42-Inch Steel Deck 17.5 HP Briggs & Stratton I/C Engine With…
It's like i'm running out of gas, then it wont crank back up without charging back up.
Experienced gardeners share their insights in answering this question :
I’ve had just problem for 10 years. I’ve replaced batteries, solenoids, starters, use 2 chargers. Now they said adjust valves, checked that. Out alittle adjusted. Now no moving on intake pushrod. I’m tearing the engine apart to find out why. You need to adjust your valves. GOOD LUCK.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
If your lawn mower battery won`t hold a charge, verify connections are clean and tight first, then connect it to the charger. If it isn`t fully charged within 8 hours, your battery is dead and you`ll need to replace it. If your lawn mower battery does charge fully, the charge should not drain if it is not in use.
Powered by a 58-volt, 5.2Ah, lithium-ion rechargeable battery, it features instant push-button starting and provides the power and performance typical of gas-powered push mowers, without all the noise and harmful exhaust.
A riding lawn mower with an especially small engine may have a 6-volt battery. The lawn mower`s alternator keeps its battery charged. A few hours of mowing recharges it the same way hours of highway driving can keep your car battery mostly charged. You might not mow the lawn in winter.
Allow the charger to power up the battery for up to eight hours. It should have a full charge by this time. If you notice that it`s still indicating a low status, it`s time to replace the battery. The cells can`t absorb the electrical energy as well as they used to do.
Most riding mowers take a 12 volt battery, although some smaller mowers rely on a 6 volt battery. If you`re unsure what type of battery your mower requires, you can check the voltage of your old battery, or look up the information in your owner`s manual or on the manufacturer`s website.
Alternators power the small engine while it is running, keeping the battery charged by circulating power back back through the system. For the easiest alternator test, simply turn on the headlights to your lawn mower or outdoor power equipment.
The factors that keep draining your lawn mower battery include damaged, loose, or corroded cables, an electronic drain, or cables that are attached loosely. Sometimes, it is as simple as the battery needing some maintenance. Other plausible reasons are faulty alternators, voltage regulators, and battery chargers.
A loose connection makes the battery work harder than it should, thereby draining it of power quickly. Clean the corrosion, tighten battery connections and check the battery case for cracks, advises M&D Mower and Appliance.
Corroded Battery Connections Electrolytes from the battery top can cause corrosion of the connections to the battery cables and prevent them from reaching a full charge, so the battery won`t hold a charge for long while driving along.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Poulan pro 42 cc, no spark – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : Try diss connecting the earth cut out wire from the ignition unit and try for a spark again, this will rule out the switch and any trapped wires, re set the air gap between the unit and the flywheel to 0.3mm, if there is still no spark the unit is bad and will require replacment, they are normally only held on with a couple of allen screws, and either bolted to the cylinder or the crankcase.
Poulan chainsaw 18″ 42 cc, pro gas filler cap?
ANSWER : Yep they swell after a while and will not screw in or out!
Sand the threads down so that the circumference is reduced with a course file or plumbers cloth, chamfer the threads a bit on the edges. A new one will do the same thing after a while so just fix the one you have.
Maxtra CHAINSAWS CAN YOU SUPPLY CHAINOIL PLUGS?FOR maxtra 42CC
18″-ml 72tfgcsoo8 the plug i have will not stay in place .
ANSWER : I would check jackssmallengines.com the link is below. They supply Poulan replacement parts.http://www.jackssmallengines.com/poulan_chainsaw_parts_index.cfmGood luck.
Poulan pro bvm200vs, what is the spark plug gap suppossed to be set at?????????????
ANSWER : Re: “The plug should be set from the factory check your manual for the gap setting”Chris, If people had the manual do you honestly think they would waste their time looking for the answer online.Chris – I hope you don’t get paid for offering ‘Check your manual’ answers.
I have a Poulan Pro 260 and the spring that attaches from the handle to the engine has boke. I am having a difficult time finding the part/part # so I can reorder. Can you help?
ANSWER : The upper av spring is part no. 545006036, check out the web for sellers.
Need to locate a diode for a Poulan Pro riding mower
ANSWER : It is on the engine side of the two wire plug going to the engine it will only be a slight bubble in the wires
Can you adjust the oil pump – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : Depends on the saw. If it is adjustable then it will be adjusted from the bottom of the saw. Most have a diagram on the bottom showing which direction to turn the screw
No owners manual was in the box – Poulan Pro Chain Saw 46cc 20"
ANSWER : Did you contact the store where you purchased it? That would be first step.
Poulan.com
Handheld (Chainsaws, Trimmers, Blowers, Edgers)1 (800) 554-6723 or
http://www.poulanpro.com/node4033.aspx
There is currently no where to download an Operator’s Manual. HTH
Lou