somewhere or something i should be looking at?
John Deere

Experienced gardeners share their insights in answering this question :
Try this:
When it begins to stall, loosen the gas cap. If the engine runs smoothly, clean the vent holes on the cap.
Gary

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Based on that usage, a lower-quality line of residential mowers is expected to last 450-500 hours, while a John Deere residential lawn mower will last around 1,000-1,500 hours.
If your John Deere won`t crank and all you hear are clicking sounds when you turn the key, you likely have a bad battery or a bad connection somewhere between the battery and the starter. Double check that the alternator and battery connections are clean and tight.
If your lawnmower starts up but then dies in the middle of mowing your lawn, you could have a bad spark plug. The spark plug works with the ignition coil to create a timed spark in the cylinder, causing combustion. The spark plug is really a very simple device.
The most common reason for a surging lawn mower engine is a blockage in the fuel supply, but there are other possibilities: Bad gas. Bad spark plug. Dirty/faulty carburetor.
Other things that could cause this issue are bad fuel, weak/colapsed/kinked fuel line, faulty spark plug, faulty ignition/coil, oil over full, clogged air filter, plugged/dirty carburetor, worn engine parts internal rings/valves/etc.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

How Many Hours Should A Riding Mower Last? Most riding mowers last between 500-700 hours, although some can run for as much as 1,000 hours if cared for and maintained properly.
However, other aspects of the machine, like the transmission, clutches, hydraulics, and more may need to be replaced to keep the tractor in good running order. A general rule of thumb is that 2,000 to 2,500 hours is well broken-in while anything above 35,000 hours is considered high.
The spark plugs are worn or damaged

If you find that your lawnmower keeps dying, or keeps stalling while cutting grass, then inspect the spark plugs. Look for signs of damage or wear. Something as simple as a cracked porcelain insulator can mean an electrode has been damaged or burned away.

Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

My 1979 111 john deere lawn tractor deck blades shut off
ANSWER : If it has a clutch, that would be the problem. An electric clutch will kick on and off when it is hot if it is bad.

Read Full Q/A … : John Deere

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : John Deere

John deere diesel 4039 over heating … thermostat appears to be working OK … new water pump has been installed but still over heating … new radiator has been installed but still over heating … other than overheating runs great and sounds great
ANSWER : If the engine is overheating temperature wise that’s one thing but if its blowing out the reservoir and your saying its overheating that’s another thing. Please let me know which one applies.

Read Full Q/A … : John Deere

HAVE A JOHN DEERE 318 LAWN TRACTOR, CHANGED POINTS AND CONDENSER, WON’T TURN OVER, TRIED STARTING FLUID IN CARB AND NOTHING. CAN IT BE THE COIL AND HOW DO I CHECK? THANKS
ANSWER : Check the coil impedance on the primary and secondary side. You’ll have to disconnect the battery negative cable so you don’t short something out. Unplug the spark plug wires and the two sets of smaller wires connected to the primary side of the coil. The primary coil reading should be between 3.7 ohms and 4.6 ohms while the secondary (spark plug side) should be between 34.2 k-ohms and 41.6 k-ohms. If the resistance values you measure are outside of these ranges, you need to replace the coil.

Read Full Q/A … : John Deere

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : John Deere

Where is the voltage regulator/rectifier located on a D130 mower?
ANSWER : Its under flywheel

Read Full Q/A … : John Deere

<!– from fixya rte –>John deere troubleshooting – John Deere Pto Clutch For Stx38 And Stx46 Lawn Mowers
ANSWER : I have model 917-276900 tractor starts fine but when I engage the mower deck it blows the fuse and dies.

Read Full Q/A … : John Deere

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : John Deere