ting down. It felt like it was getting no fuel. Any Suggestions?
20 Hp 42″ Deck Lawn Tractor

Experienced gardeners share their insights in answering this question :
Try and run it with the gas cap loose the vent could be plugged also see if it cuts out while keeping you foot on the brake and its just a bad safety switch shutting it off

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Your lawn mower turning over but not starting due to several reasons, such as a faulty or disconnected plug, a disconnected spark plug wire, a clogged air filter, or a contaminated fuel tank. A faulty carburetor, a dirty cutting deck, or a dysfunctional flywheel brake can also cause this.
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that`s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won`t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.
If your lawn mower starts, runs for a while, then dies, check the ignition coil, gas cap, and spark plug. One or more of these parts could be causing your problem. Follow our repair and symptom guide to help you fix this.
Use Carburetor Cleaner

Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.

Disconnected, dirty or fouled spark plugs are common causes for engines that won`t start. For small engines, spark plugs typically need to be replaced every season or after 25 hours of use. You should also check to make sure the spark plug gap is set correctly.
Check/clean/tighten all connections on battery/solenoid/starter/Ignition switch and neg(-) cable to frame or motor. Check to ensure all safety features are working properly and not engaged. Check for an inline fuse, bypass solenoid to see if engine cranks if it does replace solenoid, if no crank replace starter.
If your lawn mower starts, runs for a while, then dies, check the ignition coil, gas cap, and spark plug. One or more of these parts could be causing your problem. Follow our repair and symptom guide to help you fix this.
Replace the Spark Plug. If your lawn mower starts then dies right away, another possible culprit for the issue is the spark plug. A spark plug problem will result in the mower being more difficult to get going, and in some cases, the faulty spark plug may prevent it from starting at all.
The spark plugs are worn or damaged

If you find that your lawnmower keeps dying, or keeps stalling while cutting grass, then inspect the spark plugs. Look for signs of damage or wear. Something as simple as a cracked porcelain insulator can mean an electrode has been damaged or burned away.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

My 42 in Craftsman Tractor will not start. It normally runs great. I went to start it the other day and it ran for about 5 seconds before shutting down. It felt like it was getting no fuel. Any Suggestions?
ANSWER : Try and run it with the gas cap loose the vent could be plugged also see if it cuts out while keeping you foot on the brake and its just a bad safety switch shutting it off

Read Full Q/A … : 20 Hp 42″ Deck Lawn Tractor

Have a craftsman 16″ chain saw 358.360260. Could not initially get it started after it had sat for a couple years with fuel stabilizer in it. When I went to use it the fuel had all evaporated and the fuel pick line was rotted. I replaced that with some difficulty but finally got it on. Saw still wouldn’t start. Replaced the fuel filter. Still wouldn’t start. Pulled the carb apart and cleaned and recleaned everything. Diaphragms were good and I didn’t adjust any of the mixture screws because as I said it ran fine before storage. Non of the carb passages were clogged. Fresh gas 40:1, good spark plug and good spark. Airfilter is good. Engine has maybe about 4 hours of total run time on it. It’s a ZAMA (?) carb. It will run for about 30 seconds when I manually prime it by pouring a small amount of fuel directly though the carb. When I was disassembling the carb the vent hose that goes back into the fuel tank seemed to have a small out of ?substance? in it which I cleaned out. It was right at the end the of the hose that goes back into the fuel tank and not up by the carb. It didn’t appear to be like your typical gummy deposits/varnish though. I hope it wasn?t some type of spongy check valve stuff that is supposed to be in there. That might explain some of my problems. Anyway, I also can not seem to get the primer bulb to fill. When I open the fuel tank, look in side and depress the primer bulb, air bubbles come out of the fuel filter. But when I let the bulb reexpand there’s no fuel that gets sucked up the hose. I can however seem to fill the primer bulb when the fuel tank is full and the chainsaw is laying on it?s pull cord side and the bulb is depressed a bunch of times. The saw will also start and run again for about 15 seconds then die. It’s definitely not getting/fuel and probably running out . Thanks.
ANSWER :

Read Full Q/A … : 20 Hp 42″ Deck Lawn Tractor

Mower runs for about 5 min, than dies won’t restart . When cool start up ( craftsman 42 in deck 19.5 hp lawn tractor )
ANSWER : Check for spark when it dies you could have a bad coil

Read Full Q/A … : 20 Hp 42″ Deck Lawn Tractor

How do i install a mulching plug on my craftsman lawn tractor?
ANSWER : It covers the hole on the deck

Read Full Q/A … : 20 Hp 42″ Deck Lawn Tractor

Craftsman riding mower lt-1000 leaks gas – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : Need to fix that. it may be a fire hazard.

Read Full Q/A … : 20 Hp 42″ Deck Lawn Tractor

I have a craftsman LT1000 and it will run for about 20 min and die like it isn’t getting gas,but it start right back up and die in 1 or 2 min.i changed coil,air filter fuel filter and seat switch,and solenoid.
ANSWER : Try cleaning your gas cap vent. It sounds like it may be partially plugged. If it is plugged, the engine will eventually stall.
Regards!, –W/D–

Read Full Q/A … : 20 Hp 42″ Deck Lawn Tractor

How can I get the belts on? – Craftsman 42 in. Deck 19.5hp Lawn Tractor
ANSWER : Lots of sweat and foul words sometimes even a lot of blood . Water Filters Lawn Garden Appliance Parts

Read Full Q/A … : 20 Hp 42″ Deck Lawn Tractor

13.5 hp craftsman runs rough hard to start – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : Clean the carb jets

Read Full Q/A … : 20 Hp 42″ Deck Lawn Tractor