Mower Rider 30In 11.5 Hp B&S, Lrvb

Starts and runs but won’t shift into gear

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Poulan is a brand name of the Swedish manufacturer Husqvarna AB.
I truly think this mower is worth the money and i would recommend it. My Poulan runs well and has all the power I need for mowing tall weeds. It turns easier and tighter than all previous mowers I`ve owned. What I don`t like is the transmission as compared to the hydrostatic trans.
An American Story.

For more than seven decades, Poulan Pro has been making outdoor power equipment homeowners can rely on year after year. Our products are built with pride in our factories in McRae, Georgia, Nashville, Arkansas and Orangeburg, SC.

There may be old or bad fuel in the carburetor float bowl. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and make the engine hard to start. If the carburetor is clogged, try cleaning it with carburetor cleaner.
Equipped with a powerful, high performance Briggs & Stratton® 163 cc 675 EXI Series engine, the Poulan Pro PR675Y22RHP features the ReadyStart® starting system, with no priming or choke required — gauranteed to start in 2 pulls or less.
Husqvarna definitely owns Poulan. I`m sure they still make some of their original good quality stuff in Sweden. Husqvarna bought Poulan.
Husqvarna definitely owns Poulan.
Powered by a 50cc 2-cycle engine, the Poulan Pro PR5020 chainsaw is powerful and very easy to start and operate. A robust, all-round model with low weight, equipped with OxyPower engine for more power, lower emission levels and lower fuel consumption.
Equipped with a powerful, high performance Briggs & Stratton® 163 cc 675 EXI Series engine, the Poulan Pro PR675Y22RHP features the ReadyStart® starting system, with no priming or choke required — gauranteed to start in 2 pulls or less.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Won’t idle ,runs wide open unless you pull choke,solutions?
ANSWER : Maybe a carb overhaul can do the job.

Poulan chainsaw 18″ 42 cc, pro gas filler cap?
ANSWER : Yep they swell after a while and will not screw in or out!
Sand the threads down so that the circumference is reduced with a course file or plumbers cloth, chamfer the threads a bit on the edges. A new one will do the same thing after a while so just fix the one you have.

Poulan pro 42 cc, no spark – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : Try diss connecting the earth cut out wire from the ignition unit and try for a spark again, this will rule out the switch and any trapped wires, re set the air gap between the unit and the flywheel to 0.3mm, if there is still no spark the unit is bad and will require replacment, they are normally only held on with a couple of allen screws, and either bolted to the cylinder or the crankcase.

Maxtra CHAINSAWS CAN YOU SUPPLY CHAINOIL PLUGS?FOR maxtra 42CC
18″-ml 72tfgcsoo8 the plug i have will not stay in place .
ANSWER : I would check jackssmallengines.com the link is below. They supply Poulan replacement parts.http://www.jackssmallengines.com/poulan_chainsaw_parts_index.cfmGood luck.

Won,t start, gas spark plug checkout – Poulan Pro 22" Self Propelled High Wheel Mower
ANSWER : Pull the bottom bolt out of the carb and then the the bowl. inspect for debris or water then clean out the bowl then blow out the little hole in the bolt. it probably has some **** in it. I see it all the time.

I have a Poulan Pro 260 and the spring that attaches from the handle to the engine has boke. I am having a difficult time finding the part/part # so I can reorder. Can you help?
ANSWER : The upper av spring is part no. 545006036, check out the web for sellers.

Poulan pro bvm200vs, what is the spark plug gap suppossed to be set at?????????????
ANSWER : Re: “The plug should be set from the factory check your manual for the gap setting”Chris, If people had the manual do you honestly think they would waste their time looking for the answer online.Chris – I hope you don’t get paid for offering ‘Check your manual’ answers.

Need to locate a diode for a Poulan Pro riding mower
ANSWER : It is on the engine side of the two wire plug going to the engine it will only be a slight bubble in the wires