Garden

Experienced gardeners share their insights in answering this question :
Here is a Link to one of my Tips:www.this site.com/support/r6081405-cleaning_small_engie_carburetorGood Luck!Jim

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If the engine is not revving up and cuts out before you reach higher revs then you need to do the following checks: Fuel: Make sure it is fresh and correctly mixed (see `Starting Issues`). Air filter: Make sure it is clean and unclogged. Fuel cap: Make sure it`s hand-tight.
Checking the Fuel Mix

The most common problem with a strimmer not starting is that there`s a problem with the fuel mix. Double check that you`ve used 40 parts fresh unleaded petrol to 1 part 2-stroke oil (40:1). Check the petrol you`ve used isn`t stale.

When your trimmer starts and runs on choke, it could be because the check valve in the gas cap is clogged. Start the trimmer and gently unscrew the gas cap halfway off. Turn the choke off and assess. If the engine is still running, that means the gas cap may be the culprit.
The most likely culprit is a dirty or clogged air filter. Issues with your fuel pump or fuel filter can also cause your engine to idle then die with any throttle. If you have an older car, it could also be a bad carburetor.
The most common causes are problems in the ignition (for example, a bad ignition coil) or fuel system (for example, a clogged fuel filter). However, the source may also be a mechanical fault (for example, a leaking valve) or faulty components in other systems.
Basically, the gas is coming out of the gas pump at a pressure that is too fast for the car to take in. If the air vapors do not get out fast enough and the tube gets covered by gasoline, a vacuum forms inside the nozzle which will automatically switch off the flow of gas into your tank.
First prime the carburetor, by pressing the priming bulb five time. This ensures there is enough fuel into the engine to start the engine. Activate the choke and pull the starter cord until the engine ignites. Once the engine has stopped deactivate the choke and pull the starter cord again until the engine starts.
Check the following: Clogged muffler, clogged exhaust port, fuel restrictions, low compression, poor ignition spark, too much oil in gas or improper air/fuel mixture in carburetor. . Clean carburetor jets and air filter. Check clutch gear wheel for worn or greasy clutch pads.
It`s simply 40 parts of fresh, unleaded fuel with 1 part of semi-synthetic 2 stroke oil.
This ensures there is enough fuel into the engine to start the engine. Activate the choke and pull the starter cord until the engine ignites. Once the engine has stopped deactivate the choke and pull the starter cord again until the engine starts.
Usually this is the result of the cutting head being taken too close to objects, e.g. garden stones, paving edges, walls etc. The cutting line must be allowed to rotate freely and the correct diameter and type of line should be used.
The clutch engages the clutch pads to spin the trimmer head. If the clutch assembly is defective, the clutch will not disengage the clutch pads, and the trimmer head will continue to spin, even at low speeds. If the clutch is defective, replace it. (Note: some string trimmers do not have a clutch.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I have a rhobi strimmer only 2 years old wont start
ANSWER : I presume this is a petrol one.
The fuel can dry in the carby and stop the unit from starting.
Use fresh petrol.

I am not sure about the ryoby unit, but if there is a air filter, take it out and dip it in petrol, then try to start with the normal proceedure in the manual.

Read Full Q/A … : Garden

Ryobi strimmer petrol strimmer stalls on rev up can you solve this problem
ANSWER : I can not take the cover off to put the line back in

Read Full Q/A … : Garden

How do I mix two stroke engine fuel
ANSWER : Put oil in your petrol can add the exact amount of petrol put the cap on shake well use and store out of sunlight

Read Full Q/A … : Garden

How to replace Husqvarna rapid head – Husqvarna 28cc Gas Line Trimmer
ANSWER : There are video’s on youtube showung full assembly of husqvarna strimmer heads.

Read Full Q/A … : Garden

Cracked fuel line
ANSWER : You can get many sizes of hose at the home depot

Read Full Q/A … : Garden

My RST210 2 stroke petrol strimmer won start it has a spark at the plug also the plug is flooding so fuel is getting through but non start ? Great full for any ideas
ANSWER : Often it’s the easiest thing that stump us. Try changing the spark plug first. Sometimes a spark plug just won’t fire under load, i.e., while it’s in the cylinder but will spark if you have it removed. There are checkers for this, but it’s a lot less expensive to just replace the spark plug. Do that first and let me know.

Read Full Q/A … : Garden

Trimmer head rotates on shaft, how do i fix it
ANSWER : You will have to source a new front shaft because the seals inside have worn out and im not sure where to source them parts you could try einhell ltd they sometimes have spare strimmer parts

Read Full Q/A … : Garden

How to load cable – Stihl Fs76 Line Trimmer Intake
ANSWER : If its the ‘autofeed head’ all you do is squeeze the two sodes of the strimmer head where the 2 ciucular recesses are and the outer ring should just pop off exposing the bumper cap and inner spool.

Read Full Q/A … : Garden