Garden
Experienced gardeners share their insights in answering this question :
Try putting in fresh gas. Change spark plug. Clean out air filter.. Check choke for proper operation. Make sure it is getting spark and fuel.. Hope that helps dont know what you have done to the saw.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Your lawn mower turning over but not starting due to several reasons, such as a faulty or disconnected plug, a disconnected spark plug wire, a clogged air filter, or a contaminated fuel tank. A faulty carburetor, a dirty cutting deck, or a dysfunctional flywheel brake can also cause this.
There are several reasons a Craftsman lawnmower may turn over but not start, with the most common ones including the following: Lack of fuel. Dirty air filters. Electrical issues in the ignition system or the starter motor.
A dirty carburetor is one of the most common causes for a lawn mower not being able to start after sitting unused for months or years at a time.
Disconnected, dirty or fouled spark plugs are common causes for engines that won`t start. For small engines, spark plugs typically need to be replaced every season or after 25 hours of use. You should also check to make sure the spark plug gap is set correctly.
If your lawnmower is starting and then stalling, the most likely issue is the carburetor. The most common issue is that the carburetor is dirty. Here`s what you need to know about how a dirty carburetor can cause a lawnmower to start, then stall out and die.
If a mower is hard to start, it may be the result of a dirty carburetor and/or a clogged air filter. Use a screwdriver to remove the carburetor and clean any dirt out of it with a rag. Clean the air filter or replace it if it`s disposable.
If your lawnmower starts up but then dies in the middle of mowing your lawn, you could have a bad spark plug. The spark plug works with the ignition coil to create a timed spark in the cylinder, causing combustion. The spark plug is really a very simple device.
The most common reason for a riding mower cranking over but not starting is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.
The clicking noise comes from a part called the starter solenoid. The solenoid connects the battery to the starter motor when the solenoid is energized. The key switch and the safety switches in the starter circuit combine to energize the solenoid. If the solenoid is clicking, the circuit that triggers it is working.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
MY POULAN PRO 6.5 WONT START….nEED TO REPLACE SPARL PLUG BUT DO NOT KNOW ‘right one”..
ANSWER : Take the old plug out, any auto store should be able to match it up.
Gary
Read Full Q/A … : Garden
Poulan blower was running – ran out of gas – put gas in – won’t start- primed – won’t start – let sit – won’t start-took cover off – sprayed starter fluid in carb – won’t start- -(very little stutter) won’t start-set overnight – repea -twon’t start-wits end !!!
ANSWER : Hello
Does it use a fuel and oil mixture?You probably did that.
Does it use a fuel and oil mixture?You probably did that.
Try removing the spark plug and cleaning it with a wire brush or some emery cloth.Make sure you have spark by connecting the plug wire and resting the plug on the metal motor block.
Do not hold the plug in your hand ,if you have no spark you may have a bad magneto.
Read Full Q/A … : Garden
Poulan leaf blower wont start
ANSWER : Try changing the spark plug. if that doesnt work let me know and i’ll help you trouble shoot it.
Read Full Q/A … : Garden
Poulan pro chain wont stay running – Poulan Pro Chain Saw 46cc 20"
ANSWER : Keep “poulan” ha ha
Read Full Q/A … : Garden
My poulan pro 42cc is hard to start ,,, its1 year old an i’m not sure if its worn out from alot of use or if its with the ignition
ANSWER : Throw it out and buy a new one this is a throw away scoiety we live in due to cheap *** chinese **** oh yeah go green
Read Full Q/A … : Garden
Poulan 3816, back fires through carburator, wont start.
ANSWER : Water in the gas or carb needs to be removed and taken apart and cleaned
Read Full Q/A … : Garden
Poulan pro weedeater will not start without starting fluid and wont accelerate after starting Once started the first time it is easy to restart and idles fine, just cant accelerate the motor without it dying.
ANSWER : Your carburator is clogged.
1st make sure you have FRESH gas.
Empty and clean the fuel tank
Remove and disassemble the carburator and soak it in fresh gas for about 15 minutes to disolve any gunk.
1st make sure you have FRESH gas.
Empty and clean the fuel tank
Remove and disassemble the carburator and soak it in fresh gas for about 15 minutes to disolve any gunk.
Using a can of small carburator cleaner ( available at Lowes, Home Depot etc.) blow out all the ports.
reassemble and refuel with clean fresh gas
The little carbs clog easily
Read Full Q/A … : Garden
Tines wont turn handle grip flopped down no spring tension
ANSWER : Could be your cable has broken or come undone or the spring has broken. I had to replace my cable and had to order this cable and I was in a hurry so I picked up a cable for a lawn mower cut it in half and got a package of wire sleeves and put them on and crimped them with a vice grip.
Machine works good now.
Machine works good now.
Read Full Q/A … : Garden
