Poulan
Experienced gardeners share their insights in answering this question :
I had the same problem. I opened up the blower by removing all the Allen screws, 4 mm wrench. Then pull the motor, need a Torx T-25wrench. You then need to wind up the recoil which is part of the case on the motor side. Wind it up all the way and then put a screw in the slot that is in the recoil. Thread the cord through the tube through the triangular hole in the white disc. Type a big not that won’t slip through the hole. Pull the screw that is holding against the spring.Remount the motor, wiggling it until it slips into place. Make sure it ratchets.Reassemble and you shold be good to go. Only took me 3 attempts to get it right.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Sometimes, when your starter rope will not retract into your leaf blower, it can be because it is jammed between the pulley and the housing, or it is wrapped around the hub. In this case, you will often be able to fix the symptom by simply opening the machine and untangling or removing the rope from where it is stuck.
A: The spark plug gap on all products is . 025-inch.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Weed eater is locked up. can not pull cord at all.
ANSWER : Try taking the cover off around the pull if you can. Likely the cord is not free to spin, or there is a rub on the fly wheel stopping it from moving.
Read Full Q/A … : Poulan
Can't pull starter cord – Poulan Pro Super Blowervacuum
ANSWER : Here are some suggestions: Rope is bound on the pulley. Engine is locked up. Debris in the impeller housing. Flooded, excessive fuel in the combustion chamber. These are just a few. Hope it gets you in the right direction.
Read Full Q/A … : Poulan
Ryobi leaf blower, pull cord wont pull. NO tension, what should I do?
ANSWER : Starter cord spring inside may have brocken
Read Full Q/A … : Poulan
Pull cord won’t engage
ANSWER : Remove the sparkplug and try to turn the flywheel if it turns freely then the engine is most likely ok. if it does not turn you have a locked engine that means its toast. If it does turn then you have to look closely at th pull recoil that it is engaging the flywheel.
Read Full Q/A … : Poulan
Starter cord pulled out of the housing, it
ANSWER : If it’s new take it back should have a one year warrenty on it if yo can’t get it done for free get back to me so I can help you you may have a damaged windind head.
Read Full Q/A … : Poulan
Pull cord stuck – only out an inch or so – Troy Bilt Tb320bv Spring Assist Blower/Vac
ANSWER : It sounds like it got cought around the recoil in wich the string rolls up in
Read Full Q/A … : Poulan
I have a Echo PB 2601 made a loud bang then stoped working.
ANSWER : Sounds like it has seized up. If the pull cord won’t pull then the motor is locked up. Did you run gas/oil mix for the fuel its a 2 cycle motor…
Read Full Q/A … : Poulan
My string will not pull its like its stuck need help thanks
ANSWER : It might have vapor lock, try removing the spark plug and spray a little penetrating oil into the cylinder, let it sit for a couple minutes and try pulling the cord again with the spark plug still off.
Read Full Q/A … : Poulan
