Craftsman
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The reasons why mower is not moving forward or reverse is that the battery is dead, or due to clogged fuel line. Additionally, malfunctioning transmission, or a broken drive belt, also a faulty spark plug, even when friction wheel isn`t in contact with the friction plate, or damaged Tires.
If your lawn mower turns on but won`t move, there could be a number of potential causes. The most common issues include a broken or damaged belt, a clogged discharge chute, a broken or damaged drive cable, or a damaged or clogged transmission.
There are several reasons a Craftsman lawnmower may turn over but not start, with the most common ones including the following: Lack of fuel. Dirty air filters. Electrical issues in the ignition system or the starter motor.
Riding mower not going forward or reverse could be caused by a number of issues. The most common cause is a stuck or broken clutch, which prevents the mower from moving. Other causes could include a broken or disconnected drive belt, damaged transmission, or a problem with the mower`s starter or ignition system.
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
Grinding gears, starting and stopping during operation, and the wheels not rotating with the pulley are common signs that your mower`s transmission is breaking down.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I have trouble starting a toro walk behind mower
ANSWER : All, I thought my carb was shot, so I replaced it. Still, start but no run (and had to use starting fluid). THEN!!! I noticed the spring to the “rev limiter” (just below and towards rear of carb) was not “tight”. The stupid bracket that holds the end of that spring had been bent down ~1/16″ and that caused all this heartache. CHECK YOUR REV LIMITER!!!
Read Full Q/A … : Craftsman
<!– from fixya rte –>Rj19lm plug gap for a 195cc 4cyl lawnboy – Lawn-Boy lawnboy" Mower Blade 21"
ANSWER : As a starting point in my shop i always use 0.30 in. For all my mowers
Read Full Q/A … : Craftsman
My 42 in Craftsman Tractor will not start. It normally runs great. I went to start it the other day and it ran for about 5 seconds before shutting down. It felt like it was getting no fuel. Any Suggestions?
ANSWER : Try and run it with the gas cap loose the vent could be plugged also see if it cuts out while keeping you foot on the brake and its just a bad safety switch shutting it off
Read Full Q/A … : Craftsman
Mower runs for about 5 min, than dies won’t restart . When cool start up ( craftsman 42 in deck 19.5 hp lawn tractor )
ANSWER : Check for spark when it dies you could have a bad coil
Read Full Q/A … : Craftsman
Lawn mower cranck but wont start…
ANSWER : Since you already checked for spark and air I would drain all the fuel out of it and check that fuel for water. Over time some lawn mowers end up with contaminated fuel. You can see the water sitting on the bottom of the fuel if you let it stand for a bit in a small plastic bowl.
Be sure to empty and dry out you fuel can as well. Especially if the mower stopped running right after a refuel. Which is a good sign your gas can is contaminated too.
Read Full Q/A … : Craftsman
Lawn mower will start and run for 5 seconds and shut down
ANSWER : Will it stay running with your choke on? if so then clean your carb. if not then look for a blockage from tank to carb. ie fuel shut off, deteriorated fuel line. plugged filter etc
Read Full Q/A … : Craftsman
I have a Crafstman Riding mower model #917.273643. That ran fine one second, I shut it off for five minutes. When I went to start it back up it wouldn’t start. Cranks fine, checked the wires, fuse, and spark plug. The plug was dirty so I cleaned it. But I am not getting any spark. I bought a new plug still no spark. I also checked the plug on another motor and I had spark so the plug wasn’t bad. Any suggestions on how to troubleshoot this or what may be wrong?
ANSWER : Sounds like your coil went bad
Read Full Q/A … : Craftsman
Why wont my mower start and gas comes out of muffler
ANSWER : Carb is flooding out ether bad plug or your carberator needs rebuilt
Read Full Q/A … : Craftsman
