Troy

Experienced gardeners share their insights in answering this question :
If it stalls while accelerating, then turn your low side adjustment out a 1/4 to 1/2 turn and try again.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
The clutch engages the clutch pads to spin the trimmer head. If the clutch assembly is defective, the clutch will not disengage the clutch pads, and the trimmer head will continue to spin, even at low speeds. If the clutch is defective, replace it. (Note: some string trimmers do not have a clutch.
The new Troy-Bilt® 4-cycle string trimmer was engineered from the ground up to be easy to start and maintain. And, you still don`t have to mix oil and gas with our 4-stroke engine technology.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

The most common cause of a mower that runs for thirty minutes and then dies is a faulty armature. A faulty gas cap is the second most likely cause.
The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the string trimmer for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance.
over time the arrestor can become clogged with soot which may cause the trimmer engine to stall. you can try cleaning the arrestor with a wire brush. but you may need to replace it with a new.
Troy-Bilt TB130 160-cc 21-in Push Gas Lawn Mower with Honda Engine in the Gas Push Lawn Mowers department at Lowes.com.
Four-stroke engines yield higher levels of torque at a lower RPM during operation. A four-stroke engine only consumes fuel once every four strokes, making it a more fuel-efficient engine option. Four-stroke engines give off less pollution because they do not require oil or lubricant mixed in the fuel.
A 2-cycle engine has one fill port with a cap that has fuel pump and oil can icon. The cap will usually state the oil to fuel mix ratio. A 4-cycle engine has two fill ports with each cap separately identifying the fuel tank from the oil sump.
The Troy-Bilt Super Bronco XP riding mower is an excellent choice for a variety of lawns.
If a mower is hard to start, it may be the result of a dirty carburetor and/or a clogged air filter. Use a screwdriver to remove the carburetor and clean any dirt out of it with a rag. Clean the air filter or replace it if it`s disposable.
A lawn mower will not run with a dead battery. The battery is necessary to provide the power needed to start the engine and keep it running. Without the battery, the engine will not be able to start and the mower will not be able to function.
The model number on a Troy-Bilt riding lawn mower can be found on the underside of the seat. The model number will begin with 13 or 14. The model number on a Troy-Bilt riding lawn mower can be found on the underside of the seat.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
Condensation inside the gas tank is one culprit, but moisture can also enter the system through a loose or ill fitting gas cap. The best solution is to drain the mower`s gas tank and refill it with fresh gasoline. A clogged fuel filter can also cause a mower engine to die.
Other things that could cause this issue are bad fuel, weak/colapsed/kinked fuel line, faulty spark plug, faulty ignition/coil, oil over full, clogged air filter, plugged/dirty carburetor, worn engine parts internal rings/valves/etc.
Use Carburetor Cleaner

Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.

Your lawn mower turning over but not starting due to several reasons, such as a faulty or disconnected plug, a disconnected spark plug wire, a clogged air filter, or a contaminated fuel tank. A faulty carburetor, a dirty cutting deck, or a dysfunctional flywheel brake can also cause this.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Troy Bilt Rear tine tiller model 643 Bronco, won’t start,it ran out of gas, put in new gas and it started but wouldn’t stay running. Put in new spark plugs, cleaned filters, changed out gas,still won’t start
ANSWER : Did it run out of gas when you added gas it could be that the fuel line has plugged up with something from the bottom of the tank take the fuel line off and try blowing threw it and take a air hose and blow out the carb and carb cleaner

Read Full Q/A … : Troy

Starts then dies – Troy Bilt 5.5hp Self Propelled Mower
ANSWER : Check oil level. all mowers have oil level cutoff. 30w oil. Remove air cleaner, try to start. Replace filter if dirty.

Read Full Q/A … : Troy

Pony wont start. i have replaced gas, cleaned carb, replaced plug. it will turn over but wont start. getting gas and fire.
ANSWER : Look to see if there is any trash under the seat.there is a safety device and if it is not making contact it will not start.try to put the mower in forward and engage the blades,while not running.push on the mower a few times then try to start it again,

Read Full Q/A … : Troy

What should gap be between ignition module and flywheel magnets on troybilt 575ss 4 cycle weed trimmer? It is a year 2006 model.
ANSWER : Pull the module back, tighten it up and align magnets on flywheel with module. Put a business car between them and loosen the module. It will move against card. Tighten the screws there. It’s set.

Read Full Q/A … : Troy

Troy Bilt string trimmer starts but dies when I try to give it gas to trim.
ANSWER : Try mixing up some fresh gas mixture if it is over 30 days old it is considered bad gas. Or the carburetor may need to be rebuilt.

Read Full Q/A … : Troy

2 days ago i mowed with my troy bilt pony and parked it . itried to start it yesterday and nothing? i checked the battery, its fully charged,mower is disengaged. iturn the key and nothing,not a sound.
ANSWER : Battery connections clean? neg. and pos.
clutch pushed in?
safety switches disengaged?
starter solenoid bad

Read Full Q/A … : Troy

I need the ignition coil gap. Got a new one and it almost started. I have a feeling that the business card may not have been the right one. Please help
ANSWER : The gap is set about .010-.014″ The closer you can get it, the better it normally is…just don’t set it so close that it is almost rubbing.

Read Full Q/A … : Troy

I need to tighten the drive belt between the engine and transmission on my Troy-Bilt 3312 GRS lawn tractor
ANSWER : I REPLACE THE DRIVE BELT AND THE MOWER STILL WON’T MOVE

Read Full Q/A … : Troy