42 In Deck 19 Hp Kohler Courage Twin Cam Zero Turn Mower

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Replace dirty or clogged fuel filter. Replace old gas with fresh gas (properly dispose of old gas). Check oil level and add if low. Adjust cutting height of mower before cutting tall grass.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

If your lawn mower starts, runs briefly, then dies these are the four most common reasons that`s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
If the engine is low on power, it will bog down when you try to accelerate. This could be caused by a number of different issues, including low compression, a bad timing belt, sucking too much air, or even a head gasket leak.
The factors that keep draining your lawn mower battery include damaged, loose, or corroded cables, an electronic drain, or cables that are attached loosely. Sometimes, it is as simple as the battery needing some maintenance. Other plausible reasons are faulty alternators, voltage regulators, and battery chargers.
A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
The spark plugs are worn or damaged

If you find that your lawnmower keeps dying, or keeps stalling while cutting grass, then inspect the spark plugs. Look for signs of damage or wear. Something as simple as a cracked porcelain insulator can mean an electrode has been damaged or burned away.

Condensation inside the gas tank is one culprit, but moisture can also enter the system through a loose or ill fitting gas cap. The best solution is to drain the mower`s gas tank and refill it with fresh gasoline. A clogged fuel filter can also cause a mower engine to die.
What Type Of Oil For a Lawn Mower? While automotive engine oil, such as 10W-30 or 10W-40, can be used in a lawn mower engine, it is generally recommended that SAE 30 motor oil be used.
You might have contaminated gas in the mower. Drain out the old gas. Change the fuel filter. Get new gas, non-ethanol if possible.
When a spark plug becomes fouled, the tips become coated with fuel, carbon, oil or dirt. This interference limits the ignition power needed for mowing on level or uphill surfaces. Maintain your spark plugs by changing them every season or regularly removing and cleaning the tips.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Toro cutting off
ANSWER : Maybe low oil level, all mowers have a low oil cutoff. 30w oil.

Battery goes dead over night – Toro 42'' Zero Turn Lawn Mower Trailer Package Deal ()
ANSWER : First thing to do is find out if it’s the battery or the mower. Disconnect the battery and leave it overnight. If it’s dead in the morning, you need a new battery. If not, you either have a charging problem (not likely if the battery isn’t dead after using the mower) or you have a current drain.

Diagnosing possible pto issue – Toro Zero Turn Rider 74366 Lawn Mower Tractor Rider Ztr
ANSWER : Check plug on the pto itself.located under the mower near the rear end. contacts probably have dried dirt and mud. if that don’t work, tap it with a hammer,it may be just stuck.Thats what I did and it been working ever since. Hope this helps someone.Let me know.

<!– from fixya rte –>How do I engage bagger on zero clearance – kawasaki 48'' Toro Com Zero Turn Lawn Mower 21hp Kawasaki ()
ANSWER : That should be covered in your manual. I’m not sure what a zero clearance mower is actually, are you assuming and making up a name for it?

Location of fuses
ANSWER : Most fuses are near the back of the switch if there good and its not starting check the safety switches

Engine runs, blades turn but mower will not move
ANSWER : Look in front of back tired on frame, not deck, there are. 2 rods, 1 on each side, rods look like a L, it’s going through a little eye opening, push it backards, mower should move. If rod is pulled through opening and locked in, mower will not move..its a safety. Feather on mower

Engine will stall when levers are moved from park position to center unlock position.
ANSWER : You didn’t mention if the same thing happens engauging the mower deck. If it does both, start with the carb and choke. also, check out the safety switch on the steering handles for a loose wire or a ground short. This should be fairly easy.

19 h.p. kawa mowing and motor stopped. Will not turn over at all. PTO was engage when shut down
ANSWER : See if it vapor locked pull plugs out and turn it over without them in if works put plugs back go on down the road and mow