25cc Gas Line Trimmer
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Turn on the ignition switch and pull the starting cord quickly. You should see a spark in the plug gap. Since the spark may be faint, it may help to do the test in a dark area. If there is no spark, check for a broken or shorted (bare) lead wire or bad switch.
Over time, the spark arrestor can become clogged with soot. If the spark arrestor is clogged, the engine may not start. To unclog the spark arrestor, remove it and clean it with a wire brush. You may also replace the spark arrestor.
A: The spark plug gap on all products is . 025-inch.
The more worn or dirty spark plugs are, the greater the pull on the rewind and more effort is required to produce an adequate spark. If you haven`t turned on your engine recently, your mower won`t start and/or you have to tug repeatedly on the rewind to start the engine, a damaged spark plug may be the culprit.
There may be old or bad fuel in the carburetor float bowl. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and make the engine hard to start. If the carburetor is clogged, try cleaning it with carburetor cleaner.
Remove the air filter and spray carburetor cleaner into the intake. Let it sit for several minutes to help loosen and dissolve varnish. Replace the filter and try starting the trimmer. If this doesn`t solve the problem, consider disassembling the carburetor to give it a more thorough cleaning.
The critical distance between the spark plug`s electrode and the ground strap (that piece of steel that curves out over the end of the plug) is called the “plug gap.” The act of setting this distance correctly is commonly referred to as “gapping” your plugs.
If your trimmer engine idles, but stalls on throttle, check the following parts: the gasket, primer bulb, fuel filter, air filter, fuel vent, fuel line, and carburetor. The repair and symptom guide will help you better identify the part needed to be replaced and how.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Need the spark plug gap – Poulan Pro 22" Self Propelled High Wheel Mower
<!– from fixya rte –>Spark plug gap setting poulan pro 033. – Poulan Pro Prod/Poulan Weedeater Poulan Pro PP5020AV 20" Gas Chain Saw
My poulan pro 42cc will not start i get sparks from spark plug,but when i put the plug back in i get nothing
If you have spark and compression it must not be getting fuel.
Put a little mix directly into the carburetor and try to start it. If it pops and doesn’t continue to run look at your fuel lines. I think you have a cracked hose. HTH
Hht 25 will not start
CHECK THE COMPRESSION 90LBS MIN.
Poulan pro bvm200vs, what is the spark plug gap suppossed to be set at?????????????
Re: “The plug should be set from the factory check your manual for the gap setting”Chris, If people had the manual do you honestly think they would waste their time looking for the answer online.Chris – I hope you don’t get paid for offering ‘Check your manual’ answers.
MY POULAN PRO 6.5 WONT START….nEED TO REPLACE SPARL PLUG BUT DO NOT KNOW ‘right one”..
Take the old plug out, any auto store should be able to match it up.
What is theair gap setting poulan 2150 2.1c i
.025″ or .6MM is the spark plug gap I assume air gap is what you were referring to is spark plug?
Spark plug gap for poulan weedeater – Poulan Pro Ppb330 33cc Gas Line Grass Lawn Trimmer
Go to the following site where you may well find parts needed