John Deere

Rear pto shaft will not come on john deere 3320 tractor

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
Pump trouble is usually characterized by increased noise, increased heat, erratic operation of cylinders, difficulty or inability to develop full output, decreased speed of cylinders or hydraulic motors, or failure of the system to work at all.
The tractor`s stub shaft, often called the PTO, transfers power from the tractor to the PTO-driven machine or implement. Power transfer is accomplished by connecting a drive shaft from the machinery to the tractor`s PTO stub shaft.
A PTO draws its power from the vehicle`s engine, but it cannot start transferring that power until it has been engaged. PTOs can be engaged through air pressure, hydraulic pressure, or a cable, explains Luke Hart, customer/employee technical training instructor for Muncie Power Products, a manufacturer of PTOs.
Lack of ownership: Since PTO isn`t accrued as they work, employees don`t feel like it “belongs” to them. If they don`t feel like they`ve earned it, they don`t use it. Lack of encouragement: Managers fall into the same trap of taking less time off. This sets a bad example that their employees feel pressured to follow.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Need the pto to work on a 6300 john deere tractor we have changed the fuses and changed the sencer on the back can you help
ANSWER : If you have tried a new sensor and a new switch the the next step is to replace the pto solenoid valve.If that proves fruitless then the b.c.u.needs to be replaced or bypassed.The solenoid valve will cure your problem 90% of the time.If that does not work,let me know,i can tell you how to by-pass the b.c.u..

Read Full Q/A … : John Deere

JD 6400 tractor, PTO light flashes when engaged but PTO does not work.
ANSWER : The most likely problem is the pto solenoid valve on the rear of the tractor.It could be the speed sensor but you won’t know until you get the codes read by the dealer.I have had to replace the b.c.u. for this problem but it is not common.

Read Full Q/A … : John Deere

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : John Deere

The mower blades on my John Deere stx 38 lawn tractor will not engage. I just installed a new pto switch and when engaged the engine stops.
ANSWER : It sounds like the safety switch under seat is bad

Read Full Q/A … : John Deere

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : John Deere

Turned pto off when finished mowing then turned it back on and it does not come on
ANSWER : Check the wiring to the PTO first. if it is good either the PTO or its inline fuse has failed. try the fuse first as it is much cheaper. if it just blows again you are back to replacing the PTO.

Read Full Q/A … : John Deere

John deere stx 30 pto wont engage
ANSWER : Check your fuse or for a broken wire( or shorted)

Read Full Q/A … : John Deere

Hello,
We have a John Deere 2140 Tractor with front end loader attachment. How do we engage the PTO, or where is lever.

Thanks

ANSWER : Located between the gear lever and ratio lever on the centre console

Read Full Q/A … : John Deere