to be a mechanical problem, but there is no power goi
My 2000 magnum 500 is not getting power, the battery is fine, it turns over, has great compression, it doesn't seem to be a mechanical problem, but there is no power going to anything, not the neutral lights, the headlights, nothing. Previous owner said rats chewed through the cables, when checked all cables were fine except for the ignition for the 4×4 which wasn't chewed through it was cut. Any ideas what this could be?
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The power fuse box is located under the driver`s seat. Remove the engine access panel to access the fuse box.
The battery is the most common reason why an ATV or UTV won`t start. First, look at it and make sure the battery isn`t corroded. If it is, try cleaning it with a scrubbing pad, water, and baking soda. If you can get it clean, try to start the machine again.
The number one reason an ATV clicks and doesn`t start is the battery, so you should troubleshoot that first. If your battery is functioning correctly, the next common source is the starter solenoid or a bad starter motor. Occasionally you could have hydro-locked your engine, or the fuses have failed.
Possible causes of a power failure could be either bad battery connections, a bad ignition switch, or a bad alternator. What you need to do is check your vehicle`s power sources.
The stator is like the alternator in your car, it makes it so the battery can recharge while the ATV is running. This is crucial to proper battery function, and your ATV will stop running if the stator is bad. It isn`t an intermittent problem or a slight problem, it`s an, “I can`t ride my ATV,” problem.
Polaris Predator 500 top speed is a respectable 73 MPH in stock condition.
Usually a rapid clicking noise is a good indication that your starter motor isn`t getting enough electrical current to engage – basically your solenoid is trying to engage but can`t make the connection.
This is important – if the starter motor sounds like it`s turning over, as usual, your issue is probably the battery. If the engine cranks but doesn`t start, it could be having trouble producing a spark, getting fuel, or creating compression.
After unplugging all the devices, switch on or reset the circuit breaker. If you don`t hear the click sound or the breaker trips again immediately, you are probably looking at a faulty breaker. But if it remains reset, you should check for a circuit overload or short circuit.
The battery can be fully charged but still not be able to start the vehicle if it is failing or has a dead cell. Other likely issues are the fuel pump, ignition switch, battery cables, starter, or a clogged fuel filter.
The cause of this problem is usually one of 3 things – a failed starter motor, a bad connection between the battery and starter motor, or a blown fuse (if present) in line between the starter and the battery.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Battery goes dead over night – Toro 42'' Zero Turn Lawn Mower Trailer Package Deal ()
First thing to do is find out if it’s the battery or the mower. Disconnect the battery and leave it overnight. If it’s dead in the morning, you need a new battery. If not, you either have a charging problem (not likely if the battery isn’t dead after using the mower) or you have a current drain.
The battery on my Worx GT doesn’t seem to hold it’s charge. I have actually taken it directly off the charger when the light is green and it doesn’t have full power. Sometimes it does. The unit is 3 years old. Is this a normal life expectancy for the battery?
The first time the Worx GT worked great since then I took it off the charger and it won’t go more than five min. without going dead. I’m back using my gas trimmer what’s up ith th battery on the Worx Gt
Ryobi trimmer runs but does not have enough power. How do i adjust or increase power
If the trimmer is indeed electric, then there is no power adjustment capability. The problem you are seeing is the result of a weak battery.
I have craftsman 18.5 horse riding mower when i turn key its like battery does not have enough power to turn engine over,was wondering if it could be the starter cause battery is good.
Blades wont turn – Toro Power Max 726 OE Snowblower – 37771
Check and see if you have a broken belt. first.
I have a toro time cutter that i need to get to the shop, the problem is i need it to go in to neural.
Under the seat towards the rear are two levers with finger loops. move them both to the neutral position shown in diagram provided on mower. This will release the wheels .
On my Timecutter ss5060 it dies when I pull in the drive arms. What could be my problem?
If this is happening while the PTO is operating then your switch is either disconnected, bad, or the wiring to it is broken.
Possible Electrical ProblemMy 2000 magnum 500 is not getting power, the battery is fine, it turns over, has great compression, it doesn’t seem to be a mechanical problem, but there is no power goi