the battery is new (2 weeks old) What could be the problem.
Garden

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

You Lose Power in the Middle of Mowing:

Here`s why this happens and what you can do: Dirty Air Filter on Your Lawn Mower: Clean or replace. Dirty Spark Plug: Clean or replace. Build Up of Clippings & Debris: Clean underside of your lawn mower deck as noted above.

A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

A dirty carburetor is the most common cause of a lawn mower that starts and then dies. Other possible causes include: Stale/Dirty Gas. Faulty Choke.
If the engine will not crank, you likely have a problem with… Discharged / defective battery or faulty electrical connections. To address these issues, check the battery and charging system for problems. Faulty parts: potentially the safety interlocks, starter motor switch (open circuit) or solenoid.
As the fuel level drops, a vacuum begins to form in the fuel tank because air can get in to fill the space the consumed fuel occupied. After about 10 or 15 minutes, the vacuum will become strong enough that fuel will stop flowing to the carburetor and the lawnmower will die.
Condensation inside the gas tank is one culprit, but moisture can also enter the system through a loose or ill fitting gas cap. The best solution is to drain the mower`s gas tank and refill it with fresh gasoline. A clogged fuel filter can also cause a mower engine to die.
If you find that your lawnmower keeps dying, or keeps stalling while cutting grass, then inspect the spark plugs. Look for signs of damage or wear. Something as simple as a cracked porcelain insulator can mean an electrode has been damaged or burned away.
A dirty carburetor is one of the most common causes for a lawn mower not being able to start after sitting unused for months or years at a time.
Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
The most common reason for a no start, not even a click sound, is a totally flat battery, but other likely causes include: Transmission in Drive. Brake Pedal not Pressed. Blade Switch / Lever On.
Electric lawnmowers may cut out for two main reasons: A faulty power switch or a loose cable connection. An overheating motor can cause the thermal cut out to trip.
Blocked cooling fins may be one of the more common causes of overheating in mowers specifically, since all the grass and debris from lawns or fields can easily end up in the cooling fins, keeping air from circulating and cooling the engine down.
If the engine dies when the blades engage, it could be the result of a damaged safety switch. The first step in assessing the safety switch is to make sure it is plugged in securely. The switch is located underneath the seat, and you may have to remove the seat to reach it.
Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
Low coolant, only on liquid-cooled mowers and not air-cooled. Clogged air cleaners, inlet screens or air paths can also prevent the cooling system from working properly on many mowers. Clogged cutting decks can overstrain the engine as it tries to power through with jammed blades, causing it to overheat.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I have a John Deere L118 Limited Edition (w/ 20 HP B&S engine), which I purchased about 8 years ago. It ran well with few problems up to late this summer. I believe the problem started when I accidentally filled the tank with some stale gasoline – the tractor turned over, but would not start. I drained the fuel tank and filled it with fresh gas, but it still would not start. When I use starter fluid, the tractor starts for 4-5 seconds, and then cuts off. I installed a new fuel filter. The connections in the fuel line seem tight, so while the problem might be the vacuum fuel pump itself, I do not think it is due to a leak in the line. I disconnected the fuel line at the carburetor — fuel flows through the line at start up. But when I put the fuel line directly into the air intake (with some starting fluid), the engine still cuts off in about 4 seconds. I am not sure if the pump simply is not drawing enough fuel into the carburetor. I understand that, if it is a problem with a safety cut-off, the engine would not start at all (even for 4 seconds). My thought was that the problem may be a gummed up carburetor, but that would not explain why the tractor does not start when I feed fuel directly into the carburetor. Any thoughts about other things I can try before bringing the tractor to a mechanic?
ANSWER : Just take the carb bowl off its easy one bolt on the bottom of it get the old gas out flush all old gas out of tank and line then it will run trust me i know

Read Full Q/A … : Garden

Parking brake wont release on a 310e back hoe, replaced the parking brake switch and that was no help
ANSWER : Sounds like the whole stop brake system is seized up. Lot of wd40 and elbow grease should do it.Good luck.

Read Full Q/A … : Garden

How do you fix a battery problem with my lawn mower because it wont start but it is charged
ANSWER : I think the motor brushes are warn out and need replacing.

Read Full Q/A … : Garden

My ZD28 just stopped in its tracks while mowing. I reset all levers and the parking brake and it would not start. Nothing. Pleanty of fuel and the battery is new (2 weeks old) What could be the problem.
ANSWER :

Read Full Q/A … : Garden

Have a craftsman 16″ chain saw 358.360260. Could not initially get it started after it had sat for a couple years with fuel stabilizer in it. When I went to use it the fuel had all evaporated and the fuel pick line was rotted. I replaced that with some difficulty but finally got it on. Saw still wouldn’t start. Replaced the fuel filter. Still wouldn’t start. Pulled the carb apart and cleaned and recleaned everything. Diaphragms were good and I didn’t adjust any of the mixture screws because as I said it ran fine before storage. Non of the carb passages were clogged. Fresh gas 40:1, good spark plug and good spark. Airfilter is good. Engine has maybe about 4 hours of total run time on it. It’s a ZAMA (?) carb. It will run for about 30 seconds when I manually prime it by pouring a small amount of fuel directly though the carb. When I was disassembling the carb the vent hose that goes back into the fuel tank seemed to have a small out of ?substance? in it which I cleaned out. It was right at the end the of the hose that goes back into the fuel tank and not up by the carb. It didn’t appear to be like your typical gummy deposits/varnish though. I hope it wasn?t some type of spongy check valve stuff that is supposed to be in there. That might explain some of my problems. Anyway, I also can not seem to get the primer bulb to fill. When I open the fuel tank, look in side and depress the primer bulb, air bubbles come out of the fuel filter. But when I let the bulb reexpand there’s no fuel that gets sucked up the hose. I can however seem to fill the primer bulb when the fuel tank is full and the chainsaw is laying on it?s pull cord side and the bulb is depressed a bunch of times. The saw will also start and run again for about 15 seconds then die. It’s definitely not getting/fuel and probably running out . Thanks.
ANSWER :

Read Full Q/A … : Garden

I have a husqvarna 323L string trimmer. I stored it after running the tank & carb dry for about two years. I fueled it, then started it, & it ran for a minute then died like I turned the switch off. Since it would not restart, I found the fuel filter had broken off the hardened fuel line & it sucked gummy crap out of the tank & into the carb. Failing at cleaning the carb, I finally put a new carb on it & replaced the pump, hoses & filter. It has ran good till this year. I winterized it with stabilizer & left it with a full tank over the winter. The gas in the tank was gone when I got ready to use it this year. I filled the tank with premix, checked for leaks, then started it. It would run fine for about half a tank, start idling poorly (lean) then cutoff & refuse to restart till I refilled the tank. I finally found the tank had cracks & was letting pressure out of the tank & apparently this was causing the carb to lose it’s ability to siphon gas out of the tank. So I replaced the tank which came with new hoses & a filter, which I properly installed to the carb. It cranked right up, but when it runs a half tank, the carb quits sucking gas out of the tank. When I pump to prime the carb, it moves the fuel into the carb, but the pump never gets hard like it does when I prime the carb when the motor is cold. I have to keep refilling the tank, prime, & then it starts & runs until the tank gets about half empty. The new fuel filter is down in the gas tank properly, but It will not run after it shuts off until I refill the tank & prime. I’m baffled. New tank, new hoses, new filter, new carb, & I can find no leaks in the fuel system. It runs strong. The 323L is a two-stroke & it always cranks on the second pull from cold on a full tank. Any ideas?
ANSWER :

Read Full Q/A … : Garden

My Husqvarna 323L trimmer will no longer start after I added fuel and cranked it several times with the switch set to off. When I realized then corrected the switch, it still would not start. Before now, it always started on the first or second pull. I have checked for compression, spark and fuel. All seems fine, it just won’t start. The fuel is fresh and is the same fuel I used with no problem in my blower. Any ideas? Thanks!
ANSWER : Let it sit 2 hrs. then try to start it as usual.

Read Full Q/A … : Garden

Starts and stops starts and stops blowing snow, is the belt lose or waren or streched ? model 3650 6.5
ANSWER : Take the black cover off of the side (left) and look at the belt. It is probably worn out.

Read Full Q/A … : Garden