Lawn mower run for 30min then begin to skip and cut off. I try to start it
back up but won`t start. But if I let it sit for a few mins. it start back up
then back to the same thing all over.
Did you check the oil? Some engines have a low oil shut off switch to prevent the engine from running out of oil and burning themselves up. If it is low in oil and all the oil is up in the engine to lubricate, then the switch may be setting itself off. After a few minutes, the oil comes back down to satisfy the switch and it starts back up, but only till the switch is activated again. Might do it???
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die
By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
If your lawn mower starts, runs for a while, then dies, check the ignition coil, gas cap, and spark plug. One or more of these parts could be causing your problem. Follow our repair and symptom guide to help you fix this.
Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
A dirty carburetor is one of the most common causes for a lawn mower not being able to start after sitting unused for months or years at a time.
Use Carburetor Cleaner Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.
This is most likely a safety switch issue. Usually the seat safety switch will cause this problem. The mower dies because it thinks nobody is sitting in the seat, and shuts off for safety reasons.
The most likely cause of a no-start mower after running out of gas is dirt in the carburetor, but other possible causes include: Air locked gas system. Faulty carburetor. Contaminated gas.
The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the engine for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
In such cases, your first step after the mower cools down should be to check the air filter. If it`s clogged, the combustion chamber may not be getting enough oxygen, resulting in a too-rich fuel mixture that will cause the engine to run poorly and even spew smoke.
The most likely cause of a no-start mower after running out of gas is dirt in the carburetor, but other possible causes include: Air locked gas system. Faulty carburetor. Contaminated gas.
If it is difficult to start the ride-on mower, the most common reasons include: Old fuel; make sure to use fresh fuel, especially after winter storage. Spark plugs might be dirty or damaged. How to examine and replace a spark plug on your ride-on mower.
Loss of power while working
If you feel loss of power while you are working with your Ride-On mower, this could be due to: Damaged belt tensioner which is tensioning the cutting deck belt. The belt connecting the cutting deck being damaged.