gaps for car engines are typically 0.6 to 1.8 mm (0.024 to 0.071 in). Modern engines (using solid-state ignition systems and electronic fuel injection) typically use larger gaps than older engines that use breaker point distributors and carburetors.
There could be various causes: incorrect fuel mixture, carburation not calibrated properly, or a wet spark plug. In spite of their power and robustness, chainsaws are actually rather delicate machines that require careful and precise maintenance at every stage of their life cycle.
What Causes Chain Saw Kickback? There are two circumstances that can cause kickback when using a chain saw. The first occurs when the moving chain at the tip or the nose of the guide bar strikes an object. The second situation is when the wood closes in, pinching the saw chain in the middle of the cut.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Repaired gas lines, reassembled correctly. Engine now floods and does not want to start. When left to sit over night, the cylinder filled with gas.
ANSWER : Try reversing the lines on your primer.

Gas line routing – Poulan Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
ANSWER : Try going to a local hardware store and ask them about gas routing for chainsaws. If that doesnt work then I suggest to send the chainsaw back and have them replace it.

I need to replace to fuel lines on a Craftman 32cc trimmer. The old ones cracked apart. 2 of the lines look like 1/8″ OD one line looks like 3/32″ OD. Larger line looks like it hooks to filter, Smaller line to a fitting in the gas tank. I am assuming the smaller line ges to the primer inlet. My question is the lines penetrate the bottom of the gas tank. How do they seal. How do I install the filter and the fitting. I am assuming to thread the new lines in from the bottom of the tank and pull through the gas cap hole. Then I attach filter or fitting and pull back through. So do I pull the line so as to create a seal from the swell caused by the fitting/filter?
ANSWER : Depending on the brand of line you use, Tygon line is self sealing but seems to shrink faster then factory supplied because of the ethanol in the gas. The stone gas filter is designed to fall to the lowest part of the tank, not stop the line from falling out.

Need to change gas line tube – Craftsman Convertible 25cc. Gas Line Trimmer

Fl 1500 gas line broken where does the two lines go
ANSWER : New gas lines wont start

Fuel line diagram for craftsman gas blower – Craftsman 25cc Gas Line Trimmer

Why do my car want take the gas when I start the car
ANSWER : Make and model, engine size please.

How do you repair a leaking gas line? it leaks between the gas line and the tank
ANSWER : Possibly, but it might start coffin and spluttering if you fit one.