Garden

Experienced gardeners share their insights in answering this question :
Could be the motor is burnt out . quite likely repair would cost more than just replacing it

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Being unable to get your electric lawnmower started is often not a problem with the lawnmower, but is usually caused by a fault with the extension lead being used. To test this try turning the lawnmower on without using the extension lead. If this doesn`t work try using an alternative plug socket and checking the fuse.
We recommend repairs to only be carried out as directed by the instruction manual, however, if you feel that there are still problems, you can visit a repair agent and get you back to mowing in no time. You can also visit the Flymo spare parts shop to help get your mower`s mojo back.
Your Mower Won`t Start:

Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.

To start it again, simply press the GO & confirm buttons to continue mowing to the set schedule.
Thus, checking the belt path can help determine if the belt is jammed, twisted, or stuck under the pulley. These problems can cause electric lawn mower blades not spinning. Besides, worn or damaged belts can be the cause. When checking belts, look for any visible signs of damage, such as cracks or fraying.
The purpose of the Capacitor is to reduce mains interference from the motor being radiated through the supply and when the Capacitor fails it will blow the mains fuse or show signs of burning. As an essential part of its electrical system, a working capacitor keeps your device working consistently.
If the riding mower makes a heavy clicking or a rapid clattering sound when the key is turned to the start position, there is a problem with the battery or a part of the starting circuit. The clicking noise comes from a part called the starter solenoid.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

How to repair clutch HS45 Stihl – RTO Weed Eater Hedge Trimmer 20cc, Reconditioned
ANSWER : I’m not familiar with your machine, BUT… most of those centrifugal clutches ARE NOT repairable, and must be replaced when failed.

Read Full Q/A … : Garden

Trimmer head won’t turn
ANSWER : If you didn’t recently take it apart, then it sounds like you have broken the drive shaft in the neck of the trimmer. You can probably find this at an outdoor power and equipment type of store.Jim

Read Full Q/A … : Garden

Engine running but blades dont move – Ryobi 18V Hedge Trimmer
ANSWER : If its electric/battery operated suspect stripped gears and throw it away as you tried to cut something to big with it. If its gas then suspect the same thing but it’s repairable

Read Full Q/A … : Garden

When my flymo lite 250 engine is running the end does not turn to cut the grass
ANSWER : Could be anything from a stripped drive shaft to a loose or stripped trimmer head. You’ll probably need to take it to a repair shop to have them diagnose the problem and locate the replacement parts if it’s anything other than a stripped trimmer head bolt.

Read Full Q/A … : Garden

Hi i wonder if you can help my Ryobi hedge trimmer has a problem with the pull cord it works goes in and out but it does not turn the engine over is there maybe a key way or something that maybe broken ??
many thanks
Nick
ANSWER : Hello Nick,

Inside the cord attaches to a plastic wheel which cranks the engine. This cord can become loose or can break after some use. Try opening the plastic casing where the cord is to see if this is the problem.

Thanks

Read Full Q/A … : Garden

I have a 22inch Craftsman Hedge Trimmer, Model No. 315.81591. When trimming a hedge near a chain-link fence, one of the steel links from the fence got caught between the blade guard and the cutter blade. Now the cutter blade won’t move, but the trimmer buzzes. Is the trimmer repairable? If it is repairable, how do I repair it?
ANSWER : The likely issue is the gear pin has been sheared. The part is no longer available from Craftsman. (P/N from sears: 616255-001)I had a similar issue with a similar electric trimmer. I removed the old pin and used a split pin and ground it down to the proper size. It’s now worked for about 2 years just fine. This requires complete dis-assembly.

Read Full Q/A … : Garden

I have a sx-135 bandit. it was working fine then it stopped? i try to pull on rope to start but it froze. i used two cycle generic oil mixed with regular-un. gas does it need oil? or is the engine broken. just remember that i pull and pull and the little teeth inside the casing lock up.
ANSWER :

Read Full Q/A … : Garden

When in operation the Ryobi S430 string trimmer leaks oil continuously. How can I fix this problem?
ANSWER : Ryobi told me the unit can’t have the s430 trimmer bottom end raised higher than the engine at any time, or it will leak. Apparently they released a product to compete with other companies for cheap 4 cycle trimmers without much care for the end user.

Read Full Q/A … : Garden