How to install a new cable mine broke cant figure out how to install a new one
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
1 Unfasten the old cable Fully down shift the rear gears. Undo the rear derailleur cable anchor bolt. Unthread the inner cable from the grooves and guides that are on the rear and underside of the rear derailleur. 2 Pull out the cable Pull the inner cable out through the derailleur`s barrel adjuster.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
No tnesion presnet when I squeeze the handle.
REPLACE THE CABLE
Need to replace drive belt.Never replaced. 42′ Craftsman riding lawn mower. How difficult is this. How do you access rear drive pully
Take a look at how the belt is installed. Then you will have to remove the mower deck and belt from the pulley on the engine. There is probably something by the engine pulley that you will have to remove so the belt will come off. It might be a shoulder bold or a rod with a bolt holding it on. Same with the rear pulley. Then you just have to put the belt on one pulley and watch your fingers so you don’t pinch them and turn the other pulley and the belt should go on. reinstall any bolts you removed and install the deck.
Need a diagram for craftsman 44″ riding mower drive belt. Mine threw belt and cannot locate original manual.
If you can find the model number of your mower, you should be able to find your manual here. I hope this helps.http://www.searspartsdirect.com/partsdirect/index.action
Need to replace fuel lines….does the prime bulb connected to return fuel line or the supply fuel line
Normally the big line will be the line the fuel filter is connected to inside of the tank, and is connected to the primer bulb.
The smaller of the two lines is the return line to the fuel tank from the carburetor after it is pumped thru the carburetor by the primer bulb.
Please take time to rate me
I have a craftsman 16 hp 42″ deck the clutch cable to engage the blades was missing were do I connect the cable to on the mowing deck?
On the top of idler pulley
Drive belt on Craftsman has come off and now is stuck behind pulley.
Get your self a good box cutter and start cutting and trying to pull it out at the same time other wise pull the pulley off and go from there. The belt will have to be replaced regardless
Need to add oil in my hydrostatic tranny – Craftsman 42 in. Deck 19.5hp Lawn Tractor
There a plug on top of transaxle.
Craftsman riding mower lt-1000 leaks gas – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
Need to fix that. it may be a fire hazard.