**Garden**

**Experienced gardeners share their insights in answering this question :**

## How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

**50:1 ratio mix of petrol to oil**. This means for every 1 litre of petrol you must mix 20ml of oil.

**50 parts of gas to one part two-stroke oil**. To mix one gallon of fuel at 50:1, add 2.6 ounces of two-stroke oil to one gallon of gas, as shown in the chart below.

**5 litres**of high-octane gas and 0.10 litres (100 ml) of STIHL two-stroke oil.

**25 fluid ounces of gas per 1 fluid ounce of oil**. So divide the total amount of fluid ounces of gas by 25 to find the amount of oil to add.

**Part A= 100% : Part B= 25%** If you were ordering a quart of Part A, this means you would need an 8 fl oz can ( a quarter quart ) of Part B. After mixing Part A and Part B together, you will have 1.25 quarts or 40 fluid ounces of material.

**3.2 oz of oil to every gallon of gasoline**.

**50ml of oil per 5ltrs of fuel**.

Recommended by Yamaha and Suzuki for most of their small two stroke engines up to about 30hp, this ratio requires the least amount of TCW3 two stroke oil. The result of using this ratio (less oil) is reduced spark plug fouling and less smoke.

**Mix 50ml of oil per 5ltrs of fuel**.

Recommended by Yamaha and Suzuki for most of their small two stroke engines up to about 30hp, this ratio requires the least amount of TCW3 two stroke oil. The result of using this ratio (less oil) is reduced spark plug fouling and less smoke.

**One gallon of gasoline combined with 4 oz of two-cycle engine oil**. If you are in the state of California, use a 2-cycle oil mix ratio of 40:1.

For a 40:1 mixture, use **3.2 fluid ounces of oil per gallon of gas**. For a 32:1 mixture, use 4 fluid ounces of oil per gallon of gas.

**3.2 oz of oil to every gallon of gasoline**.

## Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

**ANSWER :**I think Poulan uses a 40:1 ratio to one gallon of gas, however I have always used 50:1 the same as my sthl saws with no issue. I would rather have more oil mix that to little.

**ANSWER :**Yes. Verifythe ratio, either 40:1 or 50:1

**ANSWER :**40:1 gas to oil ratio.

**ANSWER :**It uses a gas/oil mix. 40:1Hope this helps.

**ANSWER :**50:1 don’t use outboard motor mix

**ANSWER :**50 to one is a ratio of fuel to lubricating oil. Typically 50 parts petrol/gasoline to one part two stroke oil.

Oil typically comes in a special plastic bottle that incoporates a measure. Simply squeeze the right ammount of oil into the little chamber and add to 5 litres of gas.

**ANSWER :**You need 2 stroke motor oil or chain saw oil.Mix it according to the lable to make up 50:1 oil/gas mix.

**ANSWER :**Mix 2 1/2 oz of 2 cycle oil into 1 gal of gas