Spur Sprocket For Stihl 017, 021 Chainsaws
Experienced gardeners share their insights in answering this question :
If it is getting smokey exhaust befor stopping it is getting too much fuel. If not smokey it is not getting enough fuel. If smokey first take out the air filter and clean it. If it runs fine your done. If not smokey open the high needle valve (marked with an H) on the the carb a little (no more than a 1/4 turn).
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The carburetor might be clogged. A clogged carburetor is often caused by leaving fuel in the chainsaw for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the chainsaw engine to stall.
Clogged Fuel Filter This means the flow of fuel to the engine is disrupted which can then cause the engine to stall. Remove the chainsaws fuel cap and pour some gasoline into a different container when inspecting the fuel filter. Filter the tank by using a thin metal rod and examine the quality of the filter.
If your chainsaw still starts and then stops working, check the air filter. Clean or replace the air filter if it is dirty or damaged. Another reason that your chainsaw starts and then stops working could be that the spark arrestor is dirty or clogged. If this is the case, clean it with a wire brush.
The two most common reasons a chainsaw won`t idle are a blocked air filter and an idle screw out of adjustment. Other possible causes include: Dirty Air Filter. Idle Screw out of Adjustment.
If the carburetor is clogged, it may only work with the choke engaged, which is not a good way to be running your engine. Cleaning the carburetor and replacing some of the internal parts with a new carb kit is a great way to get your carburetor running properly again.
To fix the problem, start by
draining the gas tank. Replace the old gas with a fresh mix of gas, being sure to add a stabilizer to keep the ethanol from gelling. Often, just getting fresh gas and stabilizer through the chainsaw`s fuel system may correct the saw and it should stay running.
The carburetor might be clogged and needs to be cleaned.
A chainsaw`s carburetor mixes air and fuel to start the internal combustion engine. If fuel has been left in the engine for too long, it can become sticky and clog the carburetor, preventing it from starting. If the clog is minor, clean out the carburetor.
The two most common reasons a chainsaw won`t idle are a blocked air filter and an idle screw out of adjustment. Other possible causes include: Dirty Air Filter. Idle Screw out of Adjustment.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
My stihl sh 55 blower starts then shuts off – RTO Spur Sprocket For Stihl 017, 021 Chainsaws
ANSWER : If it is getting smokey exhaust befor stopping it is getting too much fuel. If not smokey it is not getting enough fuel. If smokey first take out the air filter and clean it. If it runs fine your done. If not smokey open the high needle valve (marked with an H) on the the carb a little (no more than a 1/4 turn).
Makita chainsaw starts and revs then dies – Stihl Chain Saws, 017, 019, 021, 023 & 025
ANSWER : Check the fuel filter in the tank is clean it could be blocked
Tuning specs for a stihl ms 362 – RTO Spur Sprocket For Stihl 017, 021 Chainsaws
ANSWER : Idles at 2800 and wot 14000. I tune to about 13800 and that is with bar and chain on
Where should the s on the flywheel be set
ANSWER : S = spark
so needs set to where the pickup coil is
Ms170 stihl chainsaw wont start or if it does start it wont take the throttle
ANSWER : Try new gas, and adjust the carb.
Stihl ms660 ilde chain speed to fast – RTO Spur Sprocket For Stihl 017, 021 Chainsaws
ANSWER : Somewhere on the carb linkage you will see a set screw touching it. Turn the screw so it does not push the linkage so far.
Safety bar will not disengage ms 170 – RTO Spur Sprocket For Stihl 017, 021 Chainsaws
ANSWER : They can get plugged up with chips and sticks, take the cover of and blow it out with compressed air.
Sthil are a roal panin in the *** takes 50 time of pulling the rope to get it started
ANSWER : Which model is it? Have you followed the procedure in your manual? They flood very easily. Reply below please.
Lou
