Street Sign- tractor lawn riding mower parts
Put in new battery and plug today; fired her up just fine; pulled the pto knob, blades won’t engage
Experienced gardeners share their insights in answering this question :
Belt may have come off. Check the wire from the clutch and from the switch, you may have had hungry rodents during off season storage.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it. Need help finding your model number? The PTO switch provides power to the PTO clutch.
If the PTO clutch is not receiving power, the clutch solenoid is defective, or the clutch itself is worn out, the blades will not engage. Since a PTO clutch is not repairable, you will need to replace a broken or worn out clutch with a new one.
Powershift PTO engagement problems could be from blocked hoses or fittings, bad connections or ground or the solenoid. Mechanical PTO engagement problems could originate from low air pressure, improper cable installation or back lash too tight.
On a Putzmeister MR 688 series the PTO Pump/Drive switch gets its power from a fuse located in the Mack fuse block.
Pump trouble is usually characterized by increased noise, increased heat, erratic operation of cylinders, difficulty or inability to develop full output, decreased speed of cylinders or hydraulic motors, or failure of the system to work at all.
This operation is crucial to the overall functioning of riding mowers, and thus PTO clutch repair may need to be immediately performed on riding mower models that have a failed clutch. Fortunately, you can fix your clutch irrespective of your experience with PTO clutch installation.
To bypass a safety switch on a lawn mower, you will need to disable either the PTO or seat safety switch. Disabling the PTO switch requires cutting the wires near the engine. You must disconnect and cut wires under the mower`s seat to disable a seat switch.
On a Putzmeister MR 688 series the PTO Pump/Drive switch gets its power from a fuse located in the Mack fuse block.
The PTO is engaged and disengaged using the main transmission clutch and a remote control mechanism which operates on the PTO itself. Typically, an air valve is used to engage the PTO, but a mechanical linkage, electric or hydraulic mechanism are also options.
On a Putzmeister MR 688 series the PTO Pump/Drive switch gets its power from a fuse located in the Mack fuse block.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I have a Craftsman FS5500 48″ lawn mower. The PTO makes a noise (squeak) for a second when I pull up on the red blade engage knob. The blades do not engage. PTO does not turn. When I push the red button down to disengage there is a brief squeak from the PTO.
It worked well the past month then a little problem 2 weeks ago. It seemed to disengage after mowing a while. Then after sitting for 15 minutes the blades would engage. I used it earlier this week and the PTO won’t turn at all.
Just purchased from the last and original owner a month ago. He said the oil would need to be changed this summer. Could that be part of the problem? Engine runs great!
Also, I need an owners manual, not able to find from the previous owner.
Thanks
ANSWER : Hi,The problem is probably in the button that you pull and push to engaged and disengage the PTO… If you wiggle the button or try to pull it slowly, you may find a spot where it will work. But the button has gone bad and will need to be replaced.If you are comfortable with wiring, you could jumper the wires and getting it working, but it would be a very temporary and possibly dangerous fix…
Read Full Q/A … : Street Sign- tractor lawn riding mower parts
Mower won’t start
ANSWER : This may sound stupid but don’t mean it to…
Have you tried with the choke all the way open? Do you have an automatic cruise? Is the right (correct) pedal being pushed in? These will affect if it starts or not. Also if your drive belt or one of the other belts not being tight enough will affect if it starts or just turns over. Not too many things can stope it from starting with new/good battery AND if its getting gas. Try cleaning your gas line and obviously making sure there is no obstruction around or near your blade, if it does start with blade engaged that is :))
If it doesn’t start with blade engaged, well make sure it’s in neutral. Mine won’t start in reverse but will in forward or neutral.
Have you tried with the choke all the way open? Do you have an automatic cruise? Is the right (correct) pedal being pushed in? These will affect if it starts or not. Also if your drive belt or one of the other belts not being tight enough will affect if it starts or just turns over. Not too many things can stope it from starting with new/good battery AND if its getting gas. Try cleaning your gas line and obviously making sure there is no obstruction around or near your blade, if it does start with blade engaged that is :))
If it doesn’t start with blade engaged, well make sure it’s in neutral. Mine won’t start in reverse but will in forward or neutral.
Hope it helps.
Anthony
Read Full Q/A … : Street Sign- tractor lawn riding mower parts
PTO CONTROLS. How do you engage and disengage PTO.
ANSWER : The tractor is not a 6300 is it.If it’ not you need to adjust the cable for the p.t.o. until it will stay down.Don’t turn the turnbuckle too much at a time because there is a fine line between the won’t engage and the won,t disengage adjustment.
Read Full Q/A … : Street Sign- tractor lawn riding mower parts
I replaced an electric PTO Clutch, easy swap. Now the blades won’t engage or it won’t start at the switch. I can start it at the solenoid. Can anyone help? Thanks
ANSWER : Have you checked your ground wire? it’s simple switch power one side ground the other ck both side, also you might hv a bad switch if the wires ck out good luck
Read Full Q/A … : Street Sign- tractor lawn riding mower parts
Blades wont operate when engaged – Craftsman 20 Hp 42" Deck Lawn Tractor
ANSWER : Check the PTO switch it may have worn out
Read Full Q/A … : Street Sign- tractor lawn riding mower parts
On a cub cadet LT 1042, what does it mean when the blades engage on their own and won’t disengage and the motor makes a high squeeling sound
ANSWER : Sounds like the PTO clutch is bad either binding up or coming apart or binding up.
Read Full Q/A … : Street Sign- tractor lawn riding mower parts
Cub cadet lt 1050 electric pto want engage??????????
ANSWER : Make shure pig tail is hooked right
Read Full Q/A … : Street Sign- tractor lawn riding mower parts
Toro 149cc Lawn Mower Won't Start – Toro Lawn Mower With Toro Power Tools
ANSWER : Bad carburetor your old fuel jammed up the jet so it won’t get fuel and if it does it will start and shut off So replace the carb or try to clean the jet and run non oxy fuel only
Read Full Q/A … : Street Sign- tractor lawn riding mower parts
