“Chain Saw – 16” Bar, 3 Hp

SCCS 38 sovereign chainsaw

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

With a narrow flat-tipped screwdriver, adjust the oil flow. To increase the oil flow, turn the automatic oiler adjustment screw counterclockwise.
The oil drain plug is a screw plug made of metal or plastic. The oil drain plug with sealing ring seals the drain opening. This opening is needed to drain waste oil when changing the oil before refilling.
Use canola oil – Canola oil is currently the most common environmentally compatible chain-and-bar lubricant.
The oil drain plug is a screw plug made of metal or plastic. The oil drain plug with sealing ring seals the drain opening. This opening is needed to drain waste oil when changing the oil before refilling.
As their name suggests, automatic or fixed flow oilers provide a consistent amount of oil whenever the saw is running. Any time you use your saw, you`ll get the same amount of oil on your chain.
Locate the oil adjuster screw on the bottom of the chainsaw. Turning this screw will adjust the oil feed rate. Turn the screw clockwise to increase the oil feed. Turn the screw counterclockwise to decrease the oil feed.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

The automatic oiler it is not working what should you do to fix it
ANSWER : 1-Try to clean the oil bowl and line.2-Check for a bolt and if find try to adjust by tighten it.If no bolt then change the oil pump diaphragm.If you need more help come back.Post /
thumbs / testimonial are
welcome!

My automatic chain oiler is not working. What could be the problem? Resovoir is full.
ANSWER : The plastic threads on your pinion gear are stripped and if it is not that check the small filter on the underside of the crank case could be plugged

Automati oiler not working – Husqvarna 350 18 Inch Gas Chainsaw 52CC Fully Assembled Brand New 18"
ANSWER : Check the tube is that clean and if its ok check the cap air vent of oil tank if its works then oil pump is faulty.

No oil getting through to chain on use
ANSWER : HiThe oil feed depends on the rpm of the engine.More rpm results more oil.Check the oil line,the oil filter(inside the oil tank),the gear worm and the oiler:Clean the oil way. cheers savumihai71

My automatic oiler is not releasing any oil – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : With the chain & bar removed the oil should be cleary seen if run.common fault is sawdust getting into the oil chamber.

There is one clear hose on the oiler that is not hooked up need to know were it gos oiler not working
ANSWER : Contact them:
https://register.ryobitools.com/contact_us/new
Explain your problem and they should be willing to send you an IPL for your saw.
Lou

How to repair or replace the oiler – Poulan Pro Chain Saw 46cc 20"
ANSWER : Remove the clutch and then its held in with 2 screws

Echo chainsaw how do you remove the clutch from an ehco cs400evl?
ANSWER : OK I looked at Echousa.com and see that there shoule be a hex nut on the side where the clutch is. It doesn’t specify whether it is left or right hand thread. but what I used to do is we have a plastic plug to put in the cylinder to stop piston from moving and then putting a ratchet on the hex nut. without the plug you can try an impact wrench to BUMP the nut in forward and reverse to remove it. Make sure the switch is off before attempting either action. You can look at the manual or parts explosion at the site I listed